Page 159 of 250
158STARTING UP AND DRIVING
SNOW CHAINS
The use of snow chains should be in compliance with local regu-
lations. The snow chains may be applied only to the front wheel
tyres (drive wheels).
Check the tension of the chains after the first few metres have been
driven.
Use reduced bulk snow chains: for 195/55 R16” and 205/45
R17” tyres. Use reduced bulk snow chains with a maximum pro-
trusion from the tyres of 9 mm.
IMPORTANT The spare wheel cannot be fitted with snow chains.
If a front (drive) wheel is punctured and snow chains must be used,
you must remove a normal wheel from the rear and replace this
one with the small spare wheel. In this way, with two normal dri-
ve wheels, it is possible to use snow chains.
CAR INACTIVITY
If the car is to be left inactive for longer than a month, the following
precautions should be noted:
❍park the vehicle in a dry, covered and, if possible, ventilated
area; engage a gear and check that the handbrake is not en-
gaged;
❍disconnect the negative battery terminal and check battery
charge. Repeat this check once every three months during stor-
age;
❍clean and protect painted areas using protective wax;
❍clean and protect the shiny metal areas using special com-
mercially-available products;
❍sprinkle talcum powder on the rubber windscreen and rear win-
dow wiper blades and lift them off the glass;
❍slightly open the windows;
❍cover the car with a fabric or perforated plastic sheet. Do not
use compact plastic sheets which do not allow humidity to evap-
orate from the surface of the car.
❍inflate tyres to a pressure of +0.5 bar above the normal spec-
ified pressure and check the pressure at regular intervals;
❍if you have not disconnected the battery, check the battery
charge every thirty days;
❍do not drain the engine cooling system.
Keep your speed down when snow chains are fit-
ted. Do not exceed 50 km/h. Avoid potholes, steps
and pavements and also avoid driving long dis-
tances on roads not covered with snow to prevent dam-
aging the car and the roadbed.
149-158 Alfa MiTo GB 12-11-2008 15:41 Pagina 158
Page 160 of 250
IN AN EMERGENCY159
4
In an emergency we recommend that you call the freephone number found in the Warranty Booklet.
You can also consult www.alfaromeo.com to find Alfa Romeo Authorised Services your nearest
Starting the engine..................................................................... 160
Replacing a wheel....................................................................... 161
“Fix&Go Automatic” Kit............................................................... 169
Changing a bulb.......................................................................... 174
Replacing exterior bulbs................................................................ 176
Replacing an interior bulb.............................................................. 180
Replacing fuses........................................................................... 183
Recharging the battery ................................................................. 193
Lifting the car............................................................................. 193
Towing the car ............................................................................ 194
159-196 Alfa MiTo GB 12-11-2008 15:45 Pagina 159
Page 161 of 250
160IN AN EMERGENCY
STARTING THE ENGINE
If the Ywarning light in the instrument panel remains on con-
stantly, contact an Alfa Romeo Authorised Service Provider imme-
diately.
STARTING WITH AN AUXILIARY BATTERY
If the battery is flat, the engine may be started using an auxiliary
battery with the same capacity or a little higher than the flat one.
For engine starting follow the procedure below, fig. 1:
❍connect the positive terminals (+ sign near the terminal) of the
two batteries with a jump lead;
❍with a second lead, connect the negative terminal – of the aux-
iliary battery to an earth point
Eon the engine or the gear-
box of the car to be started;
❍start the engine; when engine has started, remove the cables
by reversing the sequence described for connection.If after several attempts the engine will not start, contact an Alfa
Romeo Authorised Service Provider.
IMPORTANT Never connect the negative terminals of the two bat-
teries directly! If the auxiliary battery is installed on another car,
prevent accidental contact between metallic parts of the two cars.
BUMP STARTING
Never start the engine by pushing, towing or driving downhill.
