2009 OPEL MERIVA headlamp

102 LightingLighting
Picture no: 14756s.tif
Exterior lightsTurn light switch:
In positions 8 and 9, the tail lamps and
number plate lamps are also on.
If the ignition is switched off when main
beam or dipped beam is on, the parking
lamps come on. Model with daytime running lights
3
With ignition on and lights turned on 7, the
dipped headlamps are on without
instrument illumination.
The daytime running lig hts switch off when
the ignition is switched off.
Follow the regulations of the country in
which you are driving when using daytime
running lights and fog lamps 3.
Driving abroad 3110.
Exterior lights ....................................... 102
Main beam, headlamp flash .............. 103
Turn signal lamps ................................ 103
Fog lamps > 3
.................................... 103
Fog tail lamp r................................... 104
Reversing lamps................................... 104
Hazard warning lamps ....................... 104
Headlamp range adjustment ?......... 104
Adaptive Forward Lighting 3 (AFL) .. 106
Lead-me lighting 3............................. 107
Instrument illumination k,
Information display illumination ...... 108
Courtesy lamp...................................... 108
Battery discharge protection 3.......... 110
Misted light covers............................... 110
Headlamps when driving abroad ...... 110 7
=Off
8 = Parking lamps
9 = Dipped or main beam

103
Lighting
Picture no: 18475s.tif
Main beam, headlamp flash Push stalk forward to switch from dipped
beam to main beam.
To switch to dipped beam, press stalk
forwards again.
To operate the headlamp flash, pull stalk
towards steering wheel. The main beam is
switched on for as long as the stalk is held
in this position.
Picture no: 14054h.tif
Turn signal lamps If the stalk is moved past the resistance
point, the turn signal lamp remains on.
When the steering wheel moves back
toward the straight-ahead position, the
turn signal lamp is automatically
deactivated.
Brief flash: press stalk to perceptible
resistance and release.
Manual disconnection of turn signal lamps
by returning to centre position.
Picture no: 14758s.tif
Fog lamps
> 3

The fog lamps can only be switched on
when both the ignition and lights are on.
Operated with the > button.
Lever upwards = Right turn signal
Lever downwards = Left turn signal

104 LightingFog tail lamp
r
The fog tail lamp can only be switched on
both the ignition and dipped
beam/parking lamps are on.
Operated with the r button.
The fog tail lamps on the vehicle are
deactivated when towing a caravan/
trailer.
Reversing lamps The reversing lamps come on when the
ignition is on and reverse gear is engaged.
Picture no: 14303s.tif
Hazard warning lamps Operated with the ¨ button.
To aid location of the pushbutton, the red
surface is illuminated when the ignition
switched on. When the button is pressed,
its control indicator flashes in time with the
hazard warning lamps.
Picture no: 14757s.tif
Headlamp range adjustment
?
Manual headlamp range adjustment 3
To adapt headlamp ra nge to the vehicle
load so that fellow motorists are not
blinded: Press knob to disengage and turn
to required position.

105
Lighting
Settings.
Automatic headlamp range
adjustment3
On vehicles with Xenon headlamps,
headlamp range is adjusted automatically
based on vehicle load.
0 = Front seats occupied
1 = All seats occupied
2 = All seats occupied and luggage
compartment load
3 = Driver’s seat occupied and luggage compartment load

