
5-1Instruments and controls
Instruments and
controlsSteering wheel adjustment
To adjust steering wheel 3, pull lever
forwards, adjust height, push lever
back and engage.
Adjust steering wheel only with
vehicle stationary and steering
column lock released.
Push the lever firmly backwards to
ensure that the steering wheel is
locked in position.
Steering wheel mounted
remote control 3
The functions of the Infotainment
system can be operated with the
buttons on the steering wheel.
Further information 3 7-2. Horn j .................................... 5-2
Windscreen wipers................ 5-2
Windscreen washer system .. 5-3
Rear window wiper/washer ... 5-3
Clock ..................................... 5-3
Outside temperature 3 .......... 5-4
Power outlets ........................ 5-4
Cigarette lighter ) 3 ............... 5-5
Ashtrays 3 ............................. 5-5
Warning lights, gauges and
indicators ............................ 5-5
Transmission display 3 ......... 5-7
Control indicators .................. 5-8
Warning chimes .................... 5-13
Service interval display 3 ...... 5-14
Engine oil life monitor 3......... 5-14
Trip computer 3 ..................... 5-14

5-4 Instruments and controls
Outside temperature 3
The outside temperature is shown in
the odometer display when the
ignition is switched on.If outside temperature drops to near
freezing point (0 °C), the symbol:
illuminates in the odometer display as
a warning for icy road surfaces.
Power outlets
Located on the instrument panel,
below the climate control switches.Operational with ignition switch in
positions ACC or ON.
Pull the cap out to use the accessory
socket, and replace it when not in
use.
The use of non-authorised
accessories may cause damage to
the socket.
Use of accessory sockets while the
engine is not running will discharge
the battery.
The maximum power requirement of
electrical accessories must not
exceed 120 watts.
Do not connect any current delivering
accessories, e.g. electrical charging
devices or batteries.
Connected electrical accessories
must comply with the EC standard in
terms of electromagnetic
compatibility requirements laid down
in DIN VDE 40 839, otherwise vehicle
malfunctions may occur. Release Ö for approx. 5 seconds to
set minute display.
Hour display flashes.
Press Ö to set hours.
Release Ö for approx. 5 seconds to
set hour display.
9 Warning
The road surface may already be
icy, even though the display
indicates a few degrees above
0°C.

5-5Instruments and controls
Cigarette lighter ) 3
With ignition switch in positions ACC
or ON, push the cigarette lighter in all
the way and release it.
Heating up ceases once element is
glowing; cigarette lighter pops up
automatically. Withdraw lighter.
Ashtrays 3
Portable ashtrayThe portable ashtray can be fitted in
the front or rear cup holder in the
centre console.
Warning lights, gauges
and indicators
Speedometer
Indicates the vehicle speed.
9 Warning
To be used only for ash and not
for combustible rubbish.

5-6 Instruments and controls
Odometer
The odometer indicates how far the
vehicle has been driven.
Trip odometer
There are two independent trip
odometers which indicate how far the
vehicle has been driven since the last
reset.
Press the MODE button repeatedly
until A or B appears on the left of the
odometer display. To reset a trip odometer, press and
hold the MODE button for approx.
2 seconds while the relevant trip
odometer is displayed.
Odometer display brightness
To change brightness level, switch on
headlamps and press the MODE
button repeatedly until the squares
that indicate the brightness level
appear in the odometer display. Then
press and hold the MODE button to
cycle through brightness levels.Four squares indicates maximum
brightness, while one square
indicates the minimum brightness
level.
Tachometer
Indicates the engine speed.
Caution
Pointer in warning zone; maximum
permissible engine speed
exceeded, danger to engine.

5-8 Instruments and controls
Instrument clusterControl indicators
The control indicators described here
are not present in all vehicles. The
description applies to all instrument
versions.
The colours of the control indicators
mean:
„Red
Danger, important
reminder.
„Yellow
Warning, information,
fault.
„Green
Confirmation of
activation.
„Blue
Confirmation of
activation.

