2009 OPEL CORSA spare wheel

24 In Brief
Picture no: 18327s.tif
Heated steering wheel
3
Heating of the steering wheel and of the
driver’s seat is switched on by a single, or
repeated (as appropriate) activation of the
switch ß - .
Heating of the steering wheel - the section
marked out in the illustration.
Heated steering wheel 351.
Picture no: 18417s.tif
Double load-bay floor
3
Double load-bay floor, which can be
inserted in the baggage compartment in
two positions.
If mounted in the upper position, the space
between the load-bay floor and the spare
wheel well cover 3 can be used as a
stowage compartment.
In this position, if the rear seat backrests
are folded forwards, an almost completely
flat load bay is created.
Double load-bay floor 382.
Picture no: 18335s.tif
Flex-Fix system
3
The Flex-Fix system allows two bikes to be
attached to a pull-ou t carrier integrated
into the vehicle floor.
If not in use, the Flex-Fix system can be
collapsed back into the vehicle floor.
Flex-Fix system 3174.
Back to overview

82 Seats, Interior
Picture no: 18424s.tif
Stowage compartments Stowage compartment 3 beneath
passenger seat
Lift stowage compartment by grasping
recessed edge and pull out. Maximum
load: 1.5 kg. To close the stowage
compartment, push it in and engage.
Picture no: 18289s.tif
Glove compartment
Pull lever to open.
In the open cover, you will find:
z a card holder in cheque card format,
z pen holder,
z pocket torch holder.
The glove compartment should remain
closed while driving.
Picture no: 18400s.tif
Stowage compartmen t beneath double
load-bay floor 3
The double load-bay fl oor can be inserted
in the luggage compartment in two
positions:
z directly beneath the cover for the spare
wheel recess 3 or the floor cover 3, or
z in the upper openin gs in the luggage
compartment.
To remove, lift the load-bay floor using a
lever and pull backwards.
To insert, push the lo ad-bay floor forwards
in the corresponding guide, then lower.
Back to overview

83
Seats, Interior
Picture no: 18417s.tif
If mounted in the upper position, the space
between the load-bay floor and the spare
wheel well cover 3 can be used as a
stowage compartment.
In this position, if the rear seat backrests
are folded forwards, an almost completely
flat load bay is created.
The double load-bay floor is able to
withstand a load of no more than 100 kg.
In the model with a tyre repair kit 3, the
spare wheel recess may be used as an
additional stowage compartment.
Sun visors Use the sun visor to protect from glare by
pulling it down and swivelling it to the side.
The mirror covers in the sun visors should
be closed while driving.
Back to overview

164 Driving and operation
Picture no: 18244s.tif
Deflation detection system (DDS)3
The deflation detection system monitors
the revolutions of all four vehicles from a
speed of approximately 30 km/h. If there is
a loss of pressure in one of the tyres, its
diameter is reduced, and therefore also the
wheel rotation speed. Warning lamp w
lights red.
Stop immediately and check tyre pressure.
Fit the spare wheel if necessary 3 196,
3 200. Control indicator
w

If control indicator w lights up red while
driving, there is a loss of pressure. Stop
immediately and check tyre pressures. A
maximum speed of 80 km/h is permitted
for tyres run flat 3 3 171.
Control indicator illumination w in yellow
indicates a fault in the system. Have cause
of fault remedied by a workshop. The
system’s integrated se lf diagnostics allow
faults to be quickly remedied.
The control indicator flashes three times
when the system is initialising.
Tyre pressure 3169, 3264.
Picture no: 18245s.tif
System initialisationAfter correcting the tyre pressure or
changing a tyre/wheel, the system must be
initialised: turn the ignition on, press the
DDS button for approx. 4 seconds. Control
indicator w flashes three times. The system
is operational after driving a certain
distance.
Only initialise the system if all tyres have
the prescribed pressure.
9
Warning
The deflation detection system does not
replace manual checks with a suitable
gauge.
Check tyre pressures at least every
14 days and prior to any long journey;
the tyres should be checked when cold.
Don’t forget to check the spare 3.
Back to overview

