Page 259 of 334
The jack handle must be
unfolded at a right angle before it
is used.
6. Raise the vehicle by turning the
jack handle clockwise 180°.7. Pull the jack handle towards you.
8. Repeat Steps 7 and 8 until the
vehicle is far enough off the
ground so there is enough room
for the compact spare tire to
t under the vehicle.9. Remove all of the wheel nuts
and place them in a dry, clean
place to avoid getting dirt in
the threads.
Vehicle Service and Care 9-75
2008 - Pontiac G8 Owner Manual
Page 260 of 334

{CAUTION
Rust or dirt on a wheel, or on
the parts to which it is
fastened, can make wheel nuts
become loose after time. The
wheel could come off and
cause an accident. When you
change a wheel, remove any
rust or dirt from places where
the wheel attaches to the
vehicle. In an emergency, you
can use a cloth or a paper
towel to do this; but be sure to
use a scraper or wire brush
later, if needed, to get all the
rust or dirt off. SeeChanging a
Flat Tire (V6 Engine) on
page 9-71.10. Remove any rust or dirt from
the wheel bolts, mounting
surfaces and spare wheel.
11. Place the compact spare tire on
the wheel-mounting surface.
{CAUTION
Never use oil or grease on
bolts or nuts. Because the nuts
might come loose. The
vehicle’s wheel could fall off,
causing a crash.
12. Reinstall the wheel nuts with
the rounded end of the nuts
toward the wheel. Tighten each
nut as much as possible
using the wheel wrench until
the wheel is held rmly against
the hub.
Use your free hand to prevent
the wheel from turning while
you are tightening.
13. Lower the vehicle by turning the
jack handle counterclockwise.
Lower the jack completely.
9-76 Vehicle Service and Care
2008 - Pontiac G8 Owner Manual
Page 262 of 334
Storing a Flat or Spare
Tire and Tools
{CAUTION
Storing a jack, a tire, or other
equipment in the passenger
compartment of the vehicle
could cause injury. In a sudden
stop or collision, loose
equipment could strike
someone. Store all these in the
proper place.To store a at or spare tire and
tools, do the following:
A. Jack Handle
B. Nut Cap Tool
C. Wheel Wrench
D. Jack1. Replace the jack and tools as
shown.
2. Turn the retainer nut clockwise to
tighten.
3. Remove the wheel center cap by
pushing it from the back.
4. Place the at tire face up into the
spare tire hub.
5. Turn the retainer nut clockwise to
secure it into place.
6. Put the load oor back in place.
The compact spare tire is for
temporary use only. Replace the
compact spare with a full-size tire as
soon as possible.
9-78 Vehicle Service and Care
2008 - Pontiac G8 Owner Manual
Page 325 of 334