5-9Instruments and controls
X Driver’s seat belt
Will illuminate in red when ignition is
switched on if driver’s seat belt is not
engaged.
If vehicle speed exceeds 15 km/h
(9 mph) and driver’s seat belt is not
engaged, the control indicator will
flash for approx. 90 seconds along
with a warning chime and then
illuminate until driver’s seat belt is
fastened correctly.
Seat belts 3 3-5.
v Airbag systems, belt
tensioners
Will flash in red several times when
the ignition is switched on, then
extinguish.
If it does not flash when the ignition is
switched on, stays lit, illuminates or
flashes whilst driving, there is a fault
with the airbag systems or with the
belt tensioners. The systems might
not therefore be triggered in the event
of an accident. Seek the assistance
of a workshop immediately.
Belt tensioners 3 3-6, airbags 3 3-13.
p Charging system
Will illuminate in red when ignition is
switched on. Extinguishes after
engine is started.
If it stays lit after the ignition is
switched on or illuminates during
driving: stop vehicle and switch off
engine. The battery is not being
charged and the engine cooling may
be interrupted. The brake servo unit
may cease to be effective. Interrupt
your journey immediately.
Remove ignition key and check drive
belt condition and tensioning before
seeking the assistance of a
workshop.
s Service transmission 3
Will illuminate briefly in yellow when
the ignition is switched on.
If it flashes, there is a fault in the
automatic transmission. Seek the
assistance of a workshop
immediately.
Automatic transmission 39-3.
R Brake system
Will illuminate in red when ignition is
switched on. Extinguishes after
engine is started.
Illuminates when engine is running if
parking brake is applied and/or fluid
level for brake hydraulics is too low.
Further information 3 9-9,
brake fluid level 3 10-6.
u Anti-lock Brake System
(ABS)
Will illuminate briefly in yellow when
ignition is switched on.
At the same time, the system
performs a self-check. When the
control indicator extinguishes, the
system is ready for operation.
Caution
If it illuminates when the parking
brake is not applied: stop vehicle;
interrupt your journey immediately.
Seek the assistance of a workshop.

5-11Instruments and controls
If it stays lit or illuminates during
driving, there is a fault with ESP®.
The vehicle’s brake system remains
operational without ESP
® regulation.
Seek the assistance of a workshop to
have the cause of the fault remedied.
Further information 3 9-10.
W Engine coolant
temperature
Will illuminate briefly in red when
ignition is switched on.
If it illuminates or flashes when the
engine is running: stop vehicle and
switch off engine. Coolant
temperature is too high; danger of
engine damage. Check coolant level.
Further information 3 10-4.
N Preheating for diesel
engines 3
Will illuminate during engine
preheating.
Preheating system switches on only if
outside temperature is low.
If it illuminates during driving or if the
engine cannot be started, seek the
assistance of a workshop as soon as
possible.
Starting the engine 3 9-2.
Z Exhaust emissions
Will illuminate in yellow when ignition
is switched on. Extinguishes after
engine is started.
If it illuminates when the engine is
running: fault in emission control
system. The permitted emission
limits may be exceeded. Fuel
economy and vehicle driveability may
be impaired. Seek the assistance of a
workshop immediately.Diesel engines: The engine stops and
control indicator Z illuminates if the
fuel level is too low. If the tank has
been run dry, bleed the fuel system 3
10-7.
Vehicles with electric throttle body
system 3: If the battery has been
disconnected, the system must be
recalibrated upon reconnection of the
battery. Hold ignition key in ON
position for 5 seconds without
running the engine. Control indicator
Z remains illuminated after the
engine is started if the procedure is
not successful.
I Engine oil pressure
Will illuminate in red when ignition is
switched on. Extinguishes after
engine is started.
If it illuminates during driving; engine
oil pressure may be dangerously low,
interrupting engine lubrication and
resulting in damage to the engine
and/or locking of the drive wheels:
„Move out of the flow of traffic as
quickly as possible without
impeding other vehicles,
9 Warning
Allow engine to cool down before
removing coolant filler cap.