2008 SUZUKI GRAND VITARA ECO mode

Downloaded from www.Manualslib.com manuals search engine L4 2.4 L
ADS
GE
V63.2 L
GE
..... : 100 N (22Ibs, 10 kg) press ADS: Accessory drive belt GE: Generator PS: Power steering pump AC: Air conditioner compressor
AC
INSPECTION AND MAINTENANCE
Engine Oil and Filter
Specified Oil
(For Gasoline Engine Model)
1.6 L or 2.4 L engine
10W-40
10W·30
(1~~ ~'lY-~Q W·20
°C -30 -20
-10
0 10
20 I I I
I I
I of -22
-4 14 32 50 68
(1) Preferred
:>
:>
S 30 40 I I 86 104
63J266
Be sure that the engine oil you use comes
under the quality classification of SG, SH, SJ, SL or SM. Select the appropriate oil viscosity according to the above chart.
79K041 SAE OW-20 (1) is the best choice for good fuel economy, and good starting in cold weather.
7-8

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
2.0 L or 3.2 L engine
15W-40 :> 10W-40 :> (2)
~
1 QW-30 :>
:> 5W-;lQ 'C -30 -20
-10
0 10
20 30 40 I I I I I
I I I 'F -22 -4 14
32 50 68 86 104
78K082
(2) Preferred
Be sure that the engine oil you use comes
under the quality classification of SG, SH, SJ, SL or SM. Select the appropriate oil
viscosity according to the above chart.
SAE 5W-30 (2) is the best choice for good
fuel economy, and good starting in cold
weather.
7-9
(For Diesel Engine Model)
(3) 1 ~W-40
"'I :> 5W-3Q
1 OW-30 :> 'c -30 -20
-10
0 10 20
30 40 'F-:22 I
I I I I
I I -4 14 32 50 68 86 104
78K102
(3) Preferred
Be sure
that the engine oil you use comes
under the quality classification of ~CEA C3 or C4 which is mandatory for DPp!9. Select the appropriate oil viscosity according to
the above chart.
SAE 5W-30 (3) is the best choice for good
fuel economy, and good starting in cold
weather.
CAUTION
Use only the recommended ACEA C3 or C4. Use of non-recommended
engine oil will cause a.Jfamage of the
diesel engine and DPpiY.
Oil Level Check
Engine oil dipstick
(For
Gasoline Engine Model)
(For Diesel Engine Model)
80G064
EXAMPLE
64J227

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Refill with Oil and Check for Leaks 1) Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to the "Capacities" item in the "SPECIFICATIONS" section. 2) Start the engine and look carefully for leaks at the oil filter and drain plug. Run
the engine at various speeds for at least 5 minutes. 3) Stop the engine and wait about 5 min­
utes. Check the oil level again and add oil if necessary. Check for leaks again.
CAUTION
• When replacing the oil filter, it is recommended that you use a genu­
ine SUZUKI replacement filter. If you use an aftermarket filter, make
sure it is of equivalent quality and follow the manufacturer's instruc­
tions.
• Oil leaks from around the oil filter or drain plug indicate incorrect installation or gasket damage. If you find any leaks or are not sure
that the filter has been properly tightened, have the vehicle inspected by your SUZUKI dealer.
7-13
Engine Coolant
(For Gasoline Engine Model)
EXAMPLE
64J151
(For Gasoline Engine Model)
EXAMPLE
(For Diesel Engine Model)
64J249
.A WARNING
It is hazardous to remove the degas­
sing tank cap for Diesel engine when
the water temperature is high,
because scalding fluid and steam may be blown out under pressure.
Wait until the coolant temperature
has lowered before removing the cap.

Downloaded from www.Manualslib.com manuals search engine EXAMPLE
64J191
3) Remove the engine under cover. 4) Loosen the drain plug attached to the lower part of the radiator and drain the coolant into a suitable container.
5) Reinstall the reservoir and fill it with coolant to the "FULL.:' line. 6) Tighten the drain plug on the radiator. 7) Reinstall the engine under cover. 8) Fill the radiator with coolant and install
the radiator cap. 9) After filling, let the engine idle for about 2-3 minutes to get rid of air in the cool­ing system.
1 O)Stop the engine. 11 )Check the coolant level in the radiator
again. If the level has gone down, add
more coolant.
CAUTION
The coolant must be replaced with
the vehicle on level ground.
(For
Diesel Engine Model) Since special procedures are required, we recommend you take your vehicle to your SUZUKI dealer for coolant replacement.
INSPECTION AND MAINTENANCE
Air Cleaner
EXAMPLE
66J167
If the air cleaner is clogged with dust, there
will be greater intake resistance, resulting in decreased power output and increased fuel consumption.
Check and
clean periodically according to
the following procedure:
1) Take off the air cleaner case cover.
Remove the element from the air cleaner case cover. 2) This air cleaner element is of dry type.
Remember that it needs cleaning
according to the following method.
3) Blow off dust on cleaner element by
compressed air from inside the ele­ment, or replace the element as neces­sary.
7-16

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Door illumination light (for 5 door model)
Luggage compartment light
7-41
64J166
High-mount stop light (if equipped) The followings are the general procedure
for replace the bulbs of high-mount stop
light.
Since special procedures are required, we recommend you take your vehicle to your SUZUKI dealer for the bulbs of high-mount
stop light replacement.
To remove a high-mounted stop light hous­
ing the following procedure:
1) Open the tailgate, and remove the trim
(1) as shown in the illustration.
64J182
2) Release the claws of the light housing
by the flat head etc. through the service
holes as shown
in the illustration.