2009 Hyundai Getz warning

FEATURES OF YOUR HYUNDAI 1- 11
!
!
HTB064-D
(1)
HTB066-D
In order to prevent operation of the passenger front and rear windows, a window lock switch is provided on thearmrest of the driver's door. To disable the power windows, press the window lock switch.To revert to normal operation, press the window lock switch a second time. Auto-Down Window (Driver's Side) The Auto-Down window is moved to its fully open position by pushing the switch. To stop at the desired positionpush the switch again.
B060A01E-AAT POWER WINDOWS (If Installed)
The power windows operate when the ignition key is in the "ON" position. The main switches are located on thedriver's armrest and control the front and rear windows on both sides of the vehicle. The windows may be openedby depressing the appropriate window switch and closed by pulling up the switch. To open the window on thedriver's side, press the switch(1) down. The window moves as long as the switch is operated. B080A02FC-GAT ADJUSTABLE SEATSWARNING:
1) Be careful that someone's head, hands and body are not trapped by a closing window.
2) Never try to operate the main switch on the driver's door andthe individual door window switch in opposing directions atthe same time. If this is done, the window will stop and cannot be opened or closed.
3) Do not leave children alone in the car. Always remove the ignitionkey for their safety.
WARNING:
Never attempt to adjust the seatwhile the vehicle is in motion. This could result in loss of control, or an accident which may cause death,serious injury, or property damage.

1- 12 FEATURES OF YOUR HYUNDAI
To recline the seatback, lean forward to take your weight off it, then pull up on the recliner control lever at the outsideedge of the seat. Now lean back until the desired seatback angle is achieved. To lock the seatback into position,release the recliner control lever. WARNING:
To minimise risk of severe injury inthe event of a collision or a sudden stop, both the driver and passen- ger seatbacks should always be inan upright position while the ve- hicle is in motion. The protection provided by the seat belts andairbags may be reduced significant- ly when the seatbacks are reclined. There is greater risk that the driverand passenger will slide under the seat belt which may result in seri- ous injury if a crash occurs whenthe seatbacks are reclined. The seat belt cannot provide full protection to an occupant if the seat back isreclined.
HTB026-D
B080C01A-AAT Adjusting Seatback Angle
!
B080B01FC-GAT FRONT SEATS Adjusting Seat Forward andRearward
HTB024-D
!
To move the seat toward the front or rear, pull the lock release lever upward. This will release the seat on its track so you can move it forward or rearward to the desired position. When you find the position you want, release the lever and slide the seat forward or rearward on its track until it locks into the desired posi- tion and cannot be moved further.WARNING:
To ensure the seat is locked securely, attempt to move the seat forward or rearward without using the lock re- lease lever.

FEATURES OF YOUR HYUNDAI 1- 13
HFC2028
Lock knob
!WARNING:
B080D03JM-GAT Adjustable Headrests
Headrests are designed to help reduce the risk of neck injuries. To raise the headrest, pull it up. Tolower it, push it down while pressing the lock knob. To remove the head- rest, raise it as far as it can go thenpress the lock knob while pulling up- ward. This should only be done when the seat is not occupied. B080D01JM
o For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the sameheight of the center of gravity of an occupant's head. Generally, the center of gravity of mostpeople's head is similar with the height of the top of their eyes. Also, adjust the headrest as closeto your head as possible. For this
reason, the use of a cushion thatholds the body away from theseatback should not be recom- mended. o Do not operate vehicle with the
headrests removed as injury to the occupants may occur in the event of an accident. Headrests may provide protection againstneck injuries when properly ad- justed.
o Do not adjust the headrest posi- tion of the driver’s seat while thevehicle is in motion.
B083D01NF-AAT Active Headrests (If Installed) The active headrest is designed to move forward and upward during a rear impact. This helps to prevent the driver'sand front passenger's head from mov- ing backward and thus helps prevent neck injuries. HNF2041-1

FEATURES OF YOUR HYUNDAI 1- 15
To recline the seatback, push the seatback folding lever toward the head-rest, and release it after the desired seatback angle is achieved.
!
B080I01TB
Seatback folding lever
B080I02FC-GAT REAR SEAT Adjusting Seatback Angle
HTB294
B099A02F-DAT BEFORE FOLDING THE REAR SEATS Outboard Rear Seat Belt
Rear Seat Centre's 3 Point Type Seat Belt.
B130A01A-AAT REAR SEAT ENTRY (For 3-door model) The front passenger seatback should be tilted to enter the rear seat. By pulling up on the recliner controllever (1) at the outside of the front passenger seat, the seatback will tilt forward and the seat will automaticallyslide forward. Rear seat occupants can tilt the front passenger seatback by depressing thefoot lever (2) as shown in the illustra- tion.
HTB258-D
(1)
(2) CAUTION:
The seatback angle should only be reclined when the seat is unoccu-pied.
!WARNING:
Passengers sitting in the rear seat should be careful not to acciden-tally press the foot lever (2) while the vehicle is moving, as this may cause the seatback to move for-ward and injure a front seat occu- pant. When you recline the seatback to de-sired position, always be sure it has locked into position.

FEATURES OF YOUR HYUNDAI 1- 17
!
WARNING:
o When you return the folded down seatback to its upright position, make sure the seat belts are inposition to be accessible and to function properly.
o When you return the folded down seatback to its upright position,care should be taken not to in- jure hands or legs.
o The purpose of the fold down rear seatback and the fold for-ward rear seat cushion is to in-crease cargo space. Do not allow passengers to sit in the cargo area while the car is moving. Thisis not a proper seating position and no seat belts are available for use when the seatback isfolded down. Passengers who are not properly seated and wear- ing seat belts could sustain seri-ous injuries or death in case of an accident or a sudden stop. o Objects should not extend higher
than the top of the front seatbacks. This could allow cargo to slide forward and cause injury or damage during sudden stops.
o When you return the folded down seatback to its upright position,always be sure to install the head-rests in their proper positions. Headrests are important to the safety of occupants in a rear col-lision. If the headrests are not installed in their proper position, serious injury or death could re- sult if a rear end collision occurs.
4. To secure the seat, hook the secur-
ing strap under the seat back to the headrest stay of front driver and passenger seat.
5. To return the seatback and seat
cushion to its normal position, re-verse the above procedure.
o When you return the seatback to its upright position, always be sure it is locked into position by pulling andpushing on the top of seatback.
HTB031Securing strap
!
WARNING:
Avoid eye injury. DO NOT over- stretch. ALWAYS keep face andbody out of recoil path. DO NOT use when strap has visible signs of wear or damage.

1- 18 FEATURES OF YOUR HYUNDAI
!
!
B150A01A-DAT SEAT BELTS The use of seat belts reduces the risk of accident injury by avoiding collisionwith the interior of the car and by preventing the occupants from being thrown out of the car. This make it themost important safety feature avail- able for you and your passengers. Adequate protection is achieved onlywhen the belt is worn correctly. You should always fasten and adjust your belts before the car is put in motion andencourage your passengers to do the same. A slack belt will greatly reduce the protection afforded to the water. Care should be taken to avoid con- tamination of the webbing withpolishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out usingmild soap and water. The belt should be replaced if webbing becomes frayed, contaminated or damaged.It is essential to replace the entire assembly after it has been worn in a severe impact even if damage tothe assembly is not obvious. Belts should not be worn with straps twisted. Each seat belt assemblymust only be used by one occu- pant; it is dangerous to put a belt around a child being carried on theoccupant's lap.
WARNING:
Seat belts are designed to bear upon the bony structure of the body, and should be worn low across the frontof the pelvis or the pelvis, chest and shoulders as applicable; wearing the lap section of the belt across theabdominal area must be avoided. Seat belts should be adjusted as firmly as possible, consistent withcomfort, to provide the protection for which they have been designed. WARNING:
No modifications or additions shouldbe made by the user which will either prevent the seat belt adjusting de-vices from operating to remove slack, or prevent the seat belt assembly from being adjusted to remove slack.B140A01B-GAT REAR SEAT WARNING
For the safety of all passengers, lug- gage or other cargo should not be piled higher than the top of the seatback. B140A01TB

1- 20 FEATURES OF YOUR HYUNDAI
will also lock if you try to lean forward too quickly. Check to make sure that the belt is properly locked and that thebelt is not twisted. NOTE: If you are not able to pull out the seat belt from the retractor, firmly pull the belt out and release it. Then you will be able to pull the belt out smoothly.
B180A03A-GAT SEAT BELTS 3-Point System with Emergency Locking Retrac-
tor (If Installed)To Fasten Your Belt To fasten your seat belt, pull it out of the retractor and insert the metal tab intothe buckle. There will be an audible "click" when the tab locks into the buckle.The seat belt automatically adjusts to the proper length only after the lap belt is adjusted manually so that it fitssnugly around your hips. If you lean forward in a slow, easy motion, the belt will extend and let you move around. Ifthere is a sudden stop or impact, how- ever, the belt will lock into position. It
!
lower it, push it down while pressing the height adjuster button. Release the button to lock the anchorinto position. Try sliding the release button to make sure that it has locked into the position.
WARNING:
o The height adjuster must be in the locked position when the vehicle is moving.
o The misadjustment of height of the shoulder belt could reducethe effectiveness of the seat belt in a crash.
*1) When the ignition key is turned from"OFF" position to "ON" within 1minute.
The seat belt warning light and chimewill activate to the following table.
B265E01TB-DAT Seat Belt Warning Light and Chime
B180A01NF
Sat Belt WarningLight
Seat Belt Ignition Switch
Unbuckled ON Stay on until buckled up
Buckled O N Come on for 6 seconds
Unbuckled ON * 1
Blink until buckled up
ON Blink until buckled up* 2
Buckled



Unbuckled User (Driver) Condition

FEATURES OF YOUR HYUNDAI 1- 21
B200A01S-GAT Adjusting Your Seat Belt B210A02A-DATTo Release the Seat Belt
The seat belt is released by pressing the release button in the locking buckle. When it is released, the belt shouldautomatically draw back into the re- tractor. If this does not happen, check the beltto be sure it is not twisted, then try again. If the seat belt does not draw back intothe retractor after checking for any twists have the belt inspected by a Hyundai dealer.
B200A02NF
You should place the belt as low as possible on your hips, not on your waist. If the belt is located too high onyour body, you could slide under it in case of an accident or a sudden stop. This could result of death, seriousinjury or property damage. Both arms should not be under or over the belt. Rather, one should be over and theother under, as shown in the illustration. Never wear the seat belt under the arm nearest to the door.
*2) If the vehicle speed exceeds 9km/
h, the seat belt chime also soundsfor about 1~2 minutes.If the vehicle speed is below 9km/h, 1 minute later the seat belt chime also sounds for about 1~2 minutes.
NOTE: If the driver's seat belt is operated in this order "unbuckled

buckled



unbuckled

buckled


unbuckled"
within 9 seconds after the seat belt isbuckled, the seat belt warning lightand chime will not activate.
B210A01NF