2009 NISSAN GT-R brake

Black plate (102,1)
Model "R35-D" EDITED: 2008/ 5/ 20
AUDIBLE REMINDERS
Key reminder chimeA chime will sound if the driver side door is
opened while the ignition switch is pushed to
the ACC position or pushed to the OFF or
LOCK position with the Intelligent Key left in the
Intelligent Key port. Make sure the ignition
switch is pushed to the OFF position, and take
the Intelligent Key with you when leaving the
vehicle.Light reminder chimeA chime will sound when the driver side door is
opened with the light switch in the
or
position and the ignition switch in the ACC, OFF
or LOCK position.
Turn the light switch off when you leave the
vehicle.Parking brake reminder chimeA chime will sound if the vehicle speed is above
4 MPH (7 km/h) with the parking brake applied.
Stop the vehicle and release the parking brake.Brake pad wear warningThe disc brake pads have audible wear warn-
ings. When a brake pad requires replacement, it
will make a high pitched scraping sound when
the vehicle is in motion. This scraping sound will
first occur only when the brake pedal is
depressed. After the wear of the brake pad is
increased, the sound will be heard all the timeeven if the brake pedal is not depressed. Have
the brakes checked as soon as possible if the
warning sound is heard.2-30
Instruments and controls
,QIRUPDWLRQ3URYLGHGE\

Black plate (106,1)
Model "R35-D" EDITED: 2008/ 5/ 20
PARKING BRAKE RELEASE WARN-
INGThis will appear if the vehicle speed is above 4
MPH (7 km/h) with the parking brake applied.
(
“Brake warning light” page 2-24)
(“Parking brake reminder chime” page 2-
30)
LOW BRAKE FLUID WARNINGThis will appear if the brake fluid level becomes
low. (
“Brake warning light” page 2-24)
ANTI-LOCK BRAKING SYSTEM
(ABS) WARNINGThis will appear if the Anti-lock Braking System
(ABS) is not functioning properly. (
“Anti-
lock Braking System (ABS) warning light” page
2-24) (
“Brake warning light” page 2-24)
2-34
Instruments and controls
,QIRUPDWLRQ3URYLGHGE\

Black plate (112,1)
Model "R35-D" EDITED: 2008/ 5/ 20
ENGINE START OPERATION INDI-
CATORThis indicator appears when the shift lever is in
the
&Pposition.
This indicator means that the engine will start by
pushing the ignition switch with the brake pedal
depressed.
SHIFT “P” WARNINGThis warning appears and an inside warning
chime sounds when the ignition switch is
pushed to stop the engine with the shift lever
in any position except the
&Pposition.
If this warning appears, move the shift lever to
the
&Pposition. This warning will also turn off
when pushing the ignition switch to the ON
position.
“PUSH” WARNINGThis warning appears when the shift lever is
moved to the
&Pposition with the ignition switch
in the ACC position after the SHIFT
&Pwarning
appears.
If this warning appears, push the ignition switch
to the OFF position.
2-40
Instruments and controls
,QIRUPDWLRQ3URYLGHGE\

Black plate (121,1)
Model "R35-D" EDITED: 2008/ 5/ 20
position when you leave the vehicle
for extended periods of time, other-
wise the battery will be discharged.
. Never leave the light switch on
when the engine is not running for
extended periods of time even if the
headlights turn off automatically.
Daytime running light system (Ca-
nada only)The daytime running lights automatically illumi-
nate when the engine is started with the parking
brake released. The daytime running lights
operate with the headlight switch in the OFF
position. Turn the headlight switch to theposition for full illumination when driving at night.
If the parking brake is applied before the engine
is started, the daytime running lights do not
illuminate. The daytime running lights illuminate
once the parking brake is released. The daytime
running lights will remain on until the ignition
switch is pushed to the OFF position.
WARNING
When the daytime running light system
is active, tail lights on your vehicle are
not on. It is necessary at dusk to turn on
your headlights. Failure to do so could
cause an accident injuring yourself and
others.
Turn signalMove the lever up or down to the position
*1
to
signal the turning direction. When the turn is
completed, the turn signals cancel automatically.
Lane change signalTo indicate a lane change, move the lever up or
down to the position
*2
where the lights begin
flashing.
Instruments and controls
2-49
,QIRUPDWLRQ3URYLGHGE\

