2008 MITSUBISHI GRANDIS low beam

Overview
Exterior
E00100502128
Sunroof* p. 1-20
Side turn-signal lamps
p. 3-37, 8-44 Fuel tank filler p. 3
Outside rear-view mirrors
p. 4-10 Antenna p. 5-52
Front fog lamps
p. 3-39, 8-44, 8-52
Front turn-signal lamps
p. 3-37, 8-44, 8-51Bonnet p. 8-4 Windscreen wipers p. 3-41
Headlamps, high beam
p. 3-32, 8-44, 8-45Position lamps
p. 3-32, 8-44, 8-51 Headlamps, low beam
p. 3-32, 8-44, 8-45
BK-XP08E1ENUK.en-uk.book Page 10 Monday, August 13, 2007 2:20 PM

3-8 Instruments and controls
3Indicator and warning lamps
E00501501337
1- CRUISE indication lamp* → p. 4-46
2- ASC indication lamp* → p. 4-43
3- Turn-signal indication lamps/Hazard warning indication
lamps → p. 3-9
4- Rear fog lamp indication lamp → p. 3-9
5- Front fog lamp indication lamp → p. 3-9
6- High-beam indication lamp → p. 3-9
7- Diesel particulate filter (DPF) warning lamp (diesel-
powered vehicles)* → p. 4-21
8- Position lamp indication lamp → p. 3-9
9- Automatic headlamp levelling warning lamp* → p. 3-35
10- Diesel preheat indication lamp (diesel-powered vehicles)
→ p. 3-9
11- Charge warning lamp → p. 3-13
12- Oil pressure warning lamp → p. 3-1413- Check engine warning lamp → p. 3-11
14- TCL OFF indication lamp* → p. 4-43
15- SONAR OFF indication lamp* → p. 4-57
16- Anti-lock brake system (ABS) warning lamp → p. 4-38
17- Brake warning lamp → p. 3-10
18- Seat belt reminder/warning lamp → p. 2-35
19- Sports mode indication lamp (vehicles with A/T) → p. 4-32
20- Selector lever position indication lamps
(vehicles with A/T, “N” indication lamp is used also as A/T
warning lamp) → p. 4-28
21- Supplemental restraint system (SRS) warning lamp
→ p. 2-76
22- Door-ajar warning lamp → p. 3-14
23- Low fuel warning lamp → p. 3-6
BK-XP08E1ENUK.en-uk.book Page 8 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-9
3 Indicator lamps
E00501600012
Turn-signal indication lamps/Hazard
warning indication lamps
E00501700169
These indication lamps blink on and off when a
turn-signal lamp is operating.NOTE●If the blinking is too fast, the cause may be
a faulty turn-signal connection or a blown
lamp bulb.
When the hazard warning lamp switch is
pressed, all turn-signal lamps will flash on and
off continuously.High-beam indication lamp
E00501800160
This indication lamp illuminates when the high
beam is used.Front fog lamp indication lamp
E00501900321
This lamp illuminates while the front fog lamps
are on.
Rear fog lamp indication lamp
E00502000101
This lamp illuminates while the rear fog lamp is
on.Position lamp indication lamp
E00508900102
This lamp illuminates with the lamp switch at
“ ” or “ ” positionDiesel preheat indication lamp
(diesel-powered vehicles)
E00502300061
This indication lamp illuminates when the igni-
tion switch is placed in the “ON” position. As
the glow plug becomes hot, the lamp goes out
and the engine can be started. If it does not go off
after a few seconds, we recommend you to have
the vehicle checked.NOTE●If the engine is cold, the diesel preheat indi-
cation lamp is on for a longer time.
●When the engine has not been started within
about 5 seconds after the diesel preheat
indication lamp went out, return the ignition
switch to the “LOCK” position. Then, turn
the switch to the “ON” position to preheat
the engine again.
BK-XP08E1ENUK.en-uk.book Page 9 Monday, August 13, 2007 2:20 PM

3-32 Instruments and controls
3Combination headlamps and dipper switch
E00506000776
HeadlampsRotate the switch to turn on the lamps.
NOTE●Do not leave the headlamps and other lamps on for a long
while the engine is stationary. A run-down battery could
result.
●When it rains, or when the vehicle has been washed, the
inside of the lens sometimes becomes foggy. This is the
same phenomenon as when window glass mists up on a
humid day, and does not indicate a functional problem.
When the lamp is switched on, the heat will remove the
fog. However, if water gathers inside the lamp, we recom-
mend you to have it checked.[Vehicles with Daytime Running Lamp]When the ignition switch is in the “ON” position and the lamp
switch is set to the “OFF” position, the low beam of the head-
lamps, tail lamps, etc., will illuminate.
OFF All lamps off
Position, tail, licence plate and instrument panel lamps on
Headlamps and other lamps go onBK-XP08E1ENUK.en-uk.book Page 32 Monday, August 13, 2007 2:20 PM

