17C-13
MR-372-J84-17C000$177.mif
V2
17C
GAS INJECTION
Fault finding - Replacement of components
COMPUTER REPLACEMENT OR REPROGRAMMING PROCEDURE
The system can be programmed and reprogrammed via the diagnostic socket using the RENAULT CLIP diagnostic
tool (see Technical Note 3585A or follow the instructions provided by the diagnostic tool).
After reprogramming or replacing the computer:
–Switch the ignition off and then on again.
–Start and run the engine in LPG mode then stop the engine (to initialise the computer) and wait for
30 seconds.
–Switch on the ignition and use the diagnostic tool to carry out the following steps:
–use command VP001 Write VIN,
–after the injection has been reprogrammed, stored faults may appear on other computers. Clear the memories of
these computers,
–carry out a road test followed by another check with the diagnostic tool. IMPORTANT
–switch on the diagnostic tool (mains or cigarette lighter supply),
–connect a battery charger,
–shut down all the electrical consumers (lights, interior lights, air conditioning, radio CD, etc.),
–wait for the engine to cool down (coolant temperature below 60 °C and air temperature below 50 °C).
LPG 3000
Program No: AB
Vdiag No: 08/10
MR-372-J84-17C000$177.mif
