2009 Peugeot 206 P Dag engine
[x] Cancel search: enginePage 27 of 113
29
De-icing - Demisting
To quickly de-ice or demist the wind-
screen and side windows:
place the air intake control 4 in the
" E x t e r i o r a i r i n t a k e " p o s i t i o n ,
place the air distribution dial 3 in the
" W i n d s c r e e n " p o s i t i o n ,
place the temperature dial 1 and the
a i r fl o w d i a l 2 in the maximum posi-
tion,
close the central vents,
switch on the air conditioning by
pressing the "A/C" button.
5. Air conditioning On/Off
S w i t c h i n g o n
Press the "A/C" button, the associ-
ated indicator light comes on.
T h e a i r c o n d i t i o n i n g d o e s n o t o p -
e r a t e w h e n t h e a i r fl o w a d j u s t m e n t
dial 2 is in position "OFF".
S w i t c h i n g o f f
Press the "A/C" button again, the as-
sociated indicator light switches off.
REAR SCREEN
DE-ICING
S w i t c h i n g o n
The rear screen de-icing can only oper-
ate when the engine is running.
Press this button to de-ice the rear
screen. The indicator light associ-
ated with the button comes on.
S w i t c h i n g o f f
The de-icing switches off automatically
to prevent an excessive consumption of
current.
It is possible to stop the de-icing op-
eration before it is switched off au-
tomatically by pressing the button
again. The indicator light associated
with the button switches off.
If the engine is switched off before the
de-icing is switched off automatically,
de-icing will resume next time the en-
gine is switched on.
Switch off the de-icing of the rear
screen as soon as you consider this
necessary as lower current con-
sumption results in reduced fuel
consumption. The control button is located on
the air conditioning system con-
trol panel.
The air conditioning is designed
to operate effectively in all sea-
sons, with the windows closed.
It enables you to:
- lower the temperature, in summer,
- increase the effectiveness of the de- misting, in winter above 0 °C.
Page 28 of 113
29
De-icing - Demisting
To quickly de-ice or demist the wind-
screen and side windows:
place the air intake control 4 in the
" E x t e r i o r a i r i n t a k e " p o s i t i o n ,
place the air distribution dial 3 in the
" W i n d s c r e e n " p o s i t i o n ,
place the temperature dial 1 and the
a i r fl o w d i a l 2 in the maximum posi-
tion,
close the central vents,
switch on the air conditioning by
pressing the "A/C" button.
5. Air conditioning On/Off
S w i t c h i n g o n
Press the "A/C" button, the associ-
ated indicator light comes on.
T h e a i r c o n d i t i o n i n g d o e s n o t o p -
e r a t e w h e n t h e a i r fl o w a d j u s t m e n t
dial 2 is in position "OFF".
S w i t c h i n g o f f
Press the "A/C" button again, the as-
sociated indicator light switches off.
REAR SCREEN
DE-ICING
S w i t c h i n g o n
The rear screen de-icing can only oper-
ate when the engine is running.
Press this button to de-ice the rear
screen. The indicator light associ-
ated with the button comes on.
S w i t c h i n g o f f
The de-icing switches off automatically
to prevent an excessive consumption of
current.
It is possible to stop the de-icing op-
eration before it is switched off au-
tomatically by pressing the button
again. The indicator light associated
with the button switches off.
If the engine is switched off before the
de-icing is switched off automatically,
de-icing will resume next time the en-
gine is switched on.
Switch off the de-icing of the rear
screen as soon as you consider this
necessary as lower current con-
sumption results in reduced fuel
consumption. The control button is located on
the air conditioning system con-
trol panel.
The air conditioning is designed
to operate effectively in all sea-
sons, with the windows closed.
It enables you to:
- lower the temperature, in summer,
- increase the effectiveness of the de- misting, in winter above 0 °C.
Page 29 of 113
30
AUTOMATIC AIR CONDITIONING
1. Automatic comfort programme
Automatic operation
2. Temperature adjustment
The value indicated on the display cor-
responds to a level of comfort and not
to a temperature in degrees Celsius or
Fahrenheit.
