2009 OPEL MERIVA child restraint

44 Seats, InteriorSeats, Interior
Picture no: 13977s.tif
Front seats Adjust longitudinal seat position
Pull handle at front of seat, move seat and
then release handle.
Picture no: 13978s.tif
Adjusting the backrests
Take the pressure off the backrest and turn
the hand wheel on the side.
Front seats ........................................... 44
Head restraints .................................... 46
Armrest
3............................................. 48
Travel Assistant 3............................... 48
Rear seats............................................. 51
Flexible Seat System (FlexSpace) ....... 52
Luggage compartment extension ..... 53
Luggage compartment cover 3......... 55
Safety net 3......................................... 56
Lashing eyes ........................................ 57
Bag hangers 3..................................... 57
Notes on loading the vehicle .............. 58
Three-stage safety system.................. 59
Three-point seat be lts ......................... 59
Belt tensioners...................................... 60
Using the belts ..................................... 62
Mounting clips 3 for ISOFIX child
restraint systems ............................... 64
Child restraint system 3...................... 65
Airbag system ...................................... 67
Cigarette lighter 3............................... 78
Accessory sockets 3............................ 78
Ashtrays ............................................... 79
Stowage compartments ...................... 80
Foldaway tables 3.............................. 81
Coin holder 3....................................... 81
Sun visors.............................................. 81
9 Warning
Never adjust seats while driving. They
may make uncontrolled movements.

53
Seats, Interior
Picture no: 14729s.tif
Variant 2: Two rear seats
Lower the centre seat by pulling the release
handle on the back of the centre seat
backrest, fold backrest forward and
engage 354.
Set seat backrest to centre position using
the handle on the outside of the seat 351.
Pull the handle beneath the seat. Slide the
seat all the way back, then inward toward
the middle of the vehicle, and then further
back to the desired position
Release handle and allow seat to engage
in position.
Luggage compartment extension To increase the size of the luggage
compartment you can
z fold down the outboard rear seat
backrests,
z lower the middle seat,
z lower the folded outboard seats,
z fold down the passenger seat
backrest 3,
see following instructions.
The rear seats must also be in "Variant 1:
Three rear seats" 352.
Picture no: 14184s.tif
Fold down the outboard rear seat
backrests
Remove the luggage compartment
cover 3 if necessary 355.
Push head restra ints down fully, 33, 346.
Take seat belt out of the belt guide on the
backrest.
Remove the push-in sleeves 3 for
mounting the ISO-FIX child restraint
system – see separate instructions for the
ISO-FIX child restraint system.

59
Seats, Interior
Three-stage safety system Comprising:
zthree-point seat belts,
z belt tensioners at the front seats,
z airbag systems for the driver and front
passenger seats 3 as well as the
outboard rear seats 3.
The three stages are activated in sequence
depending on the severity of the accident:
z The automatic seat belt locking devices
prevent the belt strap from being pulled
out and thus ensure that the vehicle
occupants are retained in their seats.
z The front seat belts are pulled down at
the belt buckles. This means the belts fit
snugly, the occupants are decelerated
early with the vehicle and the body
loading is reduced.
z The airbag systems are also triggered in
the event of severe accidents and form a
safety cushion for the occupants. Read the instructions supplied with the
child restraint system
Picture no: 18531s.tif
Three-point seat belts The seat belts have an automatic retractor,
so that the belt is spring tensioned and
always lies against the body.
Information on correct seat position
345.
The safety belts lock when the vehicle
accelerates or decelerates rapidly. This
prevents the belt from extending and
keeps the occupant in his or her seat.
9 Warning
The airbag systems serve to supplement
the three-point seat belts and belt
tensioners. The seat belts must therefore
always be worn. Disregard of these
instructions may lead to injuries or
endanger life. Vehicle passengers
should be informed accordingly.

60 Seats, InteriorSeat belt control indicator X 3 82.
Seat belts are only intended for one person.
They are not suitable for anyone under
12 years of age or under 150 cm tall.
For children under the age of 12, we
recommend the Opel ch ild restraint system
3 65.
Belt force limiters
In the front seats, stress on the body is
reduced by dampened release of the
safety belt during a collision. Checking the seat belts
From time to time, ch
eck operation of all
seat belt system components and check for
damage. Have damaged components
replaced. Have seat belts and deployed
belt tensioners replaced by an authorised
workshop after an accident.
Make sure that seat belts are not damaged
or trapped by sharp-edged objects.
Picture no: 14719s.tif
Belt tensioners The front safety belt systems tighten at the
buckles in the event of a front or rear
collision above a specific degree of
severity. This tensions the seat belts.
Actuation of belt tensioners
is indicated by illumination of control
indicator v, see next column.
Triggered belt tensioners must be replaced
by a workshop. Belt tensioners can only be
triggered once.
9 Warning
Fasten your seat belt before each trip.
In the event of an accident, persons not
wearing seat belts endanger their fellow
occupants and themselves.