fig. 1A0J0111m
159-196 Alfa MiTo GB 12-11-2008 15:45 Pagina 160
Page 164 of 250
IN AN EMERGENCY163
4
JACK
Important notes:
❍the jack weight is 1.76 kg;
❍the jack requires no adjustment;
❍the jack cannot be repaired; if it breaks it must be replaced with
a new jack;
❍no tool other than the cranking device may be fitted on the
jack.Replace the wheel as follows:
❍stop the car in a position where it does not endanger on-com-
ing traffic and where you can replace the wheel safely. The
ground must be flat and compact;
❍switch off the engine, pull up the handbrake and engage 1st
gear or reverse; put on the high visibility jacket (required by
law) before leaving the vehicle;
❍open the luggage compartment, pull tab A-fig. 2 and lift up the
mat;
❍undo locking device A-fig. 3, remove tool box B and place it
next to the wheel to be replaced; remove small spare wheel C;
fig. 2A0J0104mfig. 3A0J0105m
159-196 Alfa MiTo GB 12-11-2008 15:45 Pagina 163
Page 173 of 250
172IN AN EMERGENCY
❍inflate the tyre to the pressure shown in the paragraph entitled
“Wheels” in chapter 6. In order to obtain a precise reading,
check the pressure on pressure gauge B-fig. 18 with the com-
pressor off;
❍if a pressure value of a least 1.5 bars is not reached within 5
minutes, disconnect the compressor from the valve and current
socket, move the vehicle forwards by about 10 metres to dis-
tribute the sealant fluid in the tyre and repeat the inflation
procedure;
fig. 18A0J0114m
❍if a pressure value of a least 1.8 bars is not reached within 5
minutes of switching on the compressor, do not continue dri-
ving. Contact an Alfa Romeo Authorised Services;
❍after having driven for about 10 minutes, stop the car and check
the tyre pressure once more: remember to engage the hand-
brake;
❍if a pressure value of at least 1.8 bars is detected, restore the
correct pressure (with the engine running and the handbrake
engaged), and drive with care to an Alfa Romeo Authorised
Services.
159-196 Alfa MiTo GB 12-11-2008 15:45 Pagina 172
Page 186 of 250
IN AN EMERGENCY185
4
fig. 41A0J0127m
When washing the engine compartment, take care
not to spray water jets directly at the fuse box.FUSE LOCATION
Fuses are grouped together in three junction units located in the
engine compartment, dashboard and luggage compartment
Fuse box in engine compartment
This is located next to the battery: to access the fuses undo bolts
A-fig. 40 and remove cover B.
The ID number of the electrical component corresponding to each
fuse can be found on the back of the cover.
After replacing the fuse, make sure you close cover B on the fuse
box.
fig. 40A0J0126m
159-196 Alfa MiTo GB 12-11-2008 15:46 Pagina 185
Page 190 of 250
41
41
41
41
43
41
41
41
41
41
41
41
41
4115
20
15
10
7.5
30
5
10
5
7.5
30
15
15
20F08
F09
F10
F11
F13
F15
F16
F17
F18
F19
F20
F21
F22
F22
IN AN EMERGENCY189
4
CONSUMERS FUSE AMPERE FIGURE
Heated windscreen
Headlight washer pump
Two-tone horn
Waste gate solenoid, Shut off solenoid, Canister solenoid,
Lambda Sensor Heater, VGT solenoid,
EGR cooling bypass solenoid, Swirl solenoid,
Throttle solenoid, Glow plug preheating control unit
Headlight alignment adjustment system
Additional heater (PTC 1)
Engine management control unit
Engine management control unit (power supply)
Control system relay coil,
Engine management control unit (1.4 versions),
Engine cooling system remote control switch coil
(300W+300W)
Air conditioning compressor
Heated rear windscreen, demisting system
Fuel pump on tank
Engine management system main loads (1.4 versions)
Engine management system main loads
(1.6 JTDMversions)
159-196 Alfa MiTo GB 12-11-2008 15:46 Pagina 189
Page 191 of 250
190IN AN EMERGENCY
F23
F24
F31
F36
F37
F38
F43
F47
F4820
5
5
10
5
15
20
20
2041
41
43
43
43
43
43
43
43
CONSUMERS FUSE AMPERE FIGURE
Braking system control unit (control unit and solenoid unit)
Electric steering control unit
(power supply + Key),
Brake system control unit (power supply + Key),
Yaw sensor on tunnel
INT/A key exhaust relay coils
on engine fuse box
Radio, Blue&Me
TMcontrol unit, Climate control unit,
Alarm control unit, Volume sensing system control unit,
EOBD external diagnostic socket,
Tyre pressure detection control unit
Instrument panel, Brake light switch,
Gas discharge headlights management system
Door lock motor on door,
Safe Lock motor on doors,
Tailgate unlocking motor
Windscreen / rearscreen washer pump
Electric window motor complete with
control unit (driver-side door)
Electric window motor complete with
control unit (passenger-side door)
159-196 Alfa MiTo GB 12-11-2008 15:46 Pagina 190