3. Automatic visibility programme
The automatic comfort programme may
n o t b e s u f fi c i e n t t o q u i c k l y d e m i s t o r d e -
ice the windscreen and side windows
(humidity, several passengers, ice...).
This system is designed to operate
effectively in all seasons, with the
windows closed.
When the engine is cold, to prevent
too great a distribution of cold air, the
a i r fl o w w i l l o n l y r e a c h i t s o p t i m u m l e v e l
gradually.
In cold weather, it favours the distribu-
tion of warm air to the windscreen, the
side windows and the footwells only.
The air conditioning can only operate with the engine ru
nning.
Press the "AUTO" button.
The "AUTO" symbol is dis-
played.
Press the arrows 1 (up and
down) to change this value.
A setting around 21 enables
you to obtain an optimum level
of comfort. Depending on your require-
ments, a setting between 18 and 24 is
usual.
On entering the vehicle, if the interior
temperature is much colder or warmer
than the comfort value, there is no need
to alter the value displayed in order to
obtain the required level of comfort. The
system eliminates the temperature dif-
ference automatically and as quickly as
possible.
In this case, select the auto-
matic visibility programme.
The system automatically con-
trols the air conditioning, the
a i r fl o w a n d t h e a i r i n t a k e a n d p r o v i d e s
optimum distribution of the ventilation to
the windscreen and side windows.
To exit this programme, press the
"AUTO" button again.
We recommend that you use this
mode: it provides optimised automatic
control of all of the functions, passenger
c o m p a r t m e n t t e m p e r a t u r e , a i r fl o w , a i r
distribution and air recirculation, in
accordance with the comfort value that
you have selected.
Page 39 of 113
i
40
KEYS
Central locking and unlocking
From the front doors, the keys allow you
to lock and unlock the doors and boot.
If one of the doors is open, the central
locking does not work.
If the boot is open, the central locking
works.
Remote control
This carries out the same functions as
the key, from a distance. Locking
Press button
A to lock the vehicle.
T h i s i s c o n fi r m e d b y fi x e d l i g h t i n g o f t h e
d i r e c t i o n i n d i c a t o r s f o r a p p r o x i m a t e l y
two seconds.
Unlocking
Press button B to unlock the vehicle.
T h i s i s c o n fi r m e d b y r a p i d fl a s h i n g o f
the direction indicators. Starting the vehicle
Steering lock
Before starting, unlock the steering, if
necessary, by turning the steering wheel
slightly while turning the key.
It is advisable to release the clutch dur-
ing the action of the starter to facilitate
the starting of the engine.
There are four possible positions of the
key in the ignition switch:
1. STOP position:
the ignition is off.
2. 1st notch, Accessories position:
the ignition is off but the accessories can operate.
3. 2nd notch, On position:
the ignition is on.
4. Starting position:
the starter is operated.
Avoid pressing the buttons of your
remote control out of range of your
vehicle as this could stop it from
working. The remote control would
then have to be reprogrammed
(refer to the corresponding section).
Page 41 of 113
i
40
KEYS
Central locking and unlocking
From the front doors, the keys allow you
to lock and unlock the doors and boot.
If one of the doors is open, the central
locking does not work.
If the boot is open, the central locking
works.
Remote control
This carries out the same functions as
the key, from a distance. Locking
Press button
A to lock the vehicle.
T h i s i s c o n fi r m e d b y fi x e d l i g h t i n g o f t h e
d i r e c t i o n i n d i c a t o r s f o r a p p r o x i m a t e l y
two seconds.
Unlocking
Press button B to unlock the vehicle.
T h i s i s c o n fi r m e d b y r a p i d fl a s h i n g o f
the direction indicators. Starting the vehicle
Steering lock
Before starting, unlock the steering, if
necessary, by turning the steering wheel
slightly while turning the key.
It is advisable to release the clutch dur-
ing the action of the starter to facilitate
the starting of the engine.
There are four possible positions of the
key in the ignition switch:
1. STOP position:
the ignition is off.
2. 1st notch, Accessories position:
the ignition is off but the accessories can operate.
