1010
103
CHANGING A BULB
2 - Main beam headlamps: H1-55 W.
Turn the protective cover of the
faulty bulb a quarter of a turn and
remove it.
Disconnect the connector.
Press the end of the securing clip
to free it. Change the bulb.
W h e n fi t t i n g t h e n e w b u l b , e n s u r e
that the direction notches are po-
sitioned correctly and the securing
c l i p i s fi x e d p r o p e r l y .
Reconnect the connector.
R e fi t t h e p r o t e c t i v e c o v e r . 3 - S i d e l i g h t s : W 5 W .
Pull the socket rearwards.
Remove the bulb and change it.
Front foglamps: H1-55 W.
Handle the bulbs with a dry
cloth.
T h e h e a d l a m p s a r e fi t t e d w i t h
polycarbonate glass with a
protective coating. Do not clean them
with a dry or abrasive cloth, nor with a
detergent or solvent product.
Use a soft, damp cloth with soapy water.
In the engine compartment, remove
the style cover secured by one or two
b u t t e r fl y s c r e w s , a p l a s t i c r e t a i n e r c l i p
and two quarter turn screws.
On the left-hand side, remove the par-
tition by lifting it to gain access to the
lights.
W h e n y o u h a v e fi n i s h e d , d o n o t f o r g e t
to put everything back correctly.
W A R N I N G : R I S K O F E L E C -
TROCUTION
Xenon bulbs must be replaced
by a PEUGEOT dealer.
Front lights 1 - D i p p e d b e a m h e a d l a m p s : X e n o n b u l b . 4 - D i r e c t i o n i n d i c a t o r s :
PY 21 W (amber).
Turn the bulb holder a quarter turn
and remove it.
Remove the bulb and change it.
R e fi t t h e s t y l e c o v e r .
H i g h p r e s s u r e w a s h i n g
When using this type of washing on
stubborn dirt, do not persist on the
headlamps, the lights and their sur-
rounds to avoid damaging their var-
nish and their seal.
In certain climatic conditions
(low temperature, humidity),
condensation on the inside
surface of the glass of the
headlamps and rear lights is normal;
it disappears a few minutes after the
lights are switched on.
1010
105
Remove the three plastic retainer
clips securing the cover trim (those
nearest to the lamp).
Move aside the trim.
Disconnect the lamp harness.
Extract the lamp from its housing.
R e m o v e t h e fl a t s e a l .
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
P u t t h e fl a t s e a l b a c k i n p l a c e .
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
N u m b e r p l a t e l i g h t s : W 5 W.
Remove the transparent cover using
a screwdriver blade.
Change the faulty bulb.
Boot lid lights
1. Reversing lights: Hp16.
2. S i d e l i g h t s : H p 1 6 .
3. Fog lamps: Hp16.
I f y o u e n c o u n t e r a n y d i f fi c u l t i e s ,
contact a PEUGEOT dealer.
