Page 4 of 123
7
FAMILIARISATION
-
OPENING
Doors
Opening / Closing of the front doors. : 59 1.
Locking.
2. Unlocking.
3. Remote locking
(at the same time as the doors).
4. Remote unlocking
(at the same time as the doors).
: 61
Boot
B. Exterior control.
C. Bonnet strut.
: 62
Page 36 of 123
37
AUDIO EQUIPMENT
-
206 AUDIO SYSTEM
Presentation
Y o u r 2 0 6 i s i t t e d w i t h a J B L a u d i o
s y s t e m , d e s i g n e d s p e c i i c a l l y f o r t h e
passenger compartment.
At the heart of the system, a
2 4 0 w a t t m u l t i f u n c t i o n a m p l i i e r
(1) (integrated in the subwoofer in
the boot) independently controls
8 h i g h a c o u s t i c d e i n i t i o n s p e a -
kers and the subwoofer. The speakers are situated:
- in the front door pillars : two
Tweeters (2) for reproduction of
the treble (high frequency) in the
front.
- in the front doors: two Woofers (3) for reproduction
of the bass (low frequencies)
in the front.
- in the rear doors: two Tweeters
(4) set into two Woofers
(5) , providing a balance of
frequencies in the rear.
- in the boot : a Subwoofer
(6) for reproduction of the
bass and ultra-bass (very
low frequencies) throughout
the whole of the passenger
compartment.
You will appreciate the clarity and
depth and notice that the sound
i l l s t h e w h o l e o f t h e v e h i c l e p e r -
fectly.
This system provides optimal re-
production and distribution of the
sound in the vehicle, both in the
front and the rear. Adjusting in CD or Radio mode
The basic functions remain those of
the audio set.
There is no need for any further ad-
justment. However, in order to take
f u l l a d v a n t a g e o f y o u r J B L a u d i o
system, you are advised to set the
AUDIO functions
(BASS, TREB,
FAD, BAL) to position "0" (zero), the
Loudness (LOUD) to the "ON" posi-
tion for CD mode and to the "OFF"
position for radio mode.
Page 59 of 123
57
ACCESS
-
KEYS
The keys allow you to switch on the
ignition and independently operate
the passenger air bag disarming
switch and the steering lock. Locating your vehicle
To locate your vehicle, if you have
locked it, in a car park:
F
press button A, the courtesy
lights come on and the direction
i n d i c a t o r s l a s h f o r a f e w
seconds.
Changing the remote control
battery
Battery ref.: CR2016 / 3 volts.
W a r n i n g t h a t t h e b a t t e r y i s l a t i s
given by an audible signal accompa-
nied by the message "Remote con-
trol battery low" on the multifunction
display.
To replace the battery, remove the
screw then unclip the casing using a
coin at the ring.
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left in
the ignition. Programming the remote
control
F
Switch off the ignition.
F Switch the ignition on again.
F Press button A immediately for a
few seconds.
F Switch off the ignition and
remove the remote control
key from the ignition lock. The
remote control is now working
again.
Without central
locking / unlocking by
hand
The keys also allow you to unlock/
lock the front doors, the boot and the
f u e l i l l e r c a p .
With central locking /
unlocking
The keys allow you to lock or unlock
all of the doors and the tailgate, from
the front doors.
If one of the doors or the tailgate is
open, the central locking does not
work. With central locking /
unlocking via the remote
control
Press button
A to lock the vehicle.
T h i s i s c o n i r m e d b y i x e d l i g h t i n g o f
t h e d i r e c t i o n i n d i c a t o r s f o r a p p r o x i -
mately two seconds.
Press button B to unlock the vehicle.
T h i s i s c o n i r m e d b y t h e r a p i d l a s h -
ing of the direction indicators.
Avoid pressing the buttons of your
remote control out of range of your
vehicle. You risk causing it not to
work and the remote control would
then have to be reprogrammed (see
corresponding section).
Page 63 of 123
ACCESS
60 -
CHILD SAFETY LOCK
On each rear door this prevents
opening of the door from the inside.
Turn switch 1 an eighth turn (45 de-
grees) using the ignition key.
Automatic central locking of the
doors
The doors can lock automatically
when you are driving (at a speed of
more than 6 mph (10 km/h)).
Above 6 mph (10 km/h), press button
B
b r i e l y t o u n l o c k t h e d o o r s t e m p o -
rarily.