3. 2nd notch, On position:
the ignition is on.
4. Starting position:
the starter is operated.
Avoid pressing the buttons of your
remote control out of range of your
vehicle as this could stop it from
working. The remote control would
then have to be reprogrammed
(refer to the corresponding section).
Page 42 of 113
i
4141
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system as
soon as the ignition has been switched
off and therefore prevents starting of
the vehicle by anyone who does not
have the key.
The ignition key has an electronic chip
which has a special code. When the ig-
nition is switched on, the code must be
recognised for starting to be possible.
If the system does not function correct-
ly, the central locking button indicator light,
s i t u a t e d o n t h e h a n d b r a k e c o n s o l e , fl a s h -
es rapidly when the ignition is switched on
(2nd notch).
In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as
possible.
Key in ignition
If the key is left in the ignition, this
is indicated by an audible signal
when the driver's door is opened.
Locating your vehicle
To locate your vehicle, if you have
locked it, in a car park:
press button A , the courtesy lights
come on and the direction indicators
fl a s h f o r a f e w s e c o n d s .
Changing the remote control
battery
Battery ref.: CR2016/3 volts.
I f t h e r e m o t e c o n t r o l b a t t e r y i s fl a t , y o u
are warned by a message on display B.
To replace the battery, remove the
screw then unclip the casing using a
coin at the ring.
If the remote control does not work after
the battery has been changed, repro-
gramme the remote control. Programming the remote
control
Switch off the ignition.
Switch the ignition on again.
Press button A immediately for a
few seconds.
Switch off the ignition and remove
the remote control key from the igni-
tion lock. The remote control is now
working again.
Page 44 of 113
i
4141
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system as
soon as the ignition has been switched
off and therefore prevents starting of
the vehicle by anyone who does not
have the key.
The ignition key has an electronic chip
which has a special code. When the ig-
nition is switched on, the code must be
recognised for starting to be possible.
If the system does not function correct-
ly, the central locking button indicator light,
s i t u a t e d o n t h e h a n d b r a k e c o n s o l e , fl a s h -
es rapidly when the ignition is switched on
(2nd notch).
In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as
possible.
Key in ignition
If the key is left in the ignition, this
is indicated by an audible signal
when the driver's door is opened.
Locating your vehicle
To locate your vehicle, if you have
locked it, in a car park:
press button A , the courtesy lights
come on and the direction indicators
fl a s h f o r a f e w s e c o n d s .
Changing the remote control
battery
Battery ref.: CR2016/3 volts.
I f t h e r e m o t e c o n t r o l b a t t e r y i s fl a t , y o u
are warned by a message on display B.
To replace the battery, remove the
screw then unclip the casing using a
coin at the ring.
If the remote control does not work after
the battery has been changed, repro-
gramme the remote control. Programming the remote
control
Switch off the ignition.
Switch the ignition on again.
Press button A immediately for a
few seconds.
Switch off the ignition and remove
the remote control key from the igni-
tion lock. The remote control is now
working again.
Page 46 of 113
44
DOORS
Opening the doors from outside
Opening the doors from inside
"Door open" warning
With the engine running , you are
warned if a door is not shut properly by
an audible signal.
When the vehicle is moving , if the
courtesy light button is in the "lighting
on opening a door" position, the cour-
t e s y l i g h t fl a s h e s , a c c o m p a n i e d b y a n
audible signal. Locking/Unlocking from the inside Automatic central
locking of
the doors.
Pressing button A permits locking/un-
locking of the doors. To switch on
Press and hold button
A .
Activation of the function is accompa-
nied by an audible signal.
To switch off
Press and hold button A .
Notes: if one of the doors is open, lock-
ing from the inside and automatic cen-
tral locking are not possible.
If the boot is open, automatic central
locking of the doors is active.
The doors can lock automatically when
you are driving (at a speed of more
than 6 mph (10 km/h)).
Above 6 mph (10 km/h), press button
A
b r i e fl y t o u n l o c k t h e d o o r s t e m p o r a r i l y .
You can activate or deactivate this
function.