2009 Peugeot 607 Dag tyre pressure

Automatic switching on ofthe lights
This equipment switches on the side
lights and dipped headlamps automati-
cally when a low level of light is detected
or when the wipers are switched on.
 69
Motorised boot
This equipment makes loading and
unloading of the boot easier by means
of its motorised opening and closing.
 63
Tyre under-inflation detection
This equipment monitors the pressure
in each tyre and warns you of punctures
or defl ation.
 79
Visual and audible rear and front parking assistance
When parking, this equipment warns
you of obstacles detected in front of and
behind the vehicle.
 92

Front passenger air bag

1. Insertion of the key.

2. Selection of the "OFF" position.

3. Removal of the key keeping the
switch in this position. With the vehicle stationary, when the igni-
tion is switched on, the warning light comes
on if the driver and/or the front passenger
has not fastened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
fl ashes accompanied by an audible signal
which increases in volume. Once these
two minutes have elapsed, the warning
light remains on until the driver or front
passenger fastens his seat belt.
When the vehicle is moving, the warning
light comes on if the driver or one of the
front or rear passengers unfastens his
seat belt.
Seat belt not fastened/unfastened detection
 82  80
Tyre under-inflation detection
Sensors check the pressure of the tyres
while driving and trigger a warning if
a malfunction occurs (speed above
15 mph (25 km/h)).
If one of the warning lights below ap-
pears, refer to the corresponding
paragraph.
 79

Pressure OK

Under-infl ated wheel

Punctured wheel

1
21
Seat belt not fastened/
unfastened warning light
With the vehicle stationary,
when the ignition is switched
on, the warning light comes
on if the driver and/or the
front passenger has not fas-
tened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
fl ashes accompanied by an increas-
ingly loud audible signal. Once these
two minutes have elapsed, the warn-
ing light remains on until the driver or
front passenger fastens his seat belt.
When the vehicle is moving, the warn-
ing light comes on if the driver or one
of the front or rear passengers unfas-
tens his seat belt.
Diesel engine pre-heating
warning light
If the temperature is suffi -
cient, the warning light does
not come on and you can
start without waiting.
If the warning light comes on, wait
until it goes out before operating the
starter.
If no malfunction has been
detected: the CHECK OK
indicator light comes on af-
ter two seconds (following a
black screen), in the absence
of indicator lights showing the status
of vehicle functions. If these indicator
lights are present, the CHECK OK in-
dicator light will come on after these.

You may start your vehicle.

If a "minor" malfunction has been
detected: the warning light for the
faulty function comes on. Certain in-
dicator lights showing the status of
vehicle functions may also come on,
followed by the CHECK OK indicator
light.

You can start your vehicle; however,
contact a PEUGEOT dealer as soon
as possible.

If a "major" malfunction has been
detected: the corresponding warning
light comes on. Certain indicator lights
showing the status of vehicle functions
may also come on. The CHECK OK
indicator light does not come on.

Do not start your vehicle. Consult a
PEUGEOT dealer.

Following this, the following information appears on the instrument panel display:
The engine oil level appears for ap-
proximately 7 seconds; at the same
time, the service indicator appears on
the display located in the speedometer
dial for approximately 7 seconds.
Then, the status of the tyre pressures is
indicated for approximately 5 seconds.
With the ignition on, the vehicle carries out an automatic test which appears on the instrument panel display:

7
77
HORN
HAZARD WARNING LAMPS
Automatic lighting of hazard warning lights *
When braking in an emergency, de-
pending on the deceleration, the hazard
warning lights come on automatically.
They switch off automatically the fi rst
time you accelerate.
It is also possible to switch them off by
pressing the button.
* According to country.
Press one of the spokes of the steering
wheel.
Press the button, the direction indica-
tors fl ash.
They can operate with the ignition off.
ANTI-LOCK BRAKING SYSTEM
(ABS) AND ELECTRONIC
BRAKE FORCE DISTRIBUTION
(EBFD)
The ABS, in conjunction with the elec-
tronic brake force distribution, increas-
es the stability and manoeuvrability of
your vehicle on braking, in particular
on poor or slippery road surfaces.

Note: when changing wheels (tyres
and rims), make sure that these are
approved.
The anti-lock braking system comes
into operation automatically when
there is a risk of wheel lock.
When this warning light
comes on, accompanied by
a buzzer and a message, it
indicates that there is a mal-
function of the ABS, which
can cause a loss of control of the vehi-
cle when braking. When this warning light
comes on, connected to
the
STOP and ABS warn-
ing lights, accompanied by
a buzzer and a message, it
indicates that there is a malfunction of
the electronic brake force distribution,
which can cause a loss of control of
the vehicle when braking.
Stop immediately.
In both cases, consult a PEUGEOT
dealer.
Normal operation of the ABS may
make itself felt by slight vibrations of
the brake pedal.
ASSISTANCE SYSTEM
In an emergency, this system enables
the optimum braking pressure to be
reached more quickly, thus reducing
the stopping distance.
It is triggered by the speed at which
the brake pedal is activated.
The effect of this is a reduction in the
resistance of the pedal and an in-
crease in braking effi ciency.
When braking in an emergency, press
fi rmly without releasing the pressure.
In emergency braking, press
very fi rmly without releas-
ing the pressure.

