2009 OPEL MERIVA lock

34 Keys, doors, windows, slide and tilt sunroofAnti-theft alarm system
3
Monitors
zthe doors, luggage compartment,
bonnet.
z the passenger compartment.
z vehicle tilt, e.g. if it is raised.
z the ignition.
Picture no: 15334t.tif
To activate
All doors, windows, sun roof 3, tilting
roof 3 and bonnet must be closed. Press
button p on the radio remote control
again within 10 seconds of locking.
If the ignition was switched on, the driver’s
door must be opened and closed once so
that the anti-theft alarm system can be
switched on.
Picture no: 11575s.tif
Activation without monitoring of
passenger compartment and vehicle tilt
Switch on e.g. if animal s are to be left in the
vehicle.
1. Close tailgate and bonnet.
2. Press button in front of the courtesy lamp
(with ignition off); LED in the hazard
warning lamp button flashes a
maximum of 10 seconds.
3. Close doors.
4. Activate the anti-theft alarm system. The LED lights up. After approx. 10 seconds,
the system is activated. The LED flashes
until the system is deactivated.
9 Warning
Do not use the system if there are people
in the vehicle! The doors cannot be
unlocked from the inside.

35
Keys, doors, windows, slide and tilt sunroof
Picture no: 14046s.tif
Light emitting diode (LED)
During the first 10 seconds of anti-theft
alarm system activation: After the first 10 seconds of anti-theft
alarm system activation:
Contact a workshop for assistance if
problems are encountered.
Picture no: 15335t.tif
To deactivate
Press button
q on remote control unit
– or –
switch on ignition.
In the case of a malfunction in the remote
control, use the key to unlock the vehicle
3 32.
If the alarm is triggered when the driver’s
door is opened, deactivate the anti-theft
alarm system by switching on the ignition.
z
LED comes on
= Test, delayed
switch-on,
z LED flashes
rapidly = Door, tailgate or
bonnet open, or
system fault.
zLED flashes
slowly =System switched on,
z LED comes on for
approx. 1 second = Switch-off function.

36 Keys, doors, windows, slide and tilt sunroofNote
zChanges to the vehicle interior, such as
the use of seat covers, could impair the
function of passenger compartment
monitoring.
z Switch off the interior monitoring system
when the interior of a parked vehicle is
being heated.
Alarm
When triggered, the alarm gives off an
acoustic signal (horn) and a visual signal
(hazard warning flashers). The number
and duration of the alarms are stipulated
by legislation.
The alarm can be silenced by pressing a
button on the remote control or by
switching on the ignition. The anti-theft
alarm system is deactivated at the same
time.
Picture no: 16102s.tif
Child safety locks Turn rotary knob at rear door lock from
vertical position using key: door cannot be
opened from the inside.
Picture no: 13985s.tif
Exterior mirrors Adjust manually with the handles in the
front door or electrically 3 with the switch
in the driver’s door console.
Adjust exterior mirrors manually
Use the knob to move the exterior mirrors in
the appropriate direction.
9 Warning
Use the child safety lock whenever
children are occupying the rear seats.

59
Seats, Interior
Three-stage safety system Comprising:
zthree-point seat belts,
z belt tensioners at the front seats,
z airbag systems for the driver and front
passenger seats 3 as well as the
outboard rear seats 3.
The three stages are activated in sequence
depending on the severity of the accident:
z The automatic seat belt locking devices
prevent the belt strap from being pulled
out and thus ensure that the vehicle
occupants are retained in their seats.
z The front seat belts are pulled down at
the belt buckles. This means the belts fit
snugly, the occupants are decelerated
early with the vehicle and the body
loading is reduced.
z The airbag systems are also triggered in
the event of severe accidents and form a
safety cushion for the occupants. Read the instructions supplied with the
child restraint system
Picture no: 18531s.tif
Three-point seat belts The seat belts have an automatic retractor,
so that the belt is spring tensioned and
always lies against the body.
Information on correct seat position
345.
The safety belts lock when the vehicle
accelerates or decelerates rapidly. This
prevents the belt from extending and
keeps the occupant in his or her seat.
9 Warning
The airbag systems serve to supplement
the three-point seat belts and belt
tensioners. The seat belts must therefore
always be worn. Disregard of these
instructions may lead to injuries or
endanger life. Vehicle passengers
should be informed accordingly.

