2009 Peugeot 607 Dag stop start

8
85
When the vehicle is
being driven, the res-
pective illumination of
these warning lights
on the instrument pa-
nel, accompanied by an audible signal
and a message on the multifunction dis-
play, indicates that the handbrake is still
on or has not been properly released.
When parking on a slope, direct
your wheels towards the pave-
ment and pull the handbrake.
HANDBRAKE
Releasing
Pull on the handle and press the button
to release the handbrake.
6-SPEED MANUAL GEARBOX
Starting the vehicle
Before starting your vehicle:
- ensure that the gear lever is in neutral,
or
- if a gear is engaged, press the clutch pedal.
Applying
Pull the handbrake to immobilise your
vehicle.
Reverse
To change to reverse gear, lift the ring
under the gear lever knob and push
the gear lever to the left then to the
front.

Reverse gear can only be engaged
when the vehicle is stationary with
the engine idling.
When the ignition is on with
the engine off, always select
neutral.
IGNITION SWITCH

1. Stop position.

2. Running position.

3. Starting position.
The PC Com can be switched
on with the ignition off for a
combined duration of approxi-
mately thirty minutes.
A heavy object (key ring...), attached
to the key and weighing down on its
shaft in the switch, may cause a mal-
function.

1010
110
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position

 Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
ENERGY ECONOMY MODE
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, sunroof, electric seats,
audio equipment, telephone, dipped
headlamps, video, etc.) can only be
used for a limited combined duration,
to prevent discharging of the battery.
Once this period has elapsed, a
switching to economy mode message
appears on the multifunction display
and the active functions are put on
standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to exit the economy mode and
resume the use of these functions im-
mediately, the engine must be started
and left to run for a few minutes.
If the engine has been running for at
least 10 minutes, all of the functions
are active for 30 minutes.
If the engine has been running for
less than 10 minutes, this duration
before returning to economy mode is
5 minutes. All of these functions are
available when the engine is
running.
If the telephone is being used
when economy mode starts, it will still
be possible to fi nish the call.
LOAD REDUCTION FUNCTION
When driving, certain functions (air con-
ditioning, heated rear screen, heating
system for passenger compartment of
diesel vehicles, etc.) may be switched
off temporarily, depending on the level
of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
suffi cient.

Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated manually.
Replacing a blade

 Lift the arm, then unclip the blade
and remove it.

 Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk. A fl at battery prevents the en-
gine from starting.
If the doors or boot are opened
several times or if the alarm is
triggered, this may result in activation
of the energy economy mode.