7
79
TYRE UNDER-INFLATION
DETECTION
Sensors check the tyre pressure dur-
ing driving and trigger a warning in the
event of malfunction (speed greater
than 15 mph [25 km/h]). Sensor(s) not detected
This warning light, accompa-
nied by an audible signal and a
message on the multifunction
display, indicates that under-in-
fl ation detection is absent from
one (or several) tyre(s).
Contact a PEUGEOT dealer to replace
the faulty sensor(s).
Pressure check
With the ignition on and after
the engine oil level, this warn-
ing light comes on to indicate
that the system is measuring
the pressure of the tyres.
Pressure OK This warning light comes on
if all of the tyre pressure val-
ues measured are correct.
If one of the warning lights
described below appears,
refer to the corresponding paragraph.
If none of the lights appear, contact a
PEUGEOT dealer to have the system
checked. Under-infl ated tyre
This warning light comes on,
accompanied by an audible
signal and a message on the
multifunction display, locat-
ing the defl ated tyre.
Have the tyre pressure checked as
soon as possible.
Puncture
This warning light, accom-
panied by an audible signal
and a message on the multi-
function display locating the
punctured tyre, is followed
by illumination of the STOP-
warning light.
Stop immediately, avoiding any sud-
den movement of the steering wheel
and the brakes.
Change the damaged (punctured or
very defl ated) tyre, and have the tyre
pressure checked as soon as possible. All repairs and changing of
tyres on a wheel fi tted with this
system must be carried out by
a PEUGEOT dealer.

The tyre under-infl ation detection
system is an aid to driving which
does not replace the need for the
driver to be vigilant or to drive re-
sponsibly.
This system does not remove the ne-
cessity for having the tyre pressure
(including that of the spare wheel)
checked regularly, to ensure optimum
dynamic performance of the vehicle
and to prevent premature wear of the
tyres, particularly in the case of ardu-
ous driving conditions (heavy load,
high speed).
The system may temporarily be disturbed
by radio broadcasts on a frequency close
to it.

Note: if the damaged tyre is
temporarily stored in the boot,
it will again emit this message
to remind you of the necessity
of having it repaired. This will prevent
another warning of the same type be-
ing displayed.
Note: this message is also
displayed when one of the
tyres is away from the vehi-
cle (being repaired) or when a
wheel without a sensor is fi tted.

1010
101
Fitting a wheel
 Put the tool holder back in position.
This helps to keep the boot fl oor in its
correct position, to prevent any defor-
mation of the fl oor when loaded.

 Tighten the spare wheel securing
strap to prevent noise and for your
safety in the event of impact. After changing the wheel:
- have the tightening of the bolts and
the tyre pressure checked by a
PEUGEOT dealer as soon as pos-
sible,
- have the punctured wheel repaired and refi t it to the vehicle as soon as
possible,
- the steel spare wheel must only be used for a very short time.

 Position the wheel using the cen-
tralising tool 2 to assist you.

 Tighten the bolts by hand and re-
move the centralising tool.

 Partly tighten the bolts using the
wheelbrace 1 .

 Fold the jack 4 and remove it.

 Fully tighten the bolts using the
wheelbrace.

 Replace the wheel trim.

 For the alloy trims, position the re-
moval hole opposite the valve. Tyres fi tted with the Tyre
Under-Infl ation Detection System.
These wheels have a pressure sensor.
Have them repaired by a PEUGEOT
dealer.

1010
113
TOWING A TRAILER,
CARAVAN, BOAT, ETC...
We recommend the use of original
PEUGEOT towbars and their harnesses
which have been tested and approved
from the design stage of your vehicle and
that you entrust the fi tting of the towbar to
a PEUGEOT dealer.
If the towbar is not fi tted by a PEUGEOT
dealer, it is imperative that it is fi tted us-
ing the electrical pre-equipment installed
at the rear of the vehicle, in accordance
with the manufacturer's instructions.
Note: in certain cases of par-
ticularly arduous use (towing
the maximum load in high
temperatures on a steep
slope), the engine automatically lim-
its its power and selects the appropri-
ate automatic gearbox gear in manual
mode. In this case, cutting off the air
conditioning allows the engine power
to be recovered, and therefore the
towing capacity to be increased. Automatic adjustment
To avoid causing a nuisance to other
road users, this system automatical-
ly corrects the height of the beam of
xenon bulbs in relation to the vehicle
load after approximately 2 minutes.
The driver is then assured of having
optimum lighting.
Driving advice

Distribution of loads: distribute the
load in the trailer so that the heavi-
est loads are as close as possible to
the axle and the nose weight is close
to the maximum authorised without,
however, exceeding it.
Lighting

Tyres: check the tyre pressures of the
towing vehicle (label on the central
door pillar on the driver's side) and of
the trailer towed, observing the recom-
mended pressure.
If the coolant temperature
warning light comes on, stop
the vehicle and switch off the
engine as soon as possible.
In the case of vehicles fi tted with an
HDI engine, it is advisable, following
intensive use (towing on a motorway,
prolonged driving, ...), to leave the en-
gine running at idle for approximately
20 seconds before switching off the
ignition. This limits any increase in the
temperature of the engine after it has
been switched off.
In all cases, pay attention to the coolant
temperature.

Brakes: towing increases the braking
distance. Drive at a moderate speed,
change down early and brake gradually.

Side wind: sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed.

Cooling: towing a trailer on a slope in-
creases the coolant temperature.
As the fan is electrically controlled, its
cooling capacity is not dependent on
the engine speed.

11
119

A. Manufacturer's plate.

B. Serial number on the bodywork.

C. Serial number on the fascia.
D. Tyres.
Label D on the central door pillar on
the driver's side indicates:
- the dimensions of the rims and tyres,
- the makes of tyre recommended by the manufacturer, - the tyre pressures
(checking of
the tyre pressure must be car-
ried out when the tyres are cold,
at least once a month) ,
- the paint colour reference.
THE IDENTIFICATION FEATURES OF YOUR 607