2009 Acura TL ECU

HFL responds ‘‘Security is on.
Each time the vehicle is turned on,
the passcode will be required to
use the system. If you f orget this
passcode, you must either go to
the dealer to have it reset, or clear
the entire system using the
System Clear command.’’
Once a passcode is set, HFL will
prompt you f or your passcode each
time the ignition switch is turned to
the ON (II) position and you press
the Talk button. You will only be
askedforthepasscodeonceper
ignition cycle. Press and release the Talk button.
Af ter the beep, HFL prompts ‘‘The
system is locked. What is the f our-
digit passcode?’’
Press and release the Talk button.
Af ter the beep, say your f our-digit
passcode.Forexample,say‘‘1,2,3,
4.’’
If thepasscodeiscorrect,HFL
responds ‘‘System is unlocked.’’
If thepasscodeisnotcorrect,please
try again according to the HFL’s
guidance.
You can also select a ‘‘System Clear’’
command to reset HFL (see page ). Press and release the Talk button.
Af ter the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notif ication, auto
transf er, and clear. Press the Talk
button and say a command.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Change
passcode.’’
HFL responds ‘‘What is the f our
digit number you would like to set
as your security passcode? Press
the Talk button and say the
number.’’
Press and release the Talk button.
Af ter the beep, say your f our digit
passcode,forexample,say‘‘1,2,3,
4.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Yes.’’
1.
2.
3.
5.
1.
2.
3.
417
To enter your passcode, do this; To change your security passcode, do
this:
CONT INUED
BluetoothHandsFreeL ink(Models without navigation system)
Features
405
\f—\f—y
y
) \f\fy\f
\fy
2009 TL

HFLresponds‘‘1,2,3,4.Isthis
correct? Press the Talk button and
say Yes or No.’’Press and release the Talk button.
Af ter the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notif ication, auto
transf er, and clear. Press the Talk
button and say a command.’’
Press and release the Talk button.
After the beep, say ‘‘Call
notification.’’
HFL responds: ‘‘Would you like
the incoming call notif ication to be
a ring tone, a prompt, or of f ?’’
Press and release the Talk button.
Af ter the beep, f or example, say
‘‘Ring tone.’’
HFL responds ‘‘A ring tone will be
used.’’ You will hear a ring tone
through the audio speakers to
announce an incoming call.If you say, ‘‘Prompt.’’ HFL responds
‘‘An incoming call prompt will be
used.’’ You will hear a ‘‘You have an
incoming call.’’ prompt when
receiving an incoming call.
If you say, ‘‘Of f ,’’ no audible
notif ication of an incoming call will
be selected. During an incoming call,
thereisnoringtoneorprompt
playback. The audio system will still
mute, and the HFL message or the
HFL notif ication screen will be
displayed.
Press and release the Talk button.
Af ter the beep, say ‘‘Yes.’’
HFL responds ‘‘Security passcode
has been changed.’’
2.
1.
5.
3.
4.To set the incoming notif ication, do this:
BluetoothHandsFreeL ink(Models without navigation system)
406
\f—\f—y
\fy
) \f\fy\f

y
2009 TL

To activate this function, do this:
Press and release the Talk button.
Af ter the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notif ication, auto
transf er, and clear. Press the Talk
button and say a command.’’
If this feature is set to off, HFL
responds ‘‘Auto transf er is
disabled. Calls dialed on the phone
do not automatically transf er to
Bluetooth HandsFreeLink. Would
you like to enable Auto Transf er?
Press the Talk button and say Yes
or No.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Auto transf er.’’If the setting changes from on to off,
HFL responds ‘‘Auto transf er is
disabled. Use the Transf er command
at the HandsFree main menu to
manually transf er calls dialed on the
phone.’’
If this feature is set to on, HFL
responds ‘‘Auto-transf er is enabled.
Calls dialed on the phone will be
automatically transferred to
Bluetooth HandsFreeLink. Would
you like to disable Auto Transf er?
Press the Talk button and say Yes
or No.’’
Never try to dial from your
phonedirectlyif thevehicleis
moving.
To end the call, press the Back
button. If the setting changes from off to
on, press and release the Talk
button. Af ter the beep, say ‘‘Yes.’’
HFL responds ‘‘Auto transf er is
enabled.’’
When you make a call directly f rom
the phone with the auto transf er on,
make sure to stop your vehicle saf ely.
1.
2.
3.
BluetoothHandsFreeL ink(Models without navigation system)
Features
411
NOTE:
\f—\f—y
y
) \f\fy\f
y
2009 TL