64 Seats, Interior
Picture no: 14739S.tif
To remove the seat belt, press the button
on the left buckle (2). If the centre seat is
lowered, press the button on the right
buckle ( 1). The seat belt retracts
automatically.
Push the upper latch pl ate into the holder
for the lower latch plate. Fold over locked
together latch plates against the seat belt.
Picture no: 14740S.tif
Insert in the seat belt holder in the roof with
the lower latch plate pointing forward.
Mounting clips
3 for ISOFIX child
restraint systems
The ISOFIX points for fitting a child seat are
located between the seat backrest and the
seat surface.
Fasten permitted ISOF IX child restraint
systems to the mounting brackets.
Closely follow the installation instructions
accompanying the ISOFIX child restraint
system.

84 Instruments, Controls
Picture no: 17876s.tif
I

Engine oil pressure
Control indicator lights up red
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
1. Depress clutch.
2. Move gearshift lever to neutral, or with
manual transmissi on automated 3 place
selector lever in N.
Picture no:
3. Move out of the flow of traffic as quickly
as possible without impeding other
vehicles.
4. Switch off ignition.
Contact a workshop for assistance.
Caution
Engine lubrication may be interrupted.
This may result in damage to the engine
and/or locking of the drive wheels.
9 Warning
When the engine is off, considerably
more force is needed to brake and steer.
Do not remove key until vehicle has
come to a standstill, otherwise the
steering column lock could engage
unexpectedly.
O

Turn signal lamps
Control indicator flashes green.
The control indicator flashes if a turn signal
or the hazard warning flashers are
activated.
Rapid flashing: failure of a direction
indicator lamp or associated fuse.
Change bulbs 3 185. Fuses 3182.
C

Main beam
Control indicator lights up blue.
It is illuminated when main beam is on and
during headlamp flash 311, 3102.
j

Automatic transmission 3, start engine.
Control indicator lights up yellow.
The engine can only be started if the foot
brake is depressed. If the foot brake is not
depressed, the control indicator illuminates
3 130.

85
Instruments, Controls
Picture no: 18385s.tif
T
Winter mode for manual transmission
automated 3
Control indicator lights up yellow.
Control indicator lights up when winter
program is enabled 3132. m

Cruise control 3
Control indicator lights up green
This comes on when the system is switched
on 3148.
r
Fog tail lamp
Control indicator lights up yellow.
This comes on when the fog tail lamp is
switched on 3104.
Picture no:
p

Alternator
Control indicator lights up red.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
Stop, switch off engine. Battery is not
charging. Contact a workshop
immediately. R

Brake system, clutch system
Control indicator lights up or flashes red.
Illuminated
Illuminates when the ignition is switched on
if the hand brake is applied 3151.
Lights up when the hand brake is released
when the fluid level for the brake or clutch
systems is low 3214.
FlashesOn vehicles with manual transmission
automated 3, control indicator R flashes
for a few seconds after the ignition is
switched off when the hand brake has not
been applied. u

Anti-lock brake system
Control indicator lights up red.
Illuminates while driving
Fault in anti-lock braking system 3152. S

Engine oil level 3
Control indicator lights up yellow.
The engine oil level is checked
automatically 3.
Illuminates when the engine is running

Engine oil level too lo w. Check engine oil
level and top up engine oil if necessary
3 210.
9 Warning
Stop. Do not continue your journey.
Consult a workshop.

94 Instruments, Controls
Picture no: 16711t.tif
Function areas
For each functional area there is a main
page (Main), which is selected at the top
edge of the display (not with the
Infotainment system CD 30 or the Mobile
Phone Portal):
zAudio.
z Navigation 3.
z Telephone 3.
z Trip computer 3 .
For Audio, Navigation 3 and Telephone 3
functions – see infotainment system
instructions.
Picture no: 16712t.tif
System settings
The settings are accessed via the
Settings menu.
Press the Main button 3 (not found on all
infotainment systems) on the infotainment
system (call up main display).
Press the Settings button of the
infotainment system. On Infotainment
System CD 30, make sure no menu has
been selected.
The Settings menu is displayed.
Picture no: 16713t.tif
Setting date and time 3
Select menu item Time, Date, from the
Settings menu.
The menu for Time, Date is displayed.
Select the required menu item and make
setting.
FM AS [TP] REG CDin MP3

90.6
MHz
19,5° 19:36
7
Settings19,5° 19:36
Time, Date 19:36
Language
Units 10 . 07 . 2004
Contrast
Day / Night
! Ign. logic
7 Time, Date 19,5° 19:36
Time 19:36
Date 10 . 07 . 2004! Synchron. clock automatical.