Black plate (19,1)
5 Starting and driving
Model "R35-D" EDITED: 2008/ 5/ 20
Precautions when starting and driving..................... 5-2
Exhaust gas (Carbon monoxide) ........................ 5-2
Three-way catalyst .......................................... 5-2
Tire Pressure Monitoring System (TPMS) ............. 5-3
Avoiding collision and rollover ........................... 5-5
Off-road recovery ........................................... 5-6
Rapid air pressure loss .................................... 5-6
Drinking alcohol/drugs and driving ...................... 5-7
All-Wheel Drive (AWD) driving safety
precautions ................................................... 5-7
Push-button ignition switch .................................. 5-8
Operating range for engine start ........................ 5-8
Ignition switch operation .................................. 5-8
Ignition switch positions ................................... 5-9
Intelligent Key battery discharge ...................... 5-10
Before starting the engine .................................. 5-11
Starting the engine ........................................... 5-11
Driving the vehicle ............................................ 5-13
Dual clutch transmission ................................ 5-13
Driving tips ................................................. 5-19
VDC, transmission and suspension setup
switches ........................................................ 5-21
How to switch the modes .............................. 5-22
Features of each mode .................................. 5-23
Turbocharger system ......................................... 5-26
Parking brake .................................................. 5-27 Cruise control
................................................. 5-28
Precautions on cruise control .......................... 5-28
Steering-wheel-mounted controls ..................... 5-29
Indicators and display ................................... 5-29
Cruise control operations ............................... 5-29
Hill Start Assist ................................................ 5-31
Break-in schedule ............................................ 5-32
Increasing fuel economy .................................... 5-33
All-Wheel Drive (AWD) ..................................... 5-34
AWD warning light ....................................... 5-34
Tight corner braking phenomenon .................... 5-35
Tires ......................................................... 5-35
AWD system characteristics ........................... 5-35
Limited Slip Differential (LSD) ............................. 5-36
Parking/parking on hills ...................................... 5-37
Power steering ................................................ 5-38
Brake system .................................................. 5-38
Braking precautions ...................................... 5-38
Parking brake break-in ................................... 5-39
Brake assist .................................................... 5-39
Anti-lock Braking System (ABS) ...................... 5-39
Vehicle Dynamic Control (VDC) system ................. 5-40
Cold weather driving ......................................... 5-42
Freeing a frozen door lock .............................. 5-42
Anti-freeze .................................................. 5-42
Battery ...................................................... 5-42
,QIRUPDWLRQ3URYLGHGE\

Black plate (176,1)
Model "R35-D" EDITED: 2008/ 5/ 20
significantly more likely to be injured or
killed than a person properly wearing a
seat belt.OFF-ROAD RECOVERYWhile driving, the right side or left side wheels
may unintentionally leave the road surface. If this
occurs, maintain control of the vehicle by
following the procedure below. Please note that
this procedure is only a general guide. The
vehicle must be driven as appropriate based on
the conditions of the vehicle, road and traffic.
1. Remain calm and do not overreact.
2. Do not apply the brakes.
3. Maintain a firm grip on the steering wheelwith both hands and try to hold a straight
course.
4. When appropriate, slowly release the accel- erator pedal to gradually slow the vehicle.
5. If there is nothing in the way, steer the vehicle to follow the road while the vehicle
speed is reduced. Do not attempt to drive
the vehicle back onto the road surface until
vehicle speed is reduced.
6. When it is safe to do so, gradually turn the steering wheel until both tires return to the
road surface. When all tires are on the road
surface, steer the vehicle to stay in the
appropriate driving lane. .
If you decide that it is not safe to return
the vehicle to the road surface based on
vehicle, road or traffic conditions, gra-
dually slow the vehicle to a stop in a safe
place off the road.
RAPID AIR PRESSURE LOSSRapid air pressure loss or a “blow-out” can
occur if the tire is punctured or is damaged due
to hitting a curb or pothole. Rapid air pressure
loss can also be caused by driving on under-
inflated tires.
Rapid air pressure loss can affect the handling
and stability of the vehicle, especially at highway
speeds.
Help prevent rapid air pressure loss by main-
taining the correct air pressure and visually
inspect the tires for wear and damage.
(
“WHEELS AND TIRES” page 8-29)
If a tire rapidly loses air pressure or “blows-out”
while driving maintain control of the vehicle by
following the procedure below. Please note that
this procedure is only a general guide. The
vehicle must be driven as appropriate based on
the conditions of the vehicle, road and traffic.
WARNING
The following actions can increase the
chance of losing control of the vehicle if there is a sudden loss of tire air
pressure. Losing control of the vehicle
may cause a collision and result in
personal injury.
.
The vehicle generally moves or pulls
in the direction of the flat tire.
. Do not rapidly apply the brakes.
. Do not rapidly release the accelera-
tor pedal.
. Do not rapidly turn the steering
wheel.
1. Remain calm and do not overreact.
2. Maintain a firm grip on the steering wheel with both hands and try to hold a straight
course.
3. When appropriate, slowly release the accel- erator pedal to gradually slow the vehicle.
4. Gradually steer the vehicle to a safe location off the road and away from traffic if possible.
5. Lightly apply the brake pedal to gradually stop the vehicle.
6. Turn on the hazard warning flashers and contact a roadside emergency service to
change the tire.
5-6
Starting and driving
,QIRUPDWLRQ3URYLGHGE\

