2009 MERCEDES-BENZ SLR change wheel

Contents
Introduction....................................... 12
Product information ............................. 13
Operator’s Manual ............................... 14
Service and warranty information .. 14
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles .......... 15
Maintenance .................................. 16
Roadside Assistance ...................... 16
Change of address or ownership.... 16
Operating your vehicle outside the USA
or Canada ...................................... 17
Mercedes-Benz SLR McLaren
compliance .................................... 17
Where to find it .................................... 18
Symbols ............................................... 19
Operating safety .................................. 20
Proper use of the vehicle ............... 20
Problems with your vehicle .................. 21
Reporting safety defects...................... 22
Reporting safety defects ................ 22
Vehicle data recording......................... 23
Information regarding electronic
recording devices........................... 23
At a glance.......................................... 24
Cockpit ................................................. 26
Instrument cluster ................................ 28
Multifunction steering wheel ................ 30
Center console ..................................... 31
Upper part ...................................... 31
Lower part ...................................... 32
Overhead control panel ........................ 33
Control panel on the door sill ............... 34Getting started................................... 36
Unlocking ............................................. 38
Starter switch positions .................. 40
Adjusting .............................................. 41
Seats............................................... 41
Steering wheel ................................ 42
Mirrors ............................................ 43
Driving .................................................. 45
Fastening the seat belts.................. 45
Starting the engine ......................... 47
Parking brake.................................. 49
Driving off ....................................... 50
Switching on headlamps ................. 51
Turn signals .................................... 51Windshield wipers ........................... 52
Problems while driving.................... 54
Parking and locking .............................. 55
Parking brake ................................. 55
Switching off headlamps................. 56
Turning off the engine ..................... 56
Releasing seat belts........................ 56
Locking ........................................... 57
Safety and Security........................... 58
Occupant safety ................................... 60
Air bags .......................................... 62
Occupant Classification System ..... 67
Seat belts ....................................... 72
Children in the vehicle .................... 76
Panic alarm .......................................... 81
Activating........................................ 81
Deactivating.................................... 81
Driving safety systems ......................... 82
ABS ................................................. 82
BAS ................................................. 84
ESP® .............................................. 84
Electro-hydraulic brake system....... 87
Performance enhancement system ...... 90
Airbrake .......................................... 90

ContentsAnti-theft systems................................ 93
Immobilizer..................................... 93
Anti-theft alarm system .................. 93
Tow-away alarm ............................. 95Controls in detail............................... 96
Locking and unlocking ......................... 98
SmartKey ....................................... 98
Opening the doors........................ 101
Opening the trunk ........................ 102
Closing the trunk lid ..................... 103
Trunk emergency release ............. 104
Automatic locking ........................ 104
Locking and unlocking from the inside
105
Lighting .............................................. 106
Exterior lamp switch ..................... 106
Combination switch...................... 110
Hazard warning flasher................. 111
Interior lighting ............................. 112
Courtesy lighting .......................... 113
Trunk lamp ................................... 113
Instrument cluster ............................. 114
Adjusting instrument cluster
illumination................................... 114Coolant temperature gauge ......... 115
Resetting trip odometer ............... 115
Tachometer .................................. 116
Outside temperature indicator ..... 116
Control system .................................. 117
Multifunction display .................... 117
Multifunction steering wheel ........ 118
Menus .......................................... 120
Standard display menu ................ 122
722 S menu ................................. 123
AUDIO menu ................................ 127
Vehicle status message memory menu
128
Settings menu .............................. 129
Trip computer menu ..................... 139
TEL menu ..................................... 141
Audio system ..................................... 145
Audio and telephone, operation ... 145
Operating safety........................... 145
Location of the audio system ....... 145
Operating and display elements ... 146
Button and soft key operation ...... 148
Operation ..................................... 148
Radio operation ............................ 151
Cassette operation....................... 154
CD changer operation .................. 158Telephone operation .................... 162
Automatic transmission ..................... 169
Gear selector lever....................... 169
Shifting procedure ....................... 170
Gear selector lever positions ....... 171
Driving tips................................... 173
Gear ranges ................................. 174
Shift program mode selector switch ....
175
Gear selector lever one-touch
gearshifting .................................. 175
Steering wheel gearshift control
one-touch gearshifting ................. 177
Manual shift program ................... 178
Emergency operation
(Limp-Home Mode) ...................... 180
Good visibility .................................... 181
Headlamp cleaning system .......... 181
Rear view mirrors ......................... 181
Sun visors .................................... 182
Rear window defroster ................. 183
Automatic climate control ................. 184
Deactivating the automatic climate
control system ............................. 188
Operating the automatic climate
control system in automatic mode 188

