2009 OPEL AGILA warning

2-7 Keys, doors and windows
To unlock driver’s door only: Press
buttonc on remote control:
„Hazard warning lamps flash twice.
- or -
Turn key in driver’s door lock towards
front of vehicle once.
To unlock entire vehicle: Press
buttonc on remote control twice:
„Hazard warning lamps flash twice
with each press.
- or -
Turn key in driver's door lock towards
front of vehicle twice.Immobiliser 3
The system checks whether the
vehicle may be started using the key
that has been inserted. If the key is
recognised as "authorised", the
vehicle can be started. The check is
carried out via a transponder housed
in the key.
The immobiliser is automatically
activated when the key is turned to
the LOCK position and removed from
the ignition switch.The theft-deterrent control indicator
starts flashing after the key is turned
to positions LOCK or ACC, or
removed from the ignition switch.
Fault
If control indicator o or A flashes
after the ignition is switched on, there
may be a fault in the immobiliser
system. If the engine cannot be
started:
„Turn key to LOCK position and
remove,
„wait approx. 2 seconds,
„then repeat starting procedure.

2-10Keys, doors and windows
Windows
Manual windows
The door windows can be operated
with the crank.
Power windows 3
Operational with key in ignition switch
position ON.
Driver’s and front passenger’s door
windows are operated via two
switches located in the driver’s door.
For incremental operation, briefly pull
or press the appropriate switch.
For automatic opening of the driver’s
door window, press the switch down
fully and release it. Pull up the switch
to stop the window movement.
9 Warning
Care must be taken when
operating the power windows.
There is a risk of injury,
particularly for children, and a
danger that articles could become
trapped.
If there are children on the front
passenger’s seat, press the z
switch in the driver’s door to
deactivate power window
operation.
Keep a close watch on the
windows when closing them.
Ensure that nothing becomes
trapped in them as they move.
Before leaving the vehicle,
remove the ignition key in order to
prevent unauthorized operation.

3-1Seats, restraints and interior
Seats, restraints
and interiorHead restraints
Head restraint position
For maximum protection, the middle
of the head restraint should be at eye
level. If this is not possible for
extremely tall persons, set to highest
position, and set to lowest position for
extremely small persons.
Height adjustment
To adjust head restraint height, press
catch, adjust height to suit then
release the catch.
Removal
Press catch. Pull up and remove the
head restraint.
Stow head restraints securely in
luggage compartment. Head restraints ..................... 3-1
Front seats ............................ 3-2
Rear seats ............................ 3-3
Seat belts .............................. 3-5
Child restraints ...................... 3-9
Airbag system ....................... 3-13
9 Warning
Only drive with head restraints
correctly adjusted.

3-2 Seats, restraints and interior
Front seats
Seat position
Adjust driver’s seat such that, with the
driver sitting upright, the steering
wheel is held in the area of its upper
spokes with the driver’s arms slightly
bent.
Slide front passenger’s seat as far
back as it will go.The seatbacks must not be tilted back
too far (recommended maximum
tilting angle approx. 25°).
Longitudinal seat
adjustment
To adjust, pull the handle on the front
seat, slide the seat and release the
handle.Ensure seat audibly latches into
position before driving.
Reclining seatbacks
To adjust, raise the release lever,
move seatback to suit seating
position and release lever to lock
seatback in position.
Do not lean on the seatback whilst
adjusting it.
9 Warning
Only drive with the seats correctly
adjusted.
9 Warning
Never adjust seats whilst driving,
as they could move
uncontrollably.

3-3Seats, restraints and interior
Adjusting seat height 3
To adjust, operate lever on side of
seat.
Lever pumping action
Rear seats
Folding rear seatbacks
The luggage compartment can be
enlarged by folding the rear
seatbacks onto the seat cushions.
Ensure front seats are not in reclined
position and push rear seat head
restraints all the way down.
When folding the rear seatbacks,
ensure the seat belts are unbuckled.Route outboard rear seat belts,
including the latch plates, through
their respective belt holders (as
illustrated), ensuring they are not
twisted at any point.
Upwards: Raises seat
Downwards: Lowers seat
9 Warning
When adjusting the rear
seatbacks, use caution; beware
of moving parts.

3-6 Seats, restraints and interior
In the event of an accident, persons
not wearing seat belts endanger their
fellow occupants and themselves.
Control indicator X for driver’s seat
belt reminder 35-9.
Seat belts are designed to be used by
only one person at a time. They are
only suitable for children aged up to
12 years or smaller than 150 cm if
used in conjunction with a child
restraint 3.
Belt force limiters
Load limiters on the front seats
reduce the impact on the seat
occupant’s body from a tensioning
belt, in the event of frontal collisions
or rear impacts of a certain severity.
The belt force is controlled, to reduce
the risk of belt-inflicted injury.
Belt tensioners
The seat belt systems on the front
seats incorporate belt tensioners
housed in the belt buckles and seat
belt retractors.
In the event of frontal collisions or
rear impacts of a certain severity, belt
buckles and seat belt retractors
tighten the seat belts; the shoulder
and lap belts are instantaneously
tightened to fit the occupant’s body
more snugly.The belt tensioners actuate only once
and must be replaced after activation.
Seek the assistance of a workshop.
„The belt tensioners only actuate
once, indicated by continuous
illumination of control indicator v in
the instrument cluster 35-9.
Deployed belt tensioners must be
replaced. Seek the assistance of a
workshop.
„Accessories not released for your
vehicle type and other objects must
not be fixed or placed within the
action zone of the belt tensioners,
as they may result in injury if the
belt tensioners are triggered.
9 Warning
Always wear your seat belt, also
in urban traffic and when you are
a rear seat passenger. It can save
your life!
9 Warning
Improper handling (e.g. removal
or installation) can activate the
belt tensioners.

3-7Seats, restraints and interior
How to wear seat belts
properly
Pull the belt out evenly from the
retractor and guide it over the
shoulder, making certain that it is not
twisted at any point. The belt must not
rest against your neck or arm.
The seatback must not be tilted back
too far (the recommended maximum
tilting angle is approx. 25°).Insert the latch plate into the buckle.
Seat belt buckles are designed such
that latch plates cannot be inserted in
the incorrect buckle.
The lap belt must not be twisted and
must fit snugly across the body.
Tension the belt frequently whilst
driving by tugging the diagonal part of
the belt.The centre rear seat belt position has
a twin buckle arrangement. Engage
the smaller latch plate (1) into the
correct buckle, then pull the belt
across and audibly engage into the
buckle marked CENTER (2).
Control indicator X for driver’s seat
belt reminder 3 5-9.
9 Warning
The belt must not rest against
hard or fragile objects in the
pockets of your clothing. Do not
place any objects (e.g. handbags)
between the belt and your body.

3-8 Seats, restraints and interior
Seat belt height adjustment
Height adjustment of front seat belt
upper anchorage points.
„Do not adjust height whilst driving.
„Pull out lock knob and slide
adjuster up or down to desired
position.
„Ensure sliding height adjuster
latches into position.
Removing the belt
To remove the belt, press the red
release button on the belt buckle; the
belt will retract automatically.
Guide the belt as it retracts, to
prevent personal injury and damage
to interior surfaces.
Seat belt use during
pregnancy
Seat belt care
Periodically inspect all parts of the
belt system for damage and to make
sure they are functioning properly.
Have damaged parts replaced. After
an accident, belts and triggered belt
tensioners must be replaced by new
ones.
Do not perform any alterations on the
belts, their anchorages, the automatic
retractors or the belt buckles.
Make sure that belts are not
damaged or trapped by sharp-edged
objects.
9 Warning
On pregnant women in particular,
the lap belt must be positioned as
low as possible across the pelvis
in order to prevent pressure on
the abdomen.