You can activate or deactivate this
function. To switch off
Press and hold button
B.
Notes : if one of the doors is open,
locking from the inside and automatic
central locking are not possible.
If the boot is open, automatic central
locking of the doors is possible.
To switch on
Press and hold button
B.
Activation of the function is accompa-
nied by an audible signal and a mes-
sage on the multifunction display.
The message is displayed each time
the vehicle is started.
Page 64 of 123
61
ACCESS
-
LOCKING / UNLOCKING THE
TAILGATE
Without central locking
To lock, turn the key from A to C.
To open, turn the key from A to B,
press the handle then lift the tail-
gate.
TAILGATE RELEASE
This enables the tailgate to be un-
locked in the event of a central lock-
ing fault:
- Fold back the rear seats to gain access to the boot from inside
the vehicle,
- Pull the tailgate trim to release it,
- Pull the opening catch 1 upwards.
"Boot open" warning
If the tailgate is not shut properly:
- with the engine running , you
are warned by an audible signal
and a message or graphic on the
multifunction display,
- when the vehicle is moving ,
t h e c o u r t e s y l i g h t l a s h e s i f t h e
courtesy light button is in this
position.
With central locking
Locking and unlocking of the tailgate
is simultaneous with the doors.
The lighting is activated on open-
ing the tailgate.
Page 75 of 123
71
LAYOUT
-
COURTESY LIGHTS
Map-reading light (button B)
With the key in the accessories or ig-
nition on position, turn button B to the
left or to the right.
AREAS FOR TOLL CARDS/
CAR PARK TICKETS
The athermic windscreen has two
n o n - r e l e c t i v e z o n e s l o c a t e d e i t h e r
side of the base of the interior mirror.
T h e y a r e i n t e n d e d f o r a f i x i n g t o l l
cards and/or car park tickets.
SUN VISOR
T h e s u n v i s o r s a r e i t t e d w i t h a v a n i t y
m i r r o r , w i t h a c o n c e a l i n g l a p o n t h e
driver's side.
Permanently off.
Permanently on when the
key is in the accessories po-
sition or with the ignition on.
Front courtesy light (button A)
In this position, it comes on
for about 30 seconds:
- on unlocking the vehicle,
- when opening a door,
- when opening the tailgate and the rear screen (206 SW),
- on switching off the ignition.
It switches off on locking the vehicle.
T h e c o u r t e s y l i g h t l a s h e s w h i l e d r i v -
ing if a door or the boot is not closed
correctly.
Page 77 of 123
73
LAYOUT
-
Luggage retaining net
U s e t h e s t o w i n g r i n g s o n t h e b o o t l o o r
and on the back of the rear seat to
hook on your luggage retaining net.
There are several options for storing
the shelf:
- either behind the front seats,
- or behind the rear seat using the luggage retaining net,
- o r l a t i n t h e b o o t .
Rear parcel shelf
To remove the shelf:
- unhook the two strings
1,
- slightly raise the shelf, then remove it.
BOOT LAYOUT
Retaining strap
A strap secured to the side of the
boot enables you to secure various
o b j e c t s ( c a n s , i r s t a i d k i t , e t c . ) .
Page 99 of 123
93
PRACTICAL INFORMATION
-
Access to the spare wheel and
the jack
The wheel is located outside the
vehicle, under the boot, supported by
a metal carrier.
- Remove the wheelbrace 1,
secured on the rear right inner
panel of the boot .
- Using the wheelbrace 1, slacken
the spare wheel carrier retaining
bolt, located inside the boot
under the carpet .
- Lift the carrier to release the hook rearwards, then lower it.
- Remove the jack storage box 2 located in the spare wheel.
CHANGING A WHEEL
Removing a wheel
- Chock the rear of the wheel diagonally opposite the wheel
to be changed, using the jack
storage box.
- Remove the wheel trim using the wheelbrace, by pulling at the
valve passage hole.
- Slacken the wheel bolts.
- Place the jack under the locating point on the sub-frame E that
is closest to the wheel to be
changed. Ensure that the entire
surface of the jack base plate is
in contact with the ground.
- Extend the jack, completely unscrew the bolts and remove
the wheel.
Parking the vehicle
- If possible, park the vehicle on
level, stable and non-slippery
ground.
- Apply the handbrake, engage i r s t o r r e v e r s e g e a r ( p o s i t i o n P
for the automatic gearbox).