51 Getting started
Driving
Switching on headlamps
Low-beam headlamps
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.Exterior lamp switch1Off
2Low-beam headlamps on
Turn the exterior lamp switch to
positionB.
The low-beam headlamps come on.High beam
The combination switch is located on the
left of the steering column.
Combination switch1High beam
2High-beam flasher
Push combination switch in direction of
arrow1.
The high-beam headlamps and
high-beam headlamp indicator
lampA in the instrument cluster
come on (
page 29).
For more information on headlamps, see
“Lighting” (
page 106).
Turn signals
The combination switch is located on the
left of the steering column.Combination switch1Turn signals, right
2Turn signals, left
Press the combination switch up 1 or
down 2.
The corresponding turn signal indicator
lampL orK in the instrument
cluster flashes (
page 29).
The combination switch resets automati-
cally after major directional changes.

64 Safety and SecurityOccupant safety
Safety guidelines for the seat belt,
Emergency Tensioning Device (ETD)
and air bag
i
Air bags are designed to activate only in cer-
tain frontal impacts (front air bags, knee air
bags) and side impacts (head-thorax air bags)
which exceed preset thresholds. Only during
these types of impacts will they provide their
supplemental protection.
The driver and passenger should always wear
their seat belts. Otherwise it is not possible for
the air bags to provide their supplemental
protection.
In cases of other types of impacts and impacts
below air bag deployment thresholds, air bags
will not deploy. The driver and passenger will
then be protected to the extent possible by a
properly fastened seat belt. A properly fastened
seat belt is also needed to provide the best pos-
sible protection in a rollover.
We caution you not to rely on the presence of the
air bags in order to avoid wearing your seat belt.
It is important to your safety and that of your pas-
senger that you replace deployed air bags and
repair any malfunctioning air bags to ensure that
the vehicle will continue to provide supplemental
crash protection for occupants.
Warning!
G


Damaged seat belts or seat belts that
were highly stressed in an accident
must be replaced and their anchoring
points must also be checked. Only use
seat belts installed or supplied by an
authorized Mercedes-Benz Center.


Air bags and ETDs are designed to func-
tion on a one-time-only basis. An air bag
or ETD that was activated must be
replaced.


Air bags and ETDs contain perchlorate
material, which may require special han-
dling and regard for the environment.
Check with your local government’s dis-
posal guidelines. California residents,
see www.dtsc.ca.gov/Hazardous-
Waste/Perchlorate/index.cfm.


Do not pass seat belts over sharp edges.
They could tear.


Do not make any modification that could
change the effectiveness of the seat
belts.


Do not bleach or dye seat belts as this
may severely weaken them. In a crash,
they may not be able to provide
adequate protection.


No modifications of any kind may be
made to any components or wiring of
the SRS. This includes changing or
removing any component or part of the
SRS, the installation of additional trim
material, badges, etc. over the steering
wheel hub, passenger front air bag cov-
er, door frame trims, or door trim pan-
els, and installation of additional
electrical/electronic equipment on or
near SRS components and wiring. Keep
area between air bags and occupants
free from objects (e.g. packages,
purses, umbrellas, etc.).


Air bag system components will be hot
after an air bag has inflated. Do not
touch.

117 Controls in detail
Control system
Control system
The control system is activated as soon as
the SmartKey in the starter switch is
turned to position1. The control system
enables you to call up information about
your vehicle and to change vehicle
settings.
For example, you can use the control sys-
tem to find out when your vehicle is next
due for service, to set the language for
messages in the instrument cluster
display, and much more.
The control system relays information to
the multifunction display.
Multifunction display
The multifunction display consists of the
display fields in the speedometer and the
tachometer. In its default state, the left
display field shows the outside tempera-
ture and main odometer, while the trip
odometer and the clock appears in the
right display field. This default setting is
referred to as the standard display.Standard display1Main odometer
2Outside temperature or speed
3Current gear selector lever
position/gear range
4Trip odometer
5Automatic transmission shift program
mode
6Clock
Warning!
G
A driver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
For your safety and the safety of others, se-
lecting features through the multifunction
steering wheel should only be done by the
driver when traffic and road conditions
permit it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.