To clear the system, do this:Press and release the Talk button.
Af ter the beep, say ‘‘Yes.’’
HFL responds ‘‘Preparing to clear
the system, which may take up to
two minutes to complete. To
proceed, press the Talk button and
say Continue, otherwise say Go
Back or Cancel.’’
After saying Continue, HFL
responds ‘‘Please wait while the
system is cleared.’’ HFL responds
‘‘The system has been cleared.’’
Press and release the Talk button.
Af ter the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notif ication, auto
transf er, and clear. Press the Talk
button and say a command.’’
Press and release the Talk button.
After the beep, say ‘‘Clear.’’
HFL responds ‘‘This process will
clear all paired phones, clear all
entries in the phonebook, clear the
security passcode, and restore the
defaults in the system setup. Is
this what you would like to do?
Press the Talk button and say yes
or no.’’
This operation clears the HFL of
your passcode, your paired phones,
and all names in the HFL phonebook.
Clearing is recommended bef ore you
sell your vehicle.
2.4.
1.
3.
Clearing the System
BluetoothHandsFreeL ink(Models without navigation system)
Features
417
\f—\f—y
y
) \f\fy\fy
2009 TL

Lif t the hood up most of the way.
The hydraulic supports will lif t it
uptherestof thewayandholdit
up.To close the hood, lower it to about a
f oot (30 cm) above the f ender, then
press down f irmly with your hands.
Make sure the hood is securely
latched.
Park the vehicle on a level surf ace.
Insert the dipstick all the way back
into its hole.
Wipe of f the dipstick with a clean
cloth or paper towel.
Remove the dipstick (orange loop).
Wait a f ew minutes af ter turning the
engine of f bef ore you check the oil.
If the hood latch handle moves
stif f ly, or if you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated.
3. 1.
3.
2.
Service Station Procedures
Oil Check
490
LATCH
DIPSTICK
\f—
—y
\fy
) \f\fy\fy
2009 TL

In addition, the total weight of the
vehicle, all occupants, accessories,
cargo, and trailer tongue load must
not exceed the Gross Vehicle
Weight Rating (GVWR) or the Gross
Axle Weight Rating (GAWR). Both
areonalabelonthedriver’s
doorjamb.Store or secure all items that could
be thrown around and hurt
someone during a crash.
Do not put any items on top of the
trunk panel. They can block your
view and be thrown around the
vehicle during a crash.
Example 1
Example 2
Example 3
CONT INUED
Carrying Cargo in the Passenger
Compartment
Carrying Cargo
Bef ore Driving
499
Max Load (850 lbs)
Cargo Weight
(550 lbs)
Max Load (850 lbs)
Max Load (850 lbs) Cargo Weight
(250 lbs)
Cargo Weight
(100 lbs)
Passenger Weight
(150 lbs x 2 = 300 lbs)
Passenger Weight
(150 lbs x 4 = 600 lbs)
Passenger Weight
(150 lbs x 5 = 750 lbs)
\f—\f—y
\f
y
) \f\fy\f\fy
2009 TL

Be sure items placed on the f loor
behind the f ront seats cannot roll
underneath and interf ere with the
proper operation of the seats, the
sensors under the seats, or the
driver’s ability to operate the
pedals.
Also, keep all cargo below the
bottom of the windows. If it is
higher, it could interf ere with the
proper operation of the side
curtain airbags.
Keep the glove box closed while
driving. If it is open, a passenger
could injure their knees during a
crash or sudden stop.Cargo hook buttons in the trunk can
be used to install a net f or securing
items.
The cargo net can be used to help
hold down items stored in the trunk.
Distribute cargo evenly on the
f loor of the trunk, placing the
heaviest items on the bottom and
as far forward as possible.
If you carry large items that
prevent you f rom closing the trunk
lid, exhaust gas can enter the
passenger area. To avoid the
possibility of
, f ollow the instructions
on page . 57
If equipped
Cargo Nets
Carrying Cargo in the Trunk Cargo Hook Buttons
carbon monoxide
poisoning
Carrying Cargo
500
CARGO HOOK BUTTON
\f—\f—y
\f
y
) \f\fy\f\fy
2009 TL

Make sure all windows, mirrors,
and outside lights are clean and
unobstructed. Remove f rost, snow,
or ice.Check the seat adjustment (see
page ).
Check the adjustment of the
inside and outside mirrors (see
page ).
Check the steering wheel
adjustment (see page ).
Make sure the doors are securely
closed and locked.
Fasten your seat belt. Check that
your passengers have f astened
their seat belts (see page ).When you start the engine, check
the gauges and indicators in the
instrument panel, and the
messages on the multi-inf ormation
display (see pages , and
).
Youshoulddothesechecksand
adjustments bef ore you drive your
vehicle:
Check that the hood is f ully closed.
Check that the trunk is f ully
closed.
Visually check the tires. If a tire
looks low, use a gauge to check its
pressure.
Check that any items you may be
carrying are stored properly or
f astened down securely.
3.
2.
1.
7.
8.
9.
4.
5. 6.
155
63 75
77
16
161
140
10. 11.
Preparing to Drive
502
——y
y
) yy
2009 TL