64 Seats, Interior
Picture no: 14739S.tif
To remove the seat belt, press the button
on the left buckle (2). If the centre seat is
lowered, press the button on the right
buckle ( 1). The seat belt retracts
automatically.
Push the upper latch pl ate into the holder
for the lower latch plate. Fold over locked
together latch plates against the seat belt.
Picture no: 14740S.tif
Insert in the seat belt holder in the roof with
the lower latch plate pointing forward.
Mounting clips
3 for ISOFIX child
restraint systems
The ISOFIX points for fitting a child seat are
located between the seat backrest and the
seat surface.
Fasten permitted ISOF IX child restraint
systems to the mounting brackets.
Closely follow the installation instructions
accompanying the ISOFIX child restraint
system.

65
Seats, Interior
Child restraint system
3
Follow the usage instructions for the child
restraint system.
Always comply with local or national
regulations. In some countries, the use of
child restraint systems is forbidden on
certain seats.
Selecting the right system
Your child should be transported facing the
rear in the vehicle for as long as possible.
The very weak cervical vertebrae of a child
will be under less stress in an accident if
your child is facing the rear and semi-
horizontal, than when he is sitting upright.
9 Warning
Child restraint systems must not be
carried on a passenger’s lap. Danger
to life.
Permissible options for fitting a child safety seat
1)
1)For reasons of safety, we recommend that the child safety seat be installed on one of the outer
rear seats.Weight and
age class
2)
2)We recommend the use of each system until the child reaches the upper weight limit.
On front
passenger seat On outboard seats in
the rear seats On centre
rear seat
Group 0:
up to 10 kg
or approx.
10 months
Group 0+:
up to 13 kg
or approx.
2years B
1, +
U, + U, ++
Group I:
9to18 kg
or approx.
8months
to 4 years B2, +
U, + U, ++
Group II:
15 to 25 kg
or approx.
3 to 7 years
Group III:
22 to 36 kg
or approx.
6 to 12 years X U U,
++

66 Seats, Interior
Note
zChildren under 12 years or under 150 cm
tall should only travel in an appropriate
child restraint system.
z When transporting children, use the child
restraint systems suitable for the child’s
weight.
z Ensure correct installation of child
restraint system, see the instructions
enclosed with the system.
z The covers of the Opel child restraint
system can be wiped clean.
z Do not stick anything on the child
restraint systems and do not cover them
with any other materials.
z Only allow children to enter and exit at
the side facing away from the traffic.
z A child restraint system which has been
subjected to stress in an accident must
be replaced.
z Secure or remove child restraint systems
that are in the vehicle but not in use.
B
1= Conditional, without front
passenger airbags or with seat
occupancy recognition and Opel
child restraint systems with
transponders.
The front passenger seat must also
have a height adjusting facility:
move to highest position, slide front
passenger seat all the way back and
move front passenger seat belt
anchorage point to lowest possible
position.
B2= Conditional, without side airbag, of front passenger seat has been slid
all the way back, or with seat
occupancy recognition and Opel
child restraint systems with
transponders.
The front passenger seat must also
have a height adjusting facility:
move to highest position and slide
front passenger seat all the way
back so that the seat belt runs
towards the front from the
anchorage point.
U = Universal suitability in conjunction with three-point seat belt. + = Vehicle seat available with ISOFIX
fixings. When using ISOFIX, only
ISOFIX child restraint systems
approved for the vehicle may be
used.
++ = Only if both outboard seats are pushed back and flush with the
centre seat.
X = No child restraint system permitted in this weight class.

67
Seats, Interior
Picture no: 16424s.tif
Airbag system Front airbag
The front airbag system consists of one
airbag in the steering wheel and one in the
instrument panel. These can be identified
by the word AIRBAG.
The front airbag system comprises:
z an airbag with inflator in the steering
wheel and a second one in the
instrument panel 3,
z the control electronics with impact
sensor,
z the control indicator for airbag
systems v in the instrument,
Picture no: 14317s.tif
z seat occupancy recognition 3,
z the control indicator for Opel child
restraint systems
y
with transponders 3
in the courtesy lamp.
The front airbag system will be triggered:
z depending on the severity of the
accident,
z depending on the type of impact,
z within the range show n in the illustration,
z independently of the side airbag
system 3 and curtain airbag system 3.
The ignition must be switched on. Exception:
Passenger seat with a seat occupancy
recognition system
3. The occupancy
recognition system deactivates the front
and side airbags for the passenger when
the seat is unoccupied or an Opel child
restraint system with transponders 3 is
fitted to the passenger seat. Seat
occupancy recognition 372. Opel child
restraint system with transponders 3 3 73.
Examples of events triggering the front
airbag system:
z Impact against a non-yielding obstacle:
the front airbags are triggered at low
vehicle speed.
z Impact against a yielding obstacle (such
as another vehicle): the front airbags are
only triggered at a higher vehicle speed.