2009 FIAT PANDA door lock

F0Z0028m
fig. 54
FUEL CUT-OFF SWITCH fig. 54
It is located under the driver’s seat and comes into oper-
ation in the case of a collision:❒
cutting off fuel supply with resultant engine switching-off;
❒
automatically unlocking the doors;
❒
switching on interior lights (for about 15 minutes).
When the device comes into operation the message
“FPS on” is shown on the display.
For the reconfigurable multifunction display, the message
“Inertia switch intervened – See Handbook” will be
displayed. FOG LIGHTS fig. 53
(for versions/markets where provided)
To turn the lights on, press the button F with the side lights
on.
With fog lights on, the warning light
5
on the instrument
panel will come on at the same time.
Press the button again to turn the lights off.
REAR FOG LIGHTS fig. 53
To turn the lights on press the button D with the dipped
beam or fog lights on.
With lights on, the warning light 4on the instrument pan-
el will come on at the same time. Press the button again
to turn the lights off.
HEATED REAR WINDOW fig. 53
Operate control E to turn the heated rear window on.
With heated rear window on, the warning light
(
comes
on. Press again to turn off.
This function will turn off automatically after about
20 minutes.
54
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
031-064 PANDA EN 7-10-2009 13:43 Pagina 54

61
F0Z0686m
fig. 67
To unlock
Turn the key to position 2 with the door shut properly.
With central door locking (for versions/markets where
provided) all doors must be shut properly.
By remote control (for versions/markets where provided)
press the button
Á
to close the doors.
If one of the doors is not shut properly, simultaneous
locking is disabled.
IMPORTANT If one of the front doors is not fully closed
or in case of system failure, central door locking will not
operate and, after 6 attempts in rapid sequence, the sys-
tem will be excluded for about 60 seconds.
DOORSLOCKING/UNLOCKING FROM THE OUTSIDE
fig. 67
To unlock
Turn the key to position 1 and pull the handle upwards.
With central door locking (for versions/markets where
provided), the doors are unlocked simultaneously when
the key is turned.
By remote control (for versions/markets where provided)
press the button
Ëto open the doors.
Before opening a door, make sure this can
be done in safety.
WARNING
Open the doors only when the car is sta-
tionary.
WARNING
KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
031-064 PANDA EN 7-10-2009 13:43 Pagina 61

F0Z0062m
fig. 68
F0Z0063m
fig. 69
CHILD LOCK fig. 69
To prevent opening the rear doors from the inside.
This device can only be engaged with the rear doors open:❒
position 1 – device off (door can be opened from
the passenger’s compartment);
❒
position 2 – device on (door cannot be opened from
the passenger’s compartment).
The device remains on even if the doors are unlocked
electrically.
IMPORTANT Always use this device when transporting
children.
IMPORTANT After engaging the child lock on both rear
doors, check for proper engagement by trying to open
a rear door with the internal handle. LOCKING/UNLOCKING FROM THE INSIDE
fig. 68
To unlock
Pull the control lever A.
With central door locking system, operating the lever A on
the driver’s side will unlock all the doors. Lever A on the
other doors will only open the corresponding door.
To unlock
Push the control lever A toward the door. Operating
the lever A on driver’s side will lock all doors. On the oth-
er doors, the lever will only lock the concerned door.
With mechanical lock, without centralised system, to lock
a door you need to operate the corresponding door lever;
only for rear doors locking can be engaged also with
the door open.
62
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
031-064 PANDA EN 7-10-2009 13:43 Pagina 62

F0Z0687m
fig. 72
F0Z0688m
fig. 73
BOOTOPENING THE TAILGATE
By means of the key without remote control
fig. 72
To release the lock, use the metal insert of the ignition
key A.
Tailgate opening is eased by the action of the side gas
struts.
Some versions, opening the tailgate will switch the boot
light on: the light will go off automatically when closing
the tailgate.
The light will stay on for about 15 minutes after turning the
key to STOP: if during this time, one door or the tailgate
is opened, the light will switch on again for 15 minutes.By means of the key with remote control
(for versions/markets, where provided)
Press the button
R
. The direction indicators will
blink twice when the tailgate is opened.
Soft touch power handle fig. 73
(for versions/markets, where provided)
On some versions, the tailgate (when released) can
be opened only from outside the car operating on
the powered handle C located under the tailgate edge.
The tailgate can be opened at any time, if the doors
are unlocked. To open it, enable the handle, opening
one of the front doors or unlocking the doors by
the remote control or using the key without remote
control. If the boot is not shut properly the instru-
ment panel warning light ´(if any) will come on.
65KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 65

92
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Z0054m
fig. 99
F0Z0195m
fig. 100
SEAT BELT HEIGHT ADJUSTMENT
(for versions/markets where provided)
Four different adjustments in height are provided.
To adjust, press button A-fig. 99 and lower or raise the
grip B.
Always adjust the height of the seat belt to fit the person
wearing it: this precaution could greatly reduce the risk of
injury in case of collision.
Correct adjustment is obtained when the belt passes ap-
proximately half way between the shoulder and the neck.
See texts and figures in paragraph “General instructions
for using the seat belts” in this section.
Make height adjustment of the seat belts
when the car is stationary.
WARNING
After adjustment, always check that the
slider to which the ring is fastened is locked
in one of the set positions. To do this, with the
button A released, exert a further pressure to al-
low the anchor device to catch if release did not
take place at one of the preset positions.
WARNING
For some versions, front seat belts have just one fixed
anchor point C-fig. 100 on the door post.
091-110 PANDA EN 7-10-2009 13:46 Pagina 92

127KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CARWARNING LIGHTS
AND MESSAGESIN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
INJECTION SYSTEM FAILURE
(Multijet versions – amber)
EOBD ENGINE CONTROL SYSTEM
FAILURE (petrol versions – amber)
Injection system failure
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off af-
ter engine start-up.
The warning light staying on or turning on when travelling,
signal a fault in the supply/ignition system which could cause
possible lack of performance, poor handling and high con-
sumption levels.
On some versions the display shows the dedicated message.
Under these conditions, you may continue travelling at mod-
erate speed without demanding excessive effort from the en-
gine. Contact a Fiat Dealership as soon as possible.
EOBD ENGINE CONTROL SYSTEM FAILURE
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off after
engine start-up. The initial switching-on indicates that the
warning light is working properly. If the warning light ei-
ther stays on or comes on while travelling:
❒switched on steadily: it signals a failure in the supply/
ignition system which could cause high emissions at the
exhaust, possible lack of performance, poor handling
and high consumption levels.
On some versions the display shows the dedicated message. “DUALDRIVE” ELECTRIC POWER
STEERING FAILURE (red)
Turning the ignition key to MAR the warning light
turns on, but it should go off after a few seconds.
If the warning light stays on, you will not have the steer-
ing assistance and the effort on the steering wheel will be
increased, steering is still however possible. Contact a Fiat
Dealership.
On some versions the display shows the dedicated message.
g
INCOMPLETE DOOR LOCKING (red)
On some versions the warning light turns on when
one or more doors or the tailgate are not prop-
erly closed.
On some versions the display shows the dedicated message.
A buzzer will sound (for versions with reconfigurable mul-
tifunction display only) when doors are open and the car
is moving.
´
U
123-134 PANDA EN 7-10-2009 13:49 Pagina 127

128
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
INCOMPLETE DOOR LOCKING
(red)
On some versions the warning light turns on
when one or more doors or the tailgate are not
properly closed.
On some versions the display shows the dedicated message.
A buzzer will sound (for versions with reconfigurable mul-
tifunction display only) when doors are open and the car
is moving.
´
INJECTION SYSTEM FAILURE
(Multijet versions – amber)
EOBD ENGINE CONTROL SYSTEM
FAILURE (petrol versions – amber)
Injection system failure
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off af-
ter engine start-up.
The warning light staying on or turning on when travelling,
signal a fault in the supply/ignition system which could cause
possible lack of performance, poor handling and high con-
sumption levels.
On some versions the display shows the dedicated message.
Under these conditions, you may continue travelling at mod-
erate speed without demanding excessive effort from the en-
gine. Contact a Fiat Dealership as soon as possible.U
Under these conditions, you may continue travelling at
moderate speed without demanding excessive effort from
the engine. Prolonged use of the car with the warning light
on may cause damages. Contact a Fiat Dealership as soon
as possible. The warning light goes off if the failure disap-
pears, but it is still stored by the system.
❒flashing: it indicates the possibility of damage to the cat-
alytic converter (see “EOBD system” in section “Know
your vehicle”).
If warning light
v
flashes, contact a
Fiat Dealership as soon as possible to have
engine oil changed and instrument panel warning
light turned off.
WARNING
“DUALDRIVE” ELECTRIC POWER
STEERING FAILURE (red)
Turning the ignition key to
MAR
the warning light
turns on, but it should go off after a few seconds.
If the warning light stays on, you will not have the steer-
ing assistance and the effort on the steering wheel will be
increased, steering is still however possible. Contact
a Fiat Dealership.
On some versions the display shows the dedicated message.
g
123-134 PANDA EN 7-10-2009 13:49 Pagina 128

163KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGESIN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
5
7,5
7,5
10
7,5
15
15
7,5
7,5
7,5
7,5
5
5
15
–
–
7,5
7,5
7,5
20
10
10
10
10
F31
F35
F35
F37
F41
F45
F46
F49
F49
F49
F50
F51
F51
F54
FA
FB
F12
F13
F13
F38
F39
F39
F39
F39
FUSE SUMMARY TABLEPassenger’s compartment fuse-box - fig. 167 FUSE AMPEREReversing lights+15 radioCentral dashboard+15 stop lightsDoor mirror defroster Heated seats (pre-arrangement)Electric sun roofAutomatic climate control systemTyre pressureSensor for water presence in the diesel fuel filter +15 air bag control unit+15 Body-computer control unit+15 instrument panelSubwooferFreeFreeRight dipped beam headlightLeft dipped beam headlightHeadlight aiming adjustment+ 30 door locking deviceEOBD diagnosis socketRadioAutomatic climate control systemTyre pressure
135-168 PANDA EN 7-10-2009 14:07 Pagina 163