Trunk Release, Emergency.................. 40
Trunk Release Remote Control............... 39
Turn Signals.........................139,205
UCI Connector......................... 276
UConnect(Hands-Free Phone).............. 88
Uniform Tire Quality Grades................ 466
Universal Consumer Interface (UCI) Connector . . . 276
Universal Transmitter..................... 181
Unleaded Gasoline....................... 367
Untwisting Procedure, Seat Belt.............. 48
Vanity Mirrors........................... 87
Variance, Compass....................... 227
Vehicle Certification Label................. 373
Vehicle Identification Number (VIN)............ 6
Vehicle Loading...................343,373,375
Vehicle Modifications/Alterations.............. 7
Vehicle Storage.......................300,431Vehicle Theft Alarm
(Security Alarm)......................... 18
Video Entertainment System™
(Rear Seat Video System).................. 288
Viscosity, Engine Oil...................... 401
Voice Recognition System (VR).............. 116
Warning Flasher, Hazard.................. 378
Warning Lights
(Instrument Cluster Description)............. 205
Warnings and Cautions..................... 6
Warranty Information..................... 464
Washer, Adding Fluid..................... 408
Washers, Windshield................142,143,408
Washing Vehicle......................... 420
Water
Driving Through...................... 324
Wheel and Wheel Trim.................... 421
Wheel and Wheel Trim Care................ 421
488 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