106 Lighting
Picture no: 15209j.tif
Adaptive Forward Lighting
3
(AFL) ensures better illumination of
zbends (curve lighting),
z crossings and narrow bends (cornering
light).
Curve lighting
The light beam pivots based on
steering wheel position and speed (from
approx. 10 km/h).
The headlamps shine at an angle of up
to 15 to the right or left of the direction of
travel.
Picture no:
Cornering light
An additional lamp comes on with
certain steering wheel positions (after
approx. 90), turn si gnal settings and
speeds (up to approx. 40 km/h).
The light is thrown approx. 90 to the
left or right of the car, to a distance of
approx. 30 metres.
Reversing function
If the lights are on, reverse gear is
engaged, and the turn signal is activated,
the cornering light on the appropriate side
is switched on. The cornering light stays on
for 15 seconds once the turn signal has
been switched off.
Picture no: 17887s.tif
Control indicator B for adaptive driving
lights
Illuminated: Fault in system. The system is
not ready for operation.
Contact a workshop for assistance.
After a power supply interruption the
steering angle sensor must be calibrated to
make the system operational. 3147
Control indicator
B flashes for
about 4 seconds after the ignition is
switched on as a reminder that the
headlamps have been converted, see
"Headlamps for driving abroad" 3110.

107
Lighting
Picture no: 14302s.tif
Lead-me lighting
3
Lead-me lighting when leaving the
vehicle 3
The dipped headlamps come on for
around 30 seconds after switching on and
closing the driver’s door.
To activate:
1. Switch off ignition.
2. Remove ignition key.
3. Open driver’s door.
4. Pull turn signal stalk toward steering
wheel.
5. Close driver’s door. If the driver’s door is left open, the lamps
will go out after two minutes.
The light is switched off immediately by
inserting the key into
the ignition or pulling
the turn signal stalk towards the steering
wheel again.
Picture no: 17920S.tif
Lead-me lighting when opening the
vehicle 3
The Lead-me-to-the-car lighting function
allows the dipped headlamps to be lit for
around 30 seconds using the remote
control.
This function must be activated (once):
Unlock the vehicle, put the key in the
ignition and press the light switch for
approx. 5 seconds - see next page,
Fig. 14136 S.
To deactivate the function permanently,
contact a workshop.

110 LightingBattery discharge protection
3
Some consumers such as the interior
lighting switch themselves off after
approx. 30 minutes if the ignition is off in
order to protect the battery charge. Misted light covers The inside of the light covers may mist up
briefly in poor, wet and cold weather
conditions, in heavy rain or after washing.
The mist disappears quickly by itself; to
help, switch on the lights. Headlamps when driving abroad The asymmetrical dipped beam increases
the field of vision on the passenger side of
the lane.
In countries where traffic drives on the
opposite side of the road, prevent glare as
follows.
Vehicles with halogen headlamp system
or Xenon headlamp system 3
Have headlights conver ted in a workshop.
Picture no: 14053h.tif
Vehicles with Adaptive headlight 3 (AFL)
1. Pull stalk towards steering wheel and hold.
2. Switch on ignition.
3. After approx. 3 seconds, an acoustic signal sounds and then AFL control
indicator
B flashes approx. 4 seconds.
After the switch, AFL control indicator
B
flashes for 4 seconds each time the ignition
is switched on. To return to asymmetrical dipped beam,
pull and hold the main beam stalk again,
switch on the ignition and wait for the
acoustic signal. AFL control indicator
B
will then discontinue flashing.
Control indicator
B
3 106.

182 Self-help, vehicle care
Picture no: 14725s.tif
Keep spare fuses in the fuse box lid (shown
in yellow in the Fig.). Open lid 3182.
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its
melted wire. Do not replace the fuse until
the cause of the fault has been remedied.
To help in replacing fuses, there is a special
fuse-gripping tool in the fuse box 3.
Picture no: 12892j.tif
Slot fuse-gripping tool onto fuse and
withdraw it.
Some functions are protected by several
fuses.
There may be fuses inserted with no
function.
Always use fuses with the correct current
value. This is shown on each fuse, and is
also indicated by the fuse colour and the
plug-in location in the fuse box.
Different versions of fuses are used.
Picture no: 14211s.tif
Fuses and the most important
circuits they protect Fuse box in passenger compartment
Disengage fuse box cover at bottom and
remove. No. Circuit
1 Central control unit
2 Immobiliser, hazard warning
lamps, exterior lighting
3 Headlamp washer system