2008 MITSUBISHI GRANDIS battery

1-6 Locking and unlocking
1
Operation of the outside rear-view mirrorsTo f o l dWithin 30 seconds of locking the doors and tailgate using the
LOCK switch (1), press the LOCK switch twice rapidly to fold
the door mirrors.To e x t e n dWithin 30 seconds of unlocking the doors and tailgate using the
UNLOCK switch (2), press the UNLOCK switch twice rapidly
to return the door mirrors to their extended positions.NOTE●The keyless entry system does not operate in the follow-
ing conditions:
• The key is left in the key cylinder.
• The door or tailgate is open.
●The remote control switch will operate within about 4 m
from the vehicle. However, the operating range of the
remote control switch may change if the vehicle is located
near a TV transmitting tower, power station, or radio
broadcasting station.
●If either of the following problems occurs, the battery may
be exhausted. Have the battery replaced by a MITSUBI-
SHI MOTORS Authorized Service Point.
• The remote control switch is operated at the correct dis-
tance from the vehicle, but the doors and tailgate are not
locked/unlocked in response.
• The indication lamp (3) is dim or does not come on.●If your remote control switch is lost or damaged, please
contact your MITSUBISHI MOTORS Authorized Service
Point for a replacement remote control switch.
●If you wish to add remote control switch, we recommend
that you contact your MITSUBISHI MOTORS Author-
ized Service Point.
A maximum of 4 remote control switches are available for
your vehicle.
BK-XP08E1ENUK.en-uk.book Page 6 Monday, August 13, 2007 2:20 PM

Locking and unlocking
1-13
1
To openPull the tailgate handle upward to open the tailgate.NOTE●If you do not open the tailgate immediately after pulling
the handle, the tailgate will automatically be relocked.
If this happens, pull the handle again and lift the tailgate
with the handle still pulled.
●The tailgate cannot be opened when the battery is flat or
disconnected.
To closePull the tailgate grip (A) downward as illustrated and release it
before the tailgate closes completely. Gently slam the tailgate
from the outside so that it is completely closed.
CAUTION
!●Make sure there is no one standing nearby when
opening the tailgate.
BK-XP08E1ENUK.en-uk.book Page 13 Monday, August 13, 2007 2:20 PM

Locking and unlocking
1-15
1 Inside tailgate release
E00303400041
The inside tailgate release is designed to provide a way to open
the tailgate in the case of discharged battery.
The tailgate release lever (see illustration) is mounted on the
tailgate.
You and your family should familiarize yourselves with the
location and operation of the tailgate release lever.
To open1. Open the lid (A) inside of the tailgate.
BK-XP08E1ENUK.en-uk.book Page 15 Monday, August 13, 2007 2:20 PM

Locking and unlocking
1-17
1
NOTE●Repeated operation with the engine stopped will run down
the battery. Operate the window switches only while the
engine is running.Driver’s switchesThe driver’s switches can be used to operate all door windows.
A window can be opened or closed by operating the corre-
sponding switch.
Press the switch down to open the window, and pull up the
switch to close it.
If the switch is fully pressed down/pulled up, the door window
automatically opens/closes completely.
If you want to stop the window movement, operate the switch
lightly in the reverse direction.
1- Driver’s door window
2- Front passenger’s door window
3- Rear left door window
4- Rear right door window
5- Lock switch
WARNING
!●Before operating the electric window control, make
sure that nothing is capable of being trapped (head,
hand, finger, etc.).●Never leave the vehicle without removing the key.●Never leave a child (or other person who might not
be capable of safe operation of the electric window
control) in the vehicle alone.Driver’s switch (RHD)
BK-XP08E1ENUK.en-uk.book Page 17 Monday, August 13, 2007 2:20 PM

1-24 Locking and unlocking
1
NOTE●The sunroof stops just before reaching the fully open posi-
tion.
If the vehicle is driven with the sunroof in this position,
wind throbs is lower than with the sunroof fully open.
●When leaving the vehicle unattended, make sure you
close the sunroof and remove the ignition key.
●Do not try to operate the sunroof if it is frozen closed
(after snow fall or during extreme cold).
●Do not sit or place heavy luggage on the sunroof or roof
opening edge.●Release the switch as soon as the sunroof reaches the fully
open or fully closed position.
●If the sunroof does not operate when the sunroof switch is
operated, release the switch and check whether something
is trapped by the sunroof. If nothing is trapped, we recom-
mend you to have the sunroof checked.
●Depending on the models of ski carriers or roof carriers,
the sunroof may contact with the carrier when the sunroof
is tilted up. Be careful when tilting up the sunroof if such
a ski carrier or a roof carrier is installed.
●Be sure to close the sunroof completely when washing the
vehicle or when leaving the vehicle.
●Be careful, not to put any wax on the weatherstrip (black
rubber) around the sunroof opening. If stained with wax,
the weatherstrip cannot maintain a weatherproof seal with
the sunroof.
●After washing the vehicle or after it has rained, wipe off
any water that is on the sunroof before operating it.
●Operating the sunroof repeatedly with the engine station-
ary will run down the battery. Operate the sunroof while
the engine is running.
WARNING
!●Do not put head, hands or anything else out of the
sunroof opening while driving the vehicle.●Never leave a child (or other person who might not
be capable of safe operation of the sunroof switch) in
the vehicle alone.●Before operating the sunroof, make sure that noth-
ing is capable of being trapped (head, hand, finger,
etc.).
CAUTION
!●The safety mechanism is cancelled just before the
sunroof is fully closed. This allows the sunroof to
close completely.
Therefore be especially careful that no fingers are
trapped in the sunroof.
BK-XP08E1ENUK.en-uk.book Page 24 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-5
3
NOTE●Display TRIP and each have a maximum distance
of 999.9 km (999.9 miles).
●Even when the ignition switch has been turned to the
“LOCK” position, pressing the tripmeter reset button
causes the odometer/tripmeter indication to appear for
approximately 30 seconds.
●When disconnecting the battery terminal for a long time,
the memory of tripmeter display TRIP and are
cleared, and the display returns to “0”.
Fuel gauge
E00500700481
The fuel gauge indicates the fuel level in the fuel tank when the
ignition switch is “ON”.Fuel lid markThe fuel lid mark (A) indicates that the fuel tank filler door is
located on the left side of the vehicle (Refer to “Filling the fuel
tank” on page 3).1- Full
0- Empty
CAUTION
!●For petrol-powered vehicles, do not drive with an
extremely low fuel level; running out of fuel could
cause damage to the catalytic converter.
BK-XP08E1ENUK.en-uk.book Page 5 Monday, August 13, 2007 2:20 PM

3-12 Instruments and controls
3
NOTE●The engine electronic control module
accommodating the onboard diagnostic sys-
tem has various fault data (especially about
the