2009 OPEL MERIVA Owners Manual

123
Climate control
Picture no: 16496s.tif
Automatic mode
Basic setting for maximum comfort:
zPress AUTO button.
z Open all air vents.
z Switch on AC compressor 3125.
z Preset temperature to 22 C with turn
knob.
The temperature can be set higher or lower
as desired. Switching off the air conditioning
compressor (
ECO appears in display) can
have a detrimental effect on comfort and
safety 3125.
All air vents are actuated automatically in
automatic mode. The air vents should
therefore always be open 3115. Temperature preset
The left rotary knob can be used to set the
temperature to values of between 16 C
and 28 C.
For the sake of comfort, only change the
pre-selected temperature in small steps.
If the temperature setting is less
than 16 C,
LO appears in the air
conditioning display: the climate control
system runs constantly at maximum
cooling power, and the temperature is not
regulated.
If the temperature setting is
above 28 C, HI appears in the air
conditioning display: the climate control
system runs constantly at maximum
heating power, and the temperature is not
regulated.
The temperature settings remain stored
when the ignition is turned off.

124 Climate controlManual settings
Under certain circumstances (e.g. iced or
misted windows), the functions of the
climate control system can be modified
manually.
Manual settings are saved when the
ignition is switched off.
Make manual settings as follows when
necessary:
Picture no: 16501s.tif
Window demisting and defrosting
Misted or icy windows, e. g. due to damp
weather, damp clothing or low outside
temperatures:
Press button V, V appears in the air
conditioning display. Temperature, air dist
ribution and blower
are set automatically.
To return to automatic mode: press
button V or AUTO .
Heated rear window 341.
9 Warning
Disregard of the instructions could lead
to misting or icing of the windows and
subsequent accidents due to impaired
visibility.

125
Climate control
Picture no: 16503s.tif
Activating and deactivating air
conditioning compressor
Press the ECO button. ECO appears in the
air conditioning display.
Switch on to sa ve fuel. In this m ode cooling
(AC compressor) is switched off.
Inflowing air is neither cooled nor
dehumidified. This restricts the level of
comfort provided by the automatic climate
control system. This may cause the
windows to mist up, for example.
When cooling operates, condensation
forms and drips from the underside of the
vehicle.
To return to cooling operation: press
ECO button. ECO goes out.
Picture no: 16504s.tif
Air distribution
Press one or more of the following buttons.
The corresponding symbol appears in the
air conditioning display:
To return to automatic mode: Press the
appropriate buttons again, or press AUTO.
Picture no: 16505s.tif
Air flow
Set air flow using the right-hand rotary
knob. The selected fan speed is indicated
by the number of bars.
To deactivate the fan and thereby the
automatic climate control system: Turn the
right-hand rotary knob anticlockwise until
the display goes out.
Switching on: turn rota ry knob clockwise.
To return to automatic mode: Press
AUTO button.
sAir distribution towards windscreen
and front door windows.
M Air distribution towards vehicle
occupants via adjustable vents.
K Air distribution towards footwell.

126 Climate control
Picture no: 16506s.tif
Manual air recirculation mode
The air recirculation system prevents the
entry of outside air and the air in the
passenger compartment is circulated. Press button
4, % appears in the air
conditioning display.
To switch off manual air circulation: press
button 4 again.
Picture no: 16507s.tif
Air conditioning with the engine not
running
When the vehicle is stopped and the
ignition off, the residu al heat or cooling in
the system can be used for climate control
in passenger compartment, e.g. when
stopped at a level crossing.
Press AUTO with the ignition off. The
preselected temperature appears in the air
conditioning display. The temperature can
be adjusted with the left-hand rotary knob.
Residual climate control can only operate
for a limited period of time. To cancel,
press the AUTO button.
9 Warning
The exchange of fresh air is reduced in
air circulation mode. The quality of the
passenger compartment air
deteriorates which may cause the
vehicle occupants to feel drowsy. In
operation without cooling the air
humidity increases, so the windows may
mist up. Consequently, the air circulation
system should only be run for short
periods of time.

127
Climate control
Auxiliary heater Depending on outside temperature and
engine temperature, the passenger
compartment of vehicles with Quickheat 3
electric auxiliary heating is warmed up
more quickly.
Diesel-engined vehicles have a fuel-
powered auxiliary heater 3.
Picture no: 14147s.tif
Air intake The air intakes in front of the windscreen on
the far right and left sides of the engine
compartment must be kept clear to allow
air intake. Remove any leaves, dirt or snow. Air outletDo not cover the air outlets when storing
items in the luggage compartment storage
compartments.
Pollen filter The pollen filter cleans dust, soot, pollen
and spores from the air entering from
outside. The active carbon layer 3
eliminates most odours and noxious
environmental gases from the air.

128 Climate controlRegular operationFor consistently good operation, the air
cooling system 3 must be switched on for
several minutes once per month regardless
of the weather and the time of year.
Operation not possible with the cooling
system switched on and when the outside
temperature is low.
Service For optimal cooling performance, we
recommend that the climate control
system be checked annually, starting three
years after initial vehicle registration.
z Functionality and pressure test,
z Heating functionality,
z Leakage check,
z Check of drive belts,
z Cleaning of condenser and evaporator
drainage,
z Performance check.

129
Driving and operation
Driving and operation
Manual transmission
automated
3
The manual transmission automated
transmission 3 permits manual ( manual
mode ) or automatic gear shifting
(automatic mode ), both with automatic
clutch control.
Picture no: 17878s.tif
Transmission display
Shows the mode and current gear.
If the Winter programme is activated, T is
illuminated.
Manual transmission automated
3... 129
Manual transmission ........................... 134
Driving hints ......................................... 135
Saving fuel, protecting the environment ...................................... 137
Fuels, refuelling .................................... 139
Catalytic converter, exhaust gasses .. 142
Drive Control Systems ......................... 146
Hydraulic brake system ...................... 151
Anti-lock brake system (ABS u ) ........ 152
Hand brake .......................................... 153
Brake assist .......................................... 153
Hill Start Assist 3 (HSA) ...................... 153
Wheels, tyres ........................................ 153
Roof rack 3.......................................... 158
Towing equipment 3........................... 158
Towing equipment with removable coupling ball bar 3........................... 159
Caravan/trailer towing ........................ 162

130 Driving and operation
Picture no: 18386s.tif
Starting the engine
When starting the engine, activate the
footbrake at the same time. The engine
can only be started in position N and with
the footbrake activated. The transmission
display shows "N". If the footbrake is not
activated, the control light j 3 in the
instrument panel illuminates and "N"
flashes in the transmission display, the
engine cannot be started.
If no brake lights are operational, the
engine will not start.
Picture no: 14175s.tif
Operation of manual transmission
automated using selector lever
Always move the selector lever all the way
to the stop. Note the gear or mode
indicator in the transmission display.
Move selector lever toward N
Neutral. Selector lever in
o (centre position)
Once the selector lever has been moved
from N to position o (centre position) with
the foot brake operated, the Easytronic is
in automatic mode and first gear has been
selected (second gear with winter
programme enabled). "A" appears in the
transmission display.
When the foot brake is released the vehicle
starts to "creep". If the foot brake is not
operated, "A" flashes. Start off by pressing
the accelerator immediately or more
selector lever back to N and repeat
procedure with foot brake operated.
In Automatic mode, selection of other
gears is automatic irrespective of driving
conditions.