Black plate (178,1)
Model "R35-D" EDITED: 2008/ 5/ 20
WARNING
Do not operate the push-button ignition
switch while driving the vehicle except
in an emergency. (The engine will stop
when the ignition switch is pushed
three consecutive times or the ignition
switch is pushed and held for more than
2 seconds.) If the engine stops while
the vehicle is being driven, this could
lead to a crash and serious injury.
Before operating the push-button ignition
switch, be sure to move the shift lever to the&Pposition.
OPERATING RANGE FOR ENGINE
STARTThe operating range for starting the engine
inside the vehicle is shown in the illustration.
. If the Intelligent Key is on the instrument
panel, rear parcel shelf, inside the glove box
or door pocket, or the corner of interior
compartment, it may not be possible to start
the engine.
. If the Intelligent Key is near the door or door
glass outside the vehicle, it may be possible
to start the engine.
IGNITION SWITCH OPERATIONWhen the Intelligent Key is carried with you and
the ignition switch is pushed without depressing
the brake pedal, the ignition switch position will
change as follows:
.Push center once to change to ACC.
. Push center two times to change to ON.
. Push center three times to change to OFF.
(No position illuminates.)
. Push center four times to return to ACC.
. Open or close any door to return to LOCK
during the OFF position.
5-8
Starting and driving
PUSH-BUTTON IGNITION SWITCH
,QIRUPDWLRQ3URYLGHGE\

Black plate (181,1)
Model "R35-D" EDITED: 2008/ 5/ 20
.The Intelligent Key port does not
charge the Intelligent Key battery. If
you see the low battery indicator in the
vehicle information display, replace the
battery as soon as possible.
(
“INTELLIGENT KEY BATTERY RE-
PLACEMENT” page 8-23)
. Make sure the area around the vehicle is
clear.
. Check fluid levels such as engine oil, cool-
ant, brake fluid and window washer fluid as
frequently as possible, or at least whenever
you refuel.
. Check that all windows and lights are clean.
. Visually inspect tires for their appearance
and condition. Also check tires for proper
inflation.
. Lock all doors.
. Position seat and adjust head restraints.
. Adjust inside and outside mirrors.
. Fasten seat belts and ask all passengers to
do likewise.
. Check the operation of warning lights when
the ignition switch is pushed to the ON
position. (
“WARNING/INDICATOR
LIGHTS AND AUDIBLE REMINDERS”
page 2-23)
NOTE:. This vehicle includes spark plugs that
are designed for maximum perfor-
mance. If the start time becomes long-
er, the plugs may be fouled, making the
engine difficult to start. If this occurs,
start the engine using the procedure
described in this section.
. A click sound may be heard when the
brake pedal is depressed and released.
This is normal.
. A low rattling operating sound may
occur when the engine is started or
stopped. This does not indicate that
there is a malfunction. This sound is
likely to occur in particular if the engine
is stopped when the temperature of the
transmission oil is high.
Starting and driving
5-11
BEFORE STARTING THE ENGINE STARTING THE ENGINE
,QIRUPDWLRQ3URYLGHGE\