3-34 Instruments and controls
3
Dipper (High/Low beam change)
E00506200114
When the lamp switch is in the “ ” position, the beam
changes from high to low (or low to high) each time the lever is
pulled to (1). While the high beam is on, the high beam indica-
tor lamp in the instrument cluster will also illuminate.
Headlamp flasher
E00506300027
The high beams flash when the lever is pulled slightly to (2),
and will go off when it is released.
When the high beam is on, the high beam indicator lamp in the
instrument cluster will also illuminate.NOTE●The high beams can also flash when the lamp switch is
OFF.
●If you turn the lamps off with the headlamps set to high-
beam illumination, the headlamps are automatically
returned to their low-beam setting when the lamp switch
is next turned to the “ ” position.
BK-XP08E1ENUK.en-uk.book Page 34 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-35
3 Headlamp levelling
E00506400594
Headlamp levelling switch*Except for vehicles with discharge headlampsThe angle of the headlamp beam varies depending upon the
load carried by the vehicle.
The headlamp levelling switch can be used to adjust the head-
lamp illumination distance (when the lower beam is illumi-
nated) so that the headlamps’ glare does not distract the drivers
of approaching vehicles.
Set the switch (referring to the following table) to the appropri-
ate position according to the number of people and the load in
the vehicle.<6-person seat>


●:1 person
: Full luggage loadingVe h i c l e
conditionSwitch
position“0” “1” “2” “3” “4”
Switch position 0- Driver only/Driver + 1 front passenger
Switch position 1- Driver + 1 front passenger + 2 third seat pas-
sengers
Switch position 2- All passengers
Switch position 3- All passengers + Full luggage loading
Switch position 4- Driver + Full luggage loading
BK-XP08E1ENUK.en-uk.book Page 35 Monday, August 13, 2007 2:20 PM

3-40 Instruments and controls
3
●In case of vehicles with Daytime Running Lamp, the front
fog lamps can be operated even if the lamp switch is set to
the “OFF” position, because the low beam of the head-
lamps, tail lamps, etc. illuminate when the ignition key is
at the “ON” position.Rear fog lamp switch
E00508400237
The rear fog lamp can be operated when the headlamps or front
fog lamps are on. Push the switch to turn on the rear fog lamp,
and push the switch again to turn it off.
The indication lamp in the instrument cluster will illuminate
while the rear fog lamp is on.
NOTE●The rear fog lamp is automatically turned off when the
headlamps and front fog lamps are turned off. To turn on
the rear fog lamp again, push the switch again when the
headlamps or front fog lamps are on.
●In case of vehicles with Daytime Running Lamp, the rear
fog lamp can be operated even if the lamp switch is set to
the “OFF” position, because the low beam of the head-
lamps, tail lamps, etc. illuminate when the ignition key is
at the “ON” position.
BK-XP08E1ENUK.en-uk.book Page 40 Monday, August 13, 2007 2:20 PM

Starting and driving
4-15
4
NOTE●This vehicle is equipped with ignition switch illumination.
• The ignition switch illumination comes on while the
driver’s door is opened and remains on for about 30 sec-
onds after the driver’s door is closed.
• [On vehicles with keyless entry system]
When you get out of the vehicle and remove the ignition
key, it will be illuminated for about 30 seconds.
However, it will go off even while the illumination
comes on if the ignition switch is set to “ON” position.
●For vehicles equipped with the Daytime Running Lamp,
when the ignition switch is in the “ON”, the headlamp low
beams etc. are turned on.
Refer to “Headlamps” on page 3-32.
●Your vehicle is equipped with an electronic immobilizer.
To start the engine, the ID code which the transponder
inside the key sends must match the one registered to the
immobilizer computer. (Refer to “Electronic immobilizer
(Anti-theft starting system)” on page 1-3.)
To remove the keyFor vehicles with M/T, when removing the key, push in the key
at the “ACC” position and keep it depressed until it is turned to
the “LOCK” position, then remove the key.M/T
BK-XP08E1ENUK.en-uk.book Page 15 Monday, August 13, 2007 2:20 PM