2008 SATURN ASTRA height adjustment

Seats and
Restraints
Front Seats
Manual Seats.....................1-2
Seat Height Adjuster...........1-2
Lumbar Seat Adjustment. . . .1-3
Reclining Seatbacks...........1-3
Head Restraints..................1-5
Heated Seats.....................1-6
Rear Seats
Rear Seat Operation...........1-7
Safety Belts
Safety Belts........................1-8
How to Wear Safety Belts
Properly..........................1-12
Lap-Shoulder Belt.............1-17
Safety Belt Use During
Pregnancy.......................1-21
Safety Belt Extender.........1-22
Safety Belt Check.............1-22
Care of Safety Belts.........1-22
Replacing Safety Belt
System Parts After
a Crash
...........................1-23
Airbag System
Airbag System..................1-23
Where Are the Airbags?. . .1-25
When Should an Airbag
Inate?............................1-27
What Makes an Airbag
Inate?............................1-28
How Does an Airbag
Restrain?........................1-28
What Will You See After
an Airbag Inates?..........1-29
Passenger Sensing
System............................1-30
Servicing Your
Airbag-Equipped
Vehicle
............................1-34
Adding Equipment to
Your Airbag-Equipped
Vehicle
............................1-35
Airbag System Check.......1-36
Replacing Airbag System
Parts After a Crash.........1-36
Child Restraints
Older Children..................1-37
Infants and Young
Children..........................1-38
Child Restraint Systems. . . .1-41
Where to Put the
Restraint.........................1-43
Lower Anchors and
Tethers for Children
(LATCH)
..........................1-45
Replacing LATCH
System Parts After
a Crash
...........................1-50
Securing Child
Restraints (Rear Seat).....1-50
Securing Child Restraints
(Right Front Seat)...........1-53
Seats and Restraints 1-1
ProCarManuals.com

4. If equipped with a shoulder belt
height adjuster, move it to the
height that is right for you.
Improper shoulder belt height
adjustment could reduce the
effectiveness of the safety belt
in a crash. See “Shoulder Belt
Height Adjustment” later in this
section.
5. To make the lap part tight, pull
up on the shoulder belt.
It may be necessary to pull
stitching on the safety belt
through the latch plate to fully
tighten the lap belt on smaller
occupants.To unlatch the belt, push the button
on the buckle. The belt should go
back out of the way. When the safety
belt is not in use, slide the latch plate
up the safety belt webbing. The latch
plate should rest on the stitching on
the safety belt, near the guide loop
on the side wall.Before you close a door, be sure
the belt is out of the way. If you slam
the door on it, you can damage
both the belt and the vehicle.
Shoulder Belt Height Adjuster
The vehicle has a shoulder belt
height adjuster for the driver
and right front passenger position.
Adjust the height so that the
shoulder portion of the belt is
centered on your shoulder. The belt
should be away from the face and
neck, but not falling off the shoulder.
Incorrect positioning of the shoulder
belt can reduce the effectiveness of
the safety belt.
1-18 Seats and Restraints
ProCarManuals.com

Rear disc brake pads do not have
built-in brake pad wear indicators.
Periodic visual inspection of the rear
brake pads is required to determine
when to replace the pads. Visually
inspect the rear brake pads
whenever the rear wheels are
removed such as during tire rotation.
1. Set the parking brake and make
sure that the brakes have been
given enough time to cool.
2. Remove the rear wheels.
3. Visually inspect the rear brake
inner pads (C) at each rear
wheel through the inspection
window in the brake caliper (A).Brake pads should be replaced
when the inner pad (C) is
worn to 5/64 in (2 mm) of pad
thickness (B). New brake
pads, with no wear, are 25/64 of
an inch (10 mm) thick.
4. After brake pad inspection or
replacement, install the rear
wheels.Some driving conditions or climates
can cause a brake squeal when
the brakes are rst applied or lightly
applied. This does not mean
something is wrong with the brakes.
Properly torqued wheel bolts are
necessary to help prevent brake
pulsation. When tires are rotated,
inspect brake pads for wear and
evenly tighten wheel bolts in
the proper sequence to torque
specications inCapacities
and Specifications on page 10-2.
Brake linings should always
be replaced as complete axle sets.
Brake Pedal Travel
See your dealer/retailer if the brake
pedal does not return to normal
height, or if there is a rapid increase
in pedal travel. This could be a sign
that brake service might be required.
Brake Adjustment
Every time you make a brake stop,
the disc brakes adjust for wear.
9-24 Vehicle Service and Care
ProCarManuals.com

3. Record the distance from the
ground to the aim dot on the
low-beam headlamp.
4. At a wall, measure from the
ground upward (A) to the
recorded distance from Step 3
and mark it.
5. Draw or tape a horizontal line (B)
on the wall the width of the
vehicle at the height of the
mark in Step 4.Notice:Do not cover a headlamp
to improve beam cut-off when
aiming. Covering a headlamp may
cause excessive heat build-up
which may cause damage to the
headlamp.
6. Turn on the low-beam headlamps
and place a piece of cardboard
or equivalent in front of the
headlamp not being adjusted.
Do not place it directly on
the headlamp. This allows only
the beam of light from the
headlamp being adjusted to
be seen on the at surface.7. Locate the vertical headlamp
aiming screws, which are under
the hood near each headlamp
assembly.
The adjustment screw can be
turned with a 6 mm socket
wrench.
8. Turn the vertical aiming screw
until the headlamp beam is aimed
to the horizontal tape line. Turn it
clockwise or counterclockwise
to raise or lower the angle of
the beam.
Vehicle Service and Care 9-27
ProCarManuals.com

S
Safety Belts.......................... 1-8
Care of ...........................1-22
Check.............................1-22
How to Wear Safety
Belts Properly...............1-12
Lap-Shoulder Belt.............1-17
Reminder Light.................4-14
Replacing Parts After
a Crash.......................1-23
Safety Belt Extender.........1-22
Safety Belt Use During
Pregnancy....................1-21
Seats
Head Restraints................. 1-5
Heated Seats - Rear........... 1-6
Height Adjuster.................. 1-2
Lumbar Adjustment............. 1-3
Rear Seat Operation........... 1-7
Reclining Seatbacks............ 1-3
Securing Child
Restraints................1-50, 1-53Service................................ 9-2
Accessories and
Modications.................. 9-3
Adding Equipment to the
Outside of the Vehicle..... 9-4
California Perchlorate
Materials Requirements.... 9-3
California Proposition 65
Warning......................... 9-3
Doing Your Own Work........ 9-4
Engine Soon Light............4-20
Owner Checks................... 9-5
Publications Ordering
Information.................11-14
Vehicle Soon Light............4-24
Service, Scheduling
Appointments...................12-8
Servicing Your
Airbag-Equipped Vehicle....1-34
Sheet Metal Damage............9-78
Shifting Into Park.................8-11
Shifting Out of Park..............8-13
Signals, Turn and
Lane-Change..................... 4-8Spare Tire
Compact.........................9-67
Installing..........................9-62
Removing
........................9-61
Storing............................9-66
Specications, Capacities......10-2
Speedometer.......................4-13
StabiliTrak
®Indicator Light.....4-19
Stabilitrak®System...............8-19
Starting the Engine................ 8-3
Steering..............................8-20
Steering Wheel Controls,
Audio..............................6-24
Steering Wheel, Tilt Wheel...... 4-4
Storage Areas
Cupholders........................ 3-1
Glove Box......................... 3-1
Stuck in Sand, Mud, Ice,
or Snow..........................8-29
Sun Visors..........................2-11
Sunroof..............................2-13
i-8 INDEX
ProCarManuals.com