168 Driving and operationWheels, tyres Suitable tyres and restrictions 3264.
Tyres fitted in the factory are adapted to
the chassis and provide optimum driving
comfort and safety.
Changing tyre/wheel type
If tyres of a different size than those fitted
at the factory are used, it may be
necessary to reprogram the electronic
speedometer and make other vehicle
modifications.
After converting to a different tyre size,
have the adhesive label with tyre pressures
replaced. Vehicles with run-flat tyres
3
When switching wheels, e.g. when
switching to winter tyres, use run-flat tyres
as there is no spare wheel or tyre repair kit
in the vehicle.
Vehicles with engine Z 10 XEP: Run-flat
tyres are not permitted for all rear axle
applications. We recommend your Opel
Partner.
Run-flat tyres 3 3171. Fitting new tyres
Fit tyres in pairs or in sets, which is even
better. Ensure that tyres on one axle are
z
the same size,
z the same design,
z the same make,
z and have the same tread pattern.
Fit directional tyres such that they roll in the
direction of travel. The rolling direction is
indicated by a symbol (e.g. an arrow) on
the sidewall.
Tyres fitted opposing the rolling direction
(e.g. when a tyre is changed) should be
refitted as soon as possible. This is the only
way to obtain full benefit from the design
properties of the tyre.
Run-flat tyres 3 m u s t n o t b e c o m b i n e d w i t h
conventional tyres.
Pay attention to legal requirements when
disposing of tyres.
9
Warning
Use of unsuitable tyres or wheels may
lead to accidents and render the vehicle
unroadworthy.
Back to overview

169
Driving and operation
Picture no: 18311s.tif
Tyre pressure
Check tyre pressure, including the spare
wheel, at least every 14 days and prior to
any long journey; the tyres should be
checked when cold. Don’t forget to check
the spare wheel 3.
Remove the valve cap key from the tank
flap and use it to unscrew the valve cap.
Tyre pressure 3264 and on the adhesive
label 3 on the inside of the tank flap.
The tyre pressure data is for cold tyres. It
applies to both summer and winter tyres. Always inflate the spare wheel
3 to the
pressure specified for full load.
Do not reduce tyre pr essure when the tyres
are warm. Otherwise the pressure may
drop below the permissible minimum when
the tyres cool down.
After having checked the tyre pressure,
tighten the valve caps using the valve cap
key.
Incorrect inflation pressures will impair
safety, vehicle handling, comfort and fuel
economy and will increase tyre wear.
Picture no: 17213t.tif
9
Warning
If the pressure is too low, this can result
in considerable tyre warm-up and
internal damage, leading to tread sepa-
ration and even to tyre blow-out at high
speeds.
Back to overview

172 Driving and operationWinter tyres 3
Notes on fitting new tyres 3 168.
Restrictions 3171, 3264.
Winter tyres improve driving safety at
temperatures below 7 C.
The design of summer tyres means they
have limited qualities for winter driving.
In accordance with country-specific
regulations, affix the speed sticker 3 in the
driver’s field of view.
If you use the spare wheel when it is fitted
with a summer tyre, the vehicle’s
driveability may be affected, especially on
slippery road surfaces. Obtain a
replacement for the faulty tyre as soon as
possible, and have the wheel balanced
and fitted to the vehicle.
Wheel covers 3
Use of wheel trims and tyres that approved
by Opel for the vehicle in question and
thereby fulfil all requirements for the wheel
and tyre combination.
If the wheel trims and tyres used are not
Opel-approved, the ty res must not have a
beaded edge. Wheel trims must not impair brake cooling.
Remove the wheel trims if fitting tyre
chains
3.
Picture no: 17217t.tif
Tyre chains
Restrictions and further information 3264.
Tyre chains are only permitted on the
driven wheels (front axle). They must be
fitted to the tyres symmetrically in order to
achieve a concentric fit.
Always use fine mesh chains that add no
more than 10 mm to the tyre tread and the
inboard sides (including chain lock).
9
Warning
Use of unsuitable tyres or wheel trims
could lead to sudden loss of air and
thereby accidents.
Back to overview

173
Driving and operation
Remove the wheel trims if using tyre chains
3201.
Tyre chains may only be used at speeds up
to 50 km/h. When travelling on roads that
are free of snow, they may only be used for
brief periods.
Tyre chains must not be used on the
temporary spare wheel. If you need to use
tyre chains after suffering a flat front tyre,
fit the temporary spare on the rear axle
and transfer one of the rear wheels to the
front axle.
Roof rack
3
For safety reasons and to avoid roof
damage we recommend using the Opel
roof rack system that is approved for your
vehicle.
Follow the usage instructions for the roof
rack.
Remove the roof rack when not in use.
Driving hints 3 149
Picture no: 18313s.tif
Fitting on model without sun roof 3
Push covers for concealing roof rack
mounts down and push backwards with a
valve cap key. Location of valve cap key
3 169.
Fitting on model with sun roof 3
Disengage covers concealing roof rack
mounts by pushing sliders in direction of
arrow (e.g. with coin) and remove upwards.
To close roof rack mounts, first insert
covers at front and engage sliders at rear.
Attach roof rack at appropriate points, see
enclosed roof luggage rack system
instructions.
9
Warning
Damage may lead to tyre blowout.
Back to overview