173 Controls in detail
Automatic transmission
Driving tips
Accelerator position
Your driving style influences the
transmission’s shifting behavior:
Less throttle Earlier upshifting
More throttle Later upshifting
Kickdown
Use kickdown when you want maximum
acceleration.
Press the accelerator past the point of
resistance.
Depending on the engine speed the
transmission shifts into a lower gear.

Ease on the accelerator when you have
reached the desired speed.
The transmission shifts up again.Stopping
When you stop briefly, e.g. at traffic lights:

Leave the transmission in gear.

Hold the vehicle with the brake.
When you stop longer with the engine
idling and/or on a hill:

Set the parking brake.

Move the gear selector lever to park
positionP.Maneuvering
When you maneuver in tight areas,
e.g. when pulling into a parking space:

Control the vehicle speed by gradually
releasing the brakes.

Accelerate gently.

Never abruptly step on the accelerator.
Working on the vehicle
i
Kickdown in manual shift program MAN is
not possible.
In kickdown operation, it is not possible to
change gear with the steering wheel gear shift
paddles.
Warning!
G
When working on the vehicle, set the
parking brake and move gear selector lever
to positionP. Otherwise the vehicle could
roll away.

175 Controls in detail
Automatic transmission
Shift program mode selector switch
1Program mode selector switch
C Comfort For comfort driving
MAN Manual For manual gear shifting
(
page 178)
S Sport For standard driving
The selected shift program appears in the
right multifunction display (
page 117).

Turn the program mode selector switch
to the desired setting.
The letter of the desired shift program
appears in the right multifunction
display.
Select C for comfort driving:

The vehicle starts out in second
gear for gentler starts. This does
not apply if full throttle is applied or
gear range1 is selected.


Traction and driving stability are
improved on icy roads.


Upshifts occur earlier even when
you give more gas. The engine then
operates at lower rpms and the
wheels are less likely to spin.Gear selector lever one-touch
gearshifting
With the gear selector lever in drive posi-
tion D and driving in shift programC orS,
you can limit or extend the gear range.
With the MAN shift program activated, you
can use the gear selector lever to manually
shift the gears.
The following instructions describe opera-
tion of the gear selector lever when driving
in the shift programC orS.
!
Never change the program when the gear
selector lever is out of park positionP. This could
result in a change of driving characteristics for
which you may not be prepared.
i
For information on using the gear selector
lever in shift program MAN, see “Manual shift
program” (
page 178).
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached.
Shift into reverse gearR or park positionP only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.

178 Controls in detailAutomatic transmissionExtending gear range
Briefly pull right shift paddle2.
The transmission will shift to the next
higher gear as permitted by the shift
program. This action simultaneously
extends the gear range of the
transmission.
Canceling gear range limit

Pull and hold right shift paddle2
until
D reappears in the right multi-
function display.
The transmission will shift from the
current gear range directly to gear
rangeD.Shifting into optimal gear range

Pull and hold left shift paddle1.
The transmission will automatically se-
lect the gear range suited for optimal
acceleration and deceleration. This
may involve shifting down one or more
gears.
Manual shift program
In addition to the shift programC orS,
your vehicle is equipped with the
MANshift program.
In the manual shift programMAN,
system-controlled automatic gearshifting
is switched off and you need to change the
gears by manually upshifting or downshift-
ing using the steering wheel gearshift pad-
dles (
page 177) or the gear selector
lever (page 175).
i
To avoid overrevving the engine when down-
shifting, the transmission will not shift to a lower
gear if the engine’s max. speed would be
exceeded.
i
If you press on the accelerator when the en-
gine has reached its rpm limit, the transmission
will upshift beyond any gear range limit selected.
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached.
Shift into reverse gearR or park positionP only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.
i
Using the kickdown when driving in shift
program MAN is not possible.