Retrofitting of two-wa
yradio sand
mobil ephones (RF transmitter)
Use the Technica lSpecification
ISO/T S21609 44
implementation regulation
when retrofitting RF (radi ofrequency) trans-
mitters.
If your vehicl ehasfittings for two-way radio
equipment (e.g. taxis, hir ecars or officia lvehi-
cles), us ethe power supply or aeria lconnec-
tions intended for us ewitht he basic wiring.
Be sure to observe the manufacturer' saddi-
tiona linstructions when installing the fittings.
! Damage resulting from installation work
that ha snot bee ncarrie doutcorrectly is
not covered by the Mercedes-Benz implied
warranty.
To ensure proper installation, Mercedes-
Benz recommend shaving this work done
at aM ercedes-Benz Service Centre or at a
qualified specialist workshop.
Transmission output Transmission outpu
tatthe aeria lbasem ust
not excee dthe maximum value sbelow. Waveband Maximum trans-
missio
noutput
(PEAK) Short wave
(f <54M Hz) 100 W
4mw
aveband 30 W
2mw
aveband 50 W
Trunked radio/Tetra 35 W
70 cm waveband 35 W
GSM 900/AMPS 10 W
GSM 1800 10 W
UMTS 10 W Aerial positions
The following aeria
lpositions may be used if
RF transmitters have bee nproperly installed: Aerial positions, Coupé
0046
Front roo farea( vehicle swithp anorama
sliding sunroof*: this are aisnot author-
ise dfor use)
0047 Rear roo farea( vehicle swithp anorama
sliding sunroof*: this are aisnot author-
ise dfor use)
008A Rear mudguard (recommended installa-
tion position: on the sid ewhich face sthe
centre of the road)
0088 Boot lid Aerial positions, Cabriolet
0046
Rear mudguard (recommended installa-
tion position: on the sid ewhich face sthe
centre of the road)
44 ISO/T S21609 –Technica lSpecification for Road Vehicles -- (EMC )guideli nesfor installation of aftermarket
radio frequency transmitting equipment. Vehicl
eelect ronics
285Technical data
*optional
207_AKB; 2; 3, en-GB
mkalafa
,V ersion: 2.11.8.1
2009-07-23T10:23:49+02:00
-Seite 285 Z
