2009 OPEL CORSA automatic transmission

10 In BriefControl indicators w
Deflation detection system 3,
3 84, 3164.
r
Ultrasonic parking sensors 3,
fault,
3 162.
B
Adaptive driving light 3, fault,
3 112, 3117.
j
Manual transmission
automated 3, starting the
engine 3,
3 85, 3137.
!
Preheating system 3,
Diesel particle filter 3,
3 85.
Z
Exhaust gases 3,
3 85, 3156.
A
Engine electronics, transmission
electronics 3, immobiliser, diesel
fuel filter 3 , fault,
3 27, 386, 3142, 3148, 3156.
S Engine oil level 3
,
3 86, 3242.
I
Engine oil pressure,
386.
p
Alternator,
3
87.
p
Electro-hydraulic power
assisted steering,
387.
O
Turn signal lamps,
311, 387.
Y
Fuel level,
387, 390.
C
Main beam,
311, 387.
W
Coolant temperature,
387, 3244.
*
Deactivate front passenger
airbag systems,
375.
T
Winter setting for automatic
transmission
3 or automated
transmission 3,
3 140, 3146.
1
Manual transmission
automated SPORT mode
3,
3 139, 3146.
q
Headlamp range adjustment,
375.
8
Exterior lights,
388, 3108.
>
Fog lamps 3,
3 88, 3110.
v
Airbag systems, belt tensioners,
361, 374.
X
Seat belt 3,
3 89, 362.
r
Fog tail lamp,
388, 3110.
R
Brake system, clutch system,
389, 3167, 3246.
u
Anti-lock brake system,
3166.
v
Electronic Stability Programme
(ESP®
Plus
) 3 ,
3 151.
m
Cruise control 3,
3 161.
Back to overview

14 In Brief
Picture no: 18177s.tif
To clear fogged or icy windows Air distribution to
l
, turn rotary switch for
temperature and air flow; climate control 3:
Button n must also be pressed; automatic
climate control 3: button V must also be
pressed.
Climate control 33120.
Picture no: 18178s.tif
To set automatic mode of climate
control system
3
Press AUTO button, select temperature
with rotary knob, open air vents.
6 Climate control system 3 3 128.
Picture no: 18179s.tif
Manual transmission Reverse gear: With vehicle stationary, wait
3 seconds after depressing the clutch, then
lift the ring below the gear knob and
engage gear.
If the gear does not engage, set the lever in
neutral, release the clutch pedal and
depress again; then re peat gear selection.
Manual transmission 3144.
Back to overview

15
In Brief
Picture no: 18180s.tif
Automated manual
transmission
3
Always move the selector lever in the
appropriate direction right up to the stop.
It will automatically re turn to the neutral
position after each operation.
The foot brake must be depressed when
starting.
Automated manual transmission 3 3 136.
Picture no: 18181s.tif
Automatic transmission
3
Only start engine in P or N. To come out
of P, turn the ignition, operate the foot
break and press the button.
Deactivate the selector lever lock by
pressing the button.
6 Automatic transmission 3 3144.
Before starting off, check z Tyre pressure an d tyre condition 3169,
3 264.
z Engine oil level and fluid levels in engine
compartment, 3241 to 3248.
z All windows, mirrors, exterior lighting
and number plates are free from dirt,
snow and ice and operational.
z Seats, seat belts and mirrors are
correctly adjusted 348, 358, 342.
z Check brake function at low speed,
particularly if the brakes are wet.
N = Idling
o =Driving position
+ =Higher gear
- =Lower gear
A = Switch between Automatic and
Manual mode
R = Reverse gear (with selector lever
lock)
P = Park position
R = Reverse gear
N = Neutral (idling)
D = Automatic gear selection
3 =1st to 3rd gear
2 = 1st and 2nd gear
1 =1st gear
Back to overview

16 In Brief
Picture no: 16982t.tif
Steering wheel lock and ignitionTurn key to position 1. Move the steering
wheel slightly to release the steering wheel
lock.
Picture no: 17005t.tif
Starting the engineDepress clutch and brake pedals, select 3
P or N for automatic transmission, 3N for
manual transmission automated. Do not
press the accelerator, in the case of diesel
engines, release the key in position 2 until
the warning light ! goes out, turn the key
to position 3 and release once the engine is
running.
Before restarting or switching off the
engine, turn key back to 0.
To switch on the ignition, only turn the
key to 2.
Picture no: 18183s.tif
Releasing the hand brake:
Raise lever slightly,
press release button,
lower lever fully Hand brake 3167.
0
=Ignition off
1 = Steering free, ignition off
2 = Ignition on, with diesel engine:
pre-heating
3 =Starting
Back to overview

