2009 FIAT PANDA engine

12
FIAT PANDA 100HP
If the oil level is near or even below the
MINmark, add oil through the filler neck
A, until reaching the MAXmark.
Oil level shall never exceed the MAX
mark.
Use engine oil with specifications de-
scribed in paragraph “Fluids and Lubri-
cants” in section “Technical Specifications”
of the Owner Handbook this Supplement
is attached to.
ENGINE OIL CONSUMPTION
Max engine oil consumption is usually 400
grams every 1000 km.
When the car is new, the engine needs
to run in, therefore the engine oil con-
sumption can only be considered stabilised
after the first 5.000 ÷ 6.000 km.
IMPORTANT The oil consumption de-
pends on driving style and the conditions
under which the car is used.
IMPORTANT After adding or changing
the oil, let the engine turn over for a few
seconds and wait a few minutes after turn-
ing it off before you check the level. ENGINE OIL fig. 12
Check the oil level a few minutes (about
5) after the engine has stopped, with the
car parked on level ground.
The oil level shall be included between
marks MINand MAXon the dipstick B.
The gap between MINand MAXmarks
corresponds to about one litre of oil.
fig. 12F0G649m
Do not add oil with specifica-
tions other than that already
in the engine.
Used engine oil and filter con-
tain harmful substances for
the environment. Contact Fi-
at Dealership to have the oil
and filter changed, as they are
equipped to dispose of the waste oil
and filters respecting the nature and
the law.
When the engine is hot, take
care when working inside the
engine compartment to avoid burns.
Remember that when the engine is
hot, fan may cut in: danger of injury.
Scarves, ties and other loose cloth-
ing might be pulled by moving parts.
WARNING
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 12

13
FIAT PANDA 100HP
ENGINE COOLANT fig. 13
The coolant level shall be checked with
cold engine and shall be within the MIN
and MAXmarks on the tank.
If the level is low, pour slowly a mixture
of 50% distilled water and 50%
PARAFLU
UPof the FL SeleniaGroup
through the filler neck Auntil the level
reaches MAX.
A 50-50 mixture of PARAFLU
UPand
distilled water gives freeze protection to
–35°C.
fig. 13F0G0107m
The engine cooling system us-
es protective antifreeze fluid
PARAFLU
UP. Use the same flu-
id type as that already in the cooling
system when topping up. PARAFLU
UP
fluid cannot be mixed with any other
type of fluid. Should it happen, under
no circumstances start the engine; con-
tact a Fiat Dealership.
The cooling system is pres-
surised. If necessary, replace
the cap only with another genuine
one, otherwise system efficiency
could be compromised. Do not re-
move the reservoir cap when the en-
gine is hot: you risk scalding yourself.
WARNING
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 13

14
FIAT PANDA 100HP
ENGINE CODES - BODYWORK VERSIONS
Version Engine code Body version
Fiat Panda 100HP169A3000 169AXE1B 0H
ENGINE
GENERAL INFORMATION
Engine code
Cycle
Number and layout of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Maximum power (EEC) kW
HP
corresponding ratio rpm
Maximum torque (EEC) Nm
kgm
corresponding ratio rpm
Spark plugs
FuelFiat Panda 100HP
169A3000
Otto
4 in line
72 x 84
1368
11
73.5
100
6000
131
13.4
4250
NGK DCPR7E - N - 10
Unleaded petrol, 95 RON (Specification EN228)
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 14

19
FIAT PANDA 100HP
Fiat Panda 100HP
35
5
4.50
2.75
2.90
1.65
0.55
1.80
CAPACITIES
Fuel tank: litresincluding a reserve of: litres
Engine cooling system: litres
Engine sump: litres
Engine sump and filter: litres
Gearbox/differential casing: litres
Hydraulic brake circuit: kg
Windscreen and rear window
washer fluid reservoir: litresSpecified fuels and
recommended products
Unleaded petrol with no less than 95
R.O.N.
Mixture of distilled water and
PARAFLU
UPat 50%
SELENIA 20K
TUTELA CAR TECHNYX
TUTELA TOP 4
Mixture of water and
TUTELA PROFESSIONAL SC 35
PERFORMANCE
Top admitted speed after initial car use in km/h.
Fiat Panda 100HP185
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 19

20
FIAT PANDA 100HP
FUEL CONSUMPTION
IMPORTANT The type of route, traffic situations, weather conditions, driving style (e.g.: sports driving), general conditions of the
car, trim level/equipment/accessories, load, climate control system, roof rack, other situations that affect air drag may lead to dif-
ferent fuel consumption levels than those measured
Fuel consumption according to European Directive in force (litres x 100 km)
Version Urban Extra-urban Combined
Fiat Panda 100HP8.7 5.3 6.5
Using the SPORT function, fuel consumption will be slightly higher than the stated values.
CO2EMISSIONS
The CO2emission levels at the exhaust given in the following tables refer to combined consumption.
Version CO2emissions according to European Directive in force (g/km)
Fiat Panda 100HP154
Fiat Group Automobiles S.p.A.
Customer Services - Technical Services - Service Engineering
Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print n° 603.97.390 - 09/2009 - 1 Edition
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 20