2009 DODGE CHALLENGER SRT key battery

If Engine Fails To Start
WARNING!
•Never pour fuel or other flammable liquids into
the throttle body air inlet opening in an attempt to
start the vehicle. This could result in a flash fire
causing serious personal injury.
•Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the catalytic converter and once the
engine has started, ignite and damage the converter
and vehicle. If the vehicle has a discharged battery,
booster cables may be used to obtain a start from a
booster battery or the battery in another vehicle.
This type of start can be dangerous if done improp-
erly. Refer to Section 6 for proper jump-starting
procedures and follow them carefully.
Clearing A Flooded Engine - Using ENGINE
START/STOP Button
If the engine fails to start after you have followed the
“Normal Starting” or “Extreme Cold Weatherproce-
dures, it may be flooded. To clear any excess fuel, press
and hold the brake pedal with your left foot, push and
hold the accelerator pedal all the way to the floor with
your right foot, and then press and release the ENGINE
START/STOP button twice. The starter motor will en-
gage automatically, run for 10 seconds, and then disen-
gage. Once this occurs, release the accelerator pedal and
the brake pedal, wait 10 to 15 seconds, then repeat the
normal starting procedure.
Clearing A Flooded Engine - Using Fob With Integrated
Key
If the engine fails to start after you have followed the
“Normal Starting” or “Extreme Cold Weather” proce-
dures, it may be flooded. To clear any excess fuel, push
the accelerator pedal all the way to the floor and hold it.
218 STARTING AND OPERATING

WARNING!
Unintended movement of a vehicle could injure those
in and near the vehicle. As with all vehicles, you
should never exit a vehicle while the engine is run-
ning. Before exiting a vehicle, you should always shift
the transmission into PARK, remove the key from the
ignition, and apply the parking brake. Once the key is
removed from the ignition, the transmission shift lever
is locked in the PARK position, securing the vehicle
against unwanted movement. Furthermore, you should
never leave unattended children inside a vehicle.
Over-Temperature Mode
The transmission electronics constantly monitor the trans-
mission oil temperature. If the transmission exceeds nor-
mal operating temperature, the transmission will change
the way it shifts to help control the condition. This mayresult in a slightly different feeling or response during
normal operation in DRIVE position. After the transmis-
sion cools down, it will return to normal operation.
Brake/Transmission Shift Interlock System
This vehicle is equipped with a Brake Transmission Shift
Interlock (BTSI) system that holds the shift lever in the
PARK position when the ignition switch is in the LOCK
position. To move the shift lever out of the PARK
position, the ignition switch must be turned to the ON
position, and the brake pedal must be depressed.
BTSI Override
There is an override for the BTSI that allows you to move
the shift lever out of the PARK position if an electrical
system malfunction occurs (i.e., dead battery). To access
the override (using a flat-bladed screwdriver), carefully
remove the override cover which is located on the right
of the shift lever gate.
222 STARTING AND OPERATING

Trip Odometer button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the MIL.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of this vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the Malfunction
Indicator Light (MIL) is functioning and is not on
when the engine is running, and that the OBD II system
is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if the vehicle was recentlyserviced, recently had a dead battery, or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, the vehicle may fail the test.
This vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if this vehicle’s OBD II system is ready, you must
do the following:
1. Insert the ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn the ignition key to the ON
position, you will see the MIL symbol come on as part of
a normal bulb check.
298 MAINTAINING YOUR VEHICLE

5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition key or start the engine. This means that the
vehicle’s OBD II system isnot readyand you should
notproceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn OFF the ignition key or start
the engine. This means that the vehicle’s OBD II
system isready,and you can proceed to the I/M
station.
If the OBD II system isnot ready,you should see an
authorized dealer or repair facility. If this vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive the vehicleas you normally would in order for the OBD II system to
update. A recheck with the above test routine may then
indicate that the system is now ready.
Regardless of whether the vehicle’s OBD II system is
ready or not ready, if the MIL is illuminated during
normal vehicle operation, you should have the vehicle
serviced before going to the I/M station. The I/M station
can fail the vehicle because the MIL is on with the engine
running.
REPLACEMENT PARTS
Use of genuine MOPARparts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-MOPARparts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
MAINTAINING YOUR VEHICLE 299
7

Auto Unlock, Doors....................... 31
Automatic Dimming Mirror ................. 75
Automatic Door Locks ..................... 31
Automatic Headlights ..................... 117
Automatic Transaxle Special Additives ...................... 324
Automatic Transmission .............223,322,323
Adding Fluid ...................... 323,343
Autostick ............................ 228
Fluid and Filter Changes ................. 323
Fluid Change ......................... 323
Fluid Level Check ...................... 322
Fluid Type ........................... 343
Shifting ............................. 223
Special Additives ...................... 324
Automatic Transmission Limp Home Mode . . 226,227
Autostick ............................. 228
Axle Fluid ............................. 343
Axle Lubrication (Axle Fluid) ............... 343Ball Joints
............................. 311
Battery ............................... 307
Emergency Starting ..................... 286
Jump Starting ......................... 286
Keyless Transmitter Replacement (RKE) ....... 25
Location .......................... 287,307
Bearings .............................. 324
Belts, Drive ............................ 303
Belts, Seat ............................ 38,69
Body Mechanism Lubrication ............... 311
B-Pillar Location ........................ 250
Brake Assist System ...................... 239
Brake Control System, Electronic ............. 238
Brake Fluid ............................ 343
Brake, Parking .......................... 232
Brake System ........................ 234,320
Anti-Lock (ABS) .................... 235,238
Fluid Check ....................... 321,343
Hoses .............................. 320
INDEX 363
10

Trailer Towing.......................... 278
Transmission ........................... 322
Automatic ...................... 220,223,322
Fluid ............................... 343
Shifting ............................. 220
Transmitter Battery Service (Remote Keyless
Entry) ................................. 25
Transmitter, Garage Door Opener (HomeLink
) . . 130
Transmitter Programming (Remote Keyless Entry) . 21
Transmitter, Remote Keyless Entry (RKE) ........ 21
Transporting Pets ........................ 67
Tread Wear Indicators .................... 258
Trip Odometer .......................... 150
Trunk Lid (Deck Lid) .................... 35,36
Trunk Release, Emergency .................. 36
Trunk Release Remote Control ............... 35
Turn Signals ......................... 1 19,152UConnect™ (Hands-Free Phone)
...........78,191
Uniform Tire Quality Grades ................ 358
Universal Serial Bus (USB) Port .............. 191
Universal Transmitter ..................... 130
Unleaded Gasoline ....................... 270
Untwisting Procedure, Seat Belt .............. 42
USB Port .............................. 191
Vacuum/Vapor Harnesses ................. 319
Vanity Mirrors ........................... 77
Variance, Compass ....................... 170
Vehicle Certification Label ................. 276
Vehicle Identification Number (VIN) ............ 6
Vehicle Loading ................... 251,276,277
Vehicle Modifications/Alterations .............. 7
Vehicle Storage ....................... 207,335
Vehicle Theft Alarm (Security Alarm) .......... 18
380 INDEX