REMOTE KEYLESS ENTRY SYSTEM
LOCK DOORS
Press the
button to lock all doors.
UNLOCK DOORS
Press the
button once to unlock the driver’s door
only. Press the button again within 5 seconds to unlock
all doors.
RELEASING TRUNK LID
Press and hold the trunk release button for longer than 0.5 seconds to open the trunk
lid.
USING THE PANIC ALARM
Press and hold the
button for longer than 0.5 seconds. The panic alarm will
sound and the headlights will stay on for 30 seconds. The panic alarm stops when it
has run for 30 seconds or when any button is pressed on the keyfob.
OPENING THE WINDOWS
Windows can be lowered using the keyfob while approaching the vehicle.
Press and hold the
button. The driver’s and passenger’s windows will be lowered.
To stop lowering windows at any time, release the
.
Continue to press and hold the
button until windows are fully open.
SILENCING THE HORN BEEP FEATURE
To deactivate: Press and hold theandbuttons for at least 2 seconds.
To activate: Press and hold the
andbuttons for at least 2 seconds.
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the ON position to
activate the windshield wipers.
Move the lever to the following positions to operate
the windshield wipers:
Intermittent(INT)– Front wipers operate in-
termittently and can be further adjusted by
twisting the time control ring
.
Low Speed(LO)– Continuous low-speed
operation of front wipers.
High Speed(HI)– Continuous high-speed
operation of front wipers.
2
Mist(MIST)– Lift the lever up for one sweep of the front wipers.
Rear Wipers(REAR)– Twist the end section to operate the first(INT)or second
(ON)speed settings for the rear wipers.
The washer function activates the washer fluid and several sweeps of the wipers:
●For FRONT WASHER, pull lever toward you.
●For REAR WIPER, push lever away from you.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT CONTROL SWITCH
Turn the headlight control switchto the
position to turn on the front parking, tail, license plate
and instrument panel lights.
Turn the headlight control switch
to thepo-
sition to turn on the headlights. All other lights remain
on.
FOG LIGHT OPERATION
NOTE: The headlights must be on and the low beams selected for the fog lights to operate.
Turn the switch (inside collar)
to theposition to turn on the fog lights.
Turn the switch (inside collar)
to theOFFposition to turn off the fog lights.
TURN SIGNAL SWITCH
Move the headlight control switch up or downto
signal a turning direction. When the turn is completed,
the turn signals cancel automatically.
To signal a lane change, move the headlight control
switch up or down
to the point where the indica-
tor light begins to flash, but the headlight control switch
does not latch.
HIGH BEAM
Push the headlight control switch forwardto
select the high beam function. The blue
indicator
light illuminates. Pull the headlight switch back to the
original position to select the low beam. The blue
indicator light goes off.
Pull and release the headlight control switch
to flash the headlight high beams on
and off.
3