17
In Brief
Parking the vehicle zApply hand brake firmly without
operating release bu tton. On a downhill
or uphill slope, apply as firmly as
possible. Apply foot brake at same time
to reduce operating force.
z Switch off engine and ignition. Turn the
ignition key to position 0 and pull it out.
Turn the steering wheel until it is clear
that the steering lock has engaged
(anti-theft protection).
On vehicles with automatic
transmission 3, the key can only be
removed when the selector lever is in
the P position.
On vehicles with manual transmission
automated 3, control indicator R
flashes for a few seconds after the
ignition is switched off if the hand brake
has not been applied. z
If the vehicle is standing on a level
surface or a hill, select first gear before
switching the ignition off with manual
transmission automated 3, and with
automatic transmission 3 move selector
lever to P. Also turn front wheels away
from kerb if parked on an uphill slope.
If the vehicle is parked on a slope, with
manual transmi ssion or manual
transmission automated, 3 select
reverse gear before switching the
ignition off, and with automatic
transmission 3 move selector lever to
position P. Also turn front wheels
towards the kerb.
z Lock vehicle with key in lock or button p
on the remote key fob.
To activate the anti-theft locking
system 3 and anti-theft alarm system 3,
press button p twice.
Advice when parking zDo not park the vehicle on an easy
flammable surface. The high
temperature of the exhaust system
could ignite the surface.
z Close the windows and sun roof 3.
z The engine cooling fans may run after
the engine has been switched off 3241.
z After running at high engine speeds or
with high engine loads, operate the
engine briefly at a low load or run in
neutral for approx. 30 seconds before
switching off in order to protect the
turbocharger 3.
Remote control 331,
Central locking system 332,
Anti-theft alarm system 3 3 37,
Vehicle decommissioning 3249.
Back to overview

27
Keys, doors, windows, sun roof
Picture no: 17349t.tif
Electronic immobiliser The system checks whether the vehicle is
allowed to start with the key used. Once
the transponder in the key is recognised,
the vehicle can be started.
The electronic immobiliser activates
automatically when the key is removed
from the ignition switch.
Picture no: 18231s.tif
Control indicator for immobilizer A
Control indicator A illuminates briefly
when the ignition is switched on.
If the control indicator flashes when the
ignition is on, there is a fault in the system;
the engine cannot be started. Switch off
the ignition and then repeat the start
attempt.
If the control indicator A continues to
flash, please try to start the engine using
the second key and contact a workshop. If control indicator
A illuminates after the
engine has started, there is a fault in the
engine electronics or transmission
electronics 33142, 3148, 3156 or there is
water in the diesel fuel filter 33244.
Note
The immobiliser does not lock the doors.
You should always lock the vehicle after
leaving it and switch on the anti-theft
alarm system 3 3 33, 337.
Back to overview

85
Instruments, controls
r

Ultrasonic parking sensors 3
Control indicator lights or flashes yellow.
Lamps
Fault in system. Have the cause of the fault
eliminated by a workshop.
Flashes
Fault due to sensors that are dirty or
covered by ice or snow
or
Interference due to external sources of
ultra sound (e.g. pneumatic drills, rotary
machines). Once the source of interference
is removed, the system will operate
normally.
Ultrasonic parking sensors 3 162.
B
Adaptive Forward Lighting 3 (AFL)
Control indicator lights up and/or flashes
yellow.
Lamps

Fault in system. Contact a workshop for
assistance.
Flashes for 4 seconds after the ignition has
been switched on

System converted for driving abroad.
AFL 3112.
j

Manual transmission automated 3 start
engine
Control indicator lights up yellow.
The engine can only be started if the foot
brake is depressed. If the foot brake is not
depressed, the control indicator illuminates
3 137.
!

Preheating system 3, diesel particle
filter 3
Control indicator lights up and/or flashes
yellow.
Lamps

Preheating activated. Only activates when
outside temperatures are low.
Flashes
(in vehicles with diesel particle filter)
Control indicator ! flashes if the filter
requires cleaning and previous driving
conditions did not permit automatic
cleaning. Continue driving and if possible do
not allow engine speed to drop below
2000 rpm. The control indicator
! goes off as soon
as the self-cleaning op eration is complete.
Diesel particle filter 3157.
Z

Exhaust emission 3
Control indicator lights up and/or flashes
yellow.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
Fault in emission control system. The
permissible emission limits may be
exceeded. Contact a workshop for
assistance immediately.
If it flashes when the engine is runningFault that could lead to catalytic converter
damage. Ease up on the throttle until the
flashing stops 3156. Seek the immediate
assistance of a workshop.
Back to overview

86 Instruments, controls
Picture no: 18469s.tif
A

Engine electronics, transmission
electronics 3, immobiliser,
diesel fuel filter 3
Control indicator lights up and/or flashes
yellow.
It illuminates for a few seconds when the
ignition is switched on.
Illuminates when the engine is running

Fault in engine electronics or transmission
electronics. Electronics switches to
emergency running program, fuel
consumption may increase and driveability
of vehicle may be affected 3156. If the
fault is still there when the engine is started
again, contact a workshop for assistance.
Picture no:
Lamps
together with InSP4 on the service
display: Diesel fuel filter needs to be
drained of water 3244.
Flashes when the ignition is on

Fault in the electronic immobiliser system;
the engine cannot be started 327.
S

Engine oil level 3
Control indicator lights up yellow.
The engine oil level is checked
automatically.
Illuminates when the engine is running

Engine oil level too low. Check engine oil
level and top up engine oil if necessary
3 242.
I

Engine oil pressure
Control indicator lights up red.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
1. Depress clutch.
2. Shift manual transmission or manual
transmission automated 3 into neutral;
for automatic transmission 3, set
selector lever to N.
3. Move out of the flow of traffic as quickly as possible without impeding other
vehicles.
4. Switch off ignition.
Contact a workshop for assistance. Caution
Engine lubrication may be interrupted.
This may result in damage to the engine
and/or locking of the drive wheels.
9
Warning
When the engine is off, considerably
more force is needed to brake and steer.
Do not remove key until vehicle has
come to a standstill, otherwise the
steering column lock could engage
unexpectedly.
Back to overview