2009 DODGE CALIBER SRT ECU

[x] Cancel search: ECU

Page 26 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual Flash Lights with Remote Key Lock/Unlock
This feature will cause the turn signal lights to flash when
the doors are locked or unlocked with the RKE transmit-
ter. This feature can be turned on or turn

Page 29 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual NOTE:If the RKE transmitter is equipped with a screw,
reinstall and tighten the screw until snug.
DOOR LOCKS
Manual Door Locks
Use the manual door lock plunger to lock the doors from
inside the vehicl

Page 53 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual moderate-to-severe side collisions. In certain types of
collisions, both the front and side airbags may be trig-
gered. But even in collisions where the airbags work, you
need the seat belts to keep y

Page 63 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual Child Restraint
Everyone in your vehicle needs to be buckled up at all
times — babies and children, too. Every state in the
United States and all Canadian provinces require that
small children ride

Page 66 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual The passenger seat belts are equipped with either
cinching latch plates or seat belt retractors that can be
switched to an automatic locking mode, which are
designed to keep the lap portion tight arou

Page 71 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual WARNING!
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchor position directly behind
the child seat to secure a child restra

Page 77 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual Windshield Wipers And Washers.......... 127
▫Windshield Wiper Operation............ 127
▫Intermittent Wiper System.............. 128
▫Windshield Washers................... 128
▫Mist Feature..

Page 123 of 411

DODGE CALIBER SRT 2009 1.G Owners Manual TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released.
1. Pull the hood release lever located on the left kick
panel.2. Move the safety catch located under the front edge of
the ho