2009 HONDA CIVIC SEDAN Owner's Manual (in English)

Page 41 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) An inf ant must be properly 
restrained in a rear-f acing, reclining
child seat until the child reaches the 
seat maker’s weight or height limit 
f or the seat, and the child is at least
one year ol

Page 42 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Of the different seats available, we 
recommend those that have a f ive-
point harness system as shown. 
A child who is at least one year old, 
and who fits within the child seat
maker’s weight and

Page 43 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Conventional child seats must be 
secured to a vehicle with a seat belt,
whereas LATCH-compatible seats 
are secured by attaching the seat to 
hardware built into the two outer
seating positions in th

Page 44 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Af ter selecting a proper child seat 
and a good place to install the seat,
there are three main steps in 
installing the seat:All child seats must be
secured to the vehicle with the lap 
part of a la

Page 45 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) To install a LATCH-compatible child 
seat:Move the seat belt buckle or
tongue away f rom the lower
anchors. 
Make sure there are no objects 
near the anchors that could
prevent a secure connection
bet

Page 46 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Whatever type you have, f ollow 
the child seat maker’s instructions
f or adjusting or tightening the f it.Lif t the head restraint (see page
), then route the tether strap
through the legs of the h

Page 47 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) When not using the LATCH system, 
all child seats must be secured to the
vehicle with the lap part of a lap/ 
shoulder belt.With the child seat in the desired
seating position, route the belt
through

Page 48 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Af ter conf irming that the belt is 
locked, grab the shoulder part of
the belt near the buckle, and pull 
up to remove any slack from the 
lap part of the belt. Remember, if
the lap part of the belt