86A-13
MR-372-J84-86A050$413.mif
V3
86A
RADIO
Fault finding - Replacement of components
For information on removing/refitting the LPN* radio navigation computer, refer to the MR for the vehicle concerned:
–Scénic II ph2 (see MR 370, Mechanical, 83C On-board telematics system, Navigation computer: Removal -
Refitting)
–Espace IV ph2 (see MR 405, Mechanical, 83C, On-board telematics system, Radio navigation:
Removal - Refitting)
–Trafic II ph2 (see MR 408, Mechanical, 83C, On-board telematics system, Radio navigation:
Removal - Refitting)
–Kangoo 2 (see MR 417, Mechanical, 83C On-board telematics system, Radio navigation:
Removal - Refitting)
Operations to be carried out before replacing the LPN* radio navigation computer:
Note:
If the LPN* radio navigation computer and the multimedia network interface unit are replaced
simultaneously, first configure the multimedia network interface unit (see 86D, multimedia network interface
unit, Configuration and programming).
1 -Before replacing the LPN* radio navigation computer (with Techline approval), perform a fault read and a
conformity check to confirm that it is defective.
2 -Before removing, eject the CD.
3 -After obtaining Techline approval, remove the LPN* radio navigation computer with the ignition off (wait
1 minute for the system to shut down completely).
The LPN* radio navigation computers available from the Parts Department are supplied unconfigured.
Operations to be carried out after replacing the LPN* radio navigation computer:
1. Configure the computer (see Configurations and Programming).
The LPN* radio navigation computer is in factory mode following configuration (FM 87.5 MHz in scrambled mode for
2 minutes).
Clear the present or stored faults using command RZ003 Fault memory.
2. Enter the unlocking code for the LPN* radio navigation system
How to obtain the unlocking code for the LPN* radio navigation system:
–switch on + after ignition feed (see Introduction),
–if the LPN* radio navigation system does not switch on when the + after ignition feed is activated, press the ON/
OFF button on the front panel,
–connect the Clip diagnostic tool,
–note the programming key number ID007 Radio programming key shown in the Identification menu.
–When you have this programming key number, consult Renault.net to obtain the LPN* radio navigation system
unlocking code. If the fault is still present, contact Techline.
–The unlocking code is requested 2 minutes after the LPN* radio navigation system has been switched on,
–enter the code using the radio control satellite under the steering wheel.
Important: After activating the system, the delay before establishing dialogue can last 20 seconds.
*LPN: Low Price NavigationNote:
Each time an incorrect code is entered, the waiting time doubles (maximum 32 minutes).
MR-372-J84-86A050$413.mif
LPN RADIO
Vdiag No.: C4
