2009 OPEL AGILA brake

10-15Vehicle care
Some circuits may be protected by
several fuses.
Wheels
Tyres
Factory-fitted tyres are matched to
the chassis and offer optimum driving
comfort and safety.
Winter tyres 3
Tyres of size 165/70 R 14 and
185/60 R 15 may be used as winter
tyres.
Winter tyres improve safety at
temperatures below 7
°C and should
therefore be fitted on all the wheels.
Depending on national regulations, a
notice indicating the maximum
permissible speed for the tyres must
be affixed within the driver's field of
vision.
The maximum permissible speed
varies from country to country on
account of national regulations.
Ensure that winter tyres are inflated
to the correct pressure specified by
the tyre manufacturer. No. Circuit
1Starter motor
2Air conditioning compressor
3Fuel pump
4Fuel injection
5Heater fan
6Radiator fan
7Power steering control
module
8ABS, ESP
9ABS, ESP
10Brake lamp switch
11Headlamp (right)
12Headlamp (left)
13Front fog lamps
14Ignition switch
15Ignition switch, power
windows, wipers, starter No. Circuit

10-22 Vehicle care
Wheel changing
In order to reduce the chance of
possible injuries, make the following
preparations and note the procedure:
„Park on a level, firm and non-
slippery surface.
„Switch on hazard warning lamps
and apply parking brake. Engage
reverse gear (automatic
transmission 3 in P).
„Take the spare wheel from under
the luggage compartment floor
cover 3 10-24.
„Before raising the vehicle, turn front
wheels to straight-ahead position.
„Never change more than one
wheel at a time.
„Block wheel diagonally opposite
the wheel to be changed, by
placing wedge blocks or equivalent
in front and behind the wheel.
„Use jack only when changing
wheels.
„If the ground on which the vehicle is
parked is soft, a solid board (max.
1 cm thick) should be placed under the jack. Using a thicker board
could lead to damage of the jack
and the vehicle.
„Do not raise the vehicle more than
is necessary to change a wheel.
„No people or animals may be in the
vehicle when it is jacked-up.
„Never start or run the engine or
crawl under a jacked-up vehicle.
„Before screwing on the wheel bolts
when changing a wheel, apply a
light coating of grease to the cone
of each wheel bolt.
1. Prise off the wheel cover 3.
2. Slacken the wheel bolts by one
turn each using the wheel bolt
wrench, putting the wrench on
as far as possible.
3. The location of front and rear
jacking bars may be indicated
by notches on the bottom edge
of the vehicle, under the doors.

10-26 Vehicle care
Rotate jack shaft anti-clockwise and
remove jack from storage bracket.
To stow the jack after use, place it in
its storage bracket and turn jack shaft
clockwise until jack is held securely in
place.Jump starting 3
Do not start with quick charger, to
prevent damage to electronic
components.
Never expose the battery to naked
flames or sparks.
„A discharged battery can freeze at
temperatures of 0 °C. Defrost the
battery in a warm room before
connecting the jump leads.
„Do not allow battery fluid to contact
eyes, skin, fabrics or painted
surfaces. The fluid contains
sulphuric acid which can cause
injuries and damage in the event of
direct contact.„Wear eye protection and protective
clothing when handling a battery.
„Use auxiliary battery with same
voltage (12 volts). Its capacity (Ah)
must not be considerably less than
that of the discharged battery.
Voltage and capacity information
can be found on the batteries.
„Use jump leads with insulated
terminals and a width of at least
16 mm
2 (25 mm2 for diesel
engines).
„Do not disconnect the discharged
battery from the vehicle.
„Switch off all unnecessary
electrical consumers. Infotainment
system may be damaged if
switched on while jump starting.
„Do not lean over the battery during
jump starting procedure.
„Do not allow the terminals of one
lead to touch those of the other
lead.
„The vehicles should not touch while
jump starting.
„Apply parking brake.
9 Warning
This must be done with extreme
care. Any deviation from the
following instructions could lead
to personal injury or damage
resulting from battery explosion,
as well as to damage to the
electrical systems in both
vehicles.

10-28 Vehicle care
Towing
Towing the vehicle
Towing from the front is permissible
in emergency situations only.
For fixing of the front towing eye,
remove the towing eye socket cover
by pressing the lower part of the
cover.
The towing eye attachment is stored
below the spare wheel in the luggage
compartment 3 10-25.Screw in towing eye attachment
clockwise until it is firmly in place. If
necessary, use jack handle to tighten.
Attach a tow rope 3 - or better still a
tow rod 3 - to the front towing eye.
The front towing eye must only be
used for towing and not recovering
the vehicle.
Switch on the ignition (3 9-1) to
release the steering column lock and
to permit operation of the brake
lamps and windscreen wipers.
Manual transmission in neutral,
automatic transmission 3 in N.More brake pedal pressure is
necessary when braking since the
brake servo unit is operative only
when the engine is running.
Considerably greater steering force is
necessary since this unit is operative
only when the engine is running.
To prevent entry of exhaust fumes
from towing vehicle, switch on air
recirculation mode (3 8-3) and close
the windows.
Do not tow the vehicle with a tow
rope3 or tow rod 3 for extended
periods, to avoid causing damage to
the vehicle. Only tow in this manner
on hard-surfaced roads.
Vehicles with manual or automatic
transmission3 can be towed from
the front, provided the front axle is
raised off the ground and the parking
brake is released.
Caution
Drive slowly and avoid jerky
movements. Impermissible tractive
forces could damage the vehicles.

10-29Vehicle care
Vehicles with manual transmission
can also be towed from the front with
all four wheels on the ground. In this
case, the gearshift lever must be in
neutral with the parking brake
released and the key in ignition
switch position ACC, to permit
release of the steering column lock
before towing.
Seek the assistance of a workshop.
After towing, unscrew the towing eye
attachment anti-clockwise and refit
the cover.Towing another vehicleInterior care
Interior and upholstery
Clean the vehicle interior regularly,
including the instrument panel facia,
using Interior/Upholstery Cleaner.
Clean fabric upholstery with a
vacuum cleaner and brush. To
remove stains, use a cleaner that is
suitable for both fabrics and vinyl.
Clean seat belts only with lukewarm
water or Interior/Upholstery Cleaner.
Caution
Never tow the vehicle with the front
wheels on the ground, to avoid
causing damage to the automatic
transmission 3.
Caution
The rear lashing eye is designed for
shipping purposes only.
Towing another vehicle from the
rear is not permitted!
Caution
Open Velcro fasteners on clothing
could damage seat upholstery.
Make sure that Velcro fasteners are
closed.

10-32 Vehicle care
On vehicles which are washed
frequently in automatic car washes
with underbody washing facility, the
protective wax coating may be
impaired by dirt-dissolving additives.
Check the underbody after washing
and have it waxed if necessary.
Before the start of the cold weather
season, check the PVC coating and
protective wax coating and, if
necessary, have them restored to
perfect condition.
The underbody should be washed
following the end of the cold weather
season to remove any dirt adhering to
the underbody since this may also
contain salt. Check protective wax
coating and, if necessary, have it
restored to perfect condition.
Engine compartment
Areas of the engine compartment that
are painted in the same colour as the
vehicle must be looked after like any
other painted surface.
It is advisable to wash the engine
compartment before and after winter
and preserve it with wax. Cover alternator and fluid reservoirs with
plastic sheets before washing the
engine.
When washing the engine with a
steam-jet cleaner, do not direct the
steam-jet at components of the
Anti-lock Brake System (ABS), the air
conditioning system 3 or the belt
drive and its components.
Protective wax that has been applied
is also removed during the engine
wash. For this reason, have the
engine, brake system components in
the engine compartment, axle
components with steering, body parts
and cavities thoroughly preserved
with protective wax after the wash.
An engine wash can be performed in
the spring in order to remove dirt that
has adhered to the engine
compartment, which may also have a
high salt content. Check protective
wax layer and make good if
necessary.

11-2 Service and maintenance
Service schedule
⊕Additional operations.o Under extreme operating conditions and if required by country-specific conditions, the intervals are reduced.
Service operations by year 1)
km ( x 1000)1)
miles ( x 1000)1)
1)Whichever occurs first.
1
15
102
30
203
45
304
60
405
75
506
90
60
Controls, lighting, signalling equipment and airbags: visual checkxxxxxx
Remote control batteries: replace every 2 years
Windscreen wipers, windscreen washer system: check, correctxxxxxx
Coolant level and antifreeze: check, correct
Hoses: check for tightness and secure seatingxxxxxx
Coolant: change every 3 years/45,000 km/30,000 miles
Brake fluid level: check, correct x x x
Battery terminals: check for secure connections and battery eyexxxxxx
Pollen filter: replace x x x
oMore often for when dust, sand or pollen is in the air agreement with customer
oAir cleaner element: inspect - petrol engines only xxxxxx
Air cleaner element: replace - petrol and diesel engines x x
⊕Spark plugs: replace every 7 years/105,000 km/70,000 miles

11-3 Service and maintenance
Service operations by year 1)
km ( x 1000)1)
miles ( x 1000)1)
1)Whichever occurs first.⊕Additional operations.o Under extreme operating conditions and if required by country-specific conditions, the intervals are reduced.
1
15
102
30
203
45
304
60
405
75
506
90
60
Ribbed V-belt: visual check - petrol engines only x x
⊕ Replace every 6 years/90,000 km/60,000 miles
Ribbed V-belt and tensioner: visual check - diesel engines only x x x
⊕ Replace every 10 years/150,000 km/100,000 miles
⊕Valve clearances: check, adjust - petrol engines only x x x
Engine oil and oil filter: replace x x x x x x
oDiesel fuel filter: drain water x x x x x x
Diesel fuel filter: replace and bleed x x x
⊕Manual transmission: oil level check, correct x
Oil changexx
Parking brake cable: check, adjust x
Parking brake: check and adjust
Wheel mounting and suspension front and rear, brake lines, brake
pressure hoses, fuel lines, fuel tank and exhaust system: visual checkxxx
Corrosion protection: check and record in Service and Warranty Booklet annually
Front and rear wheel brakes: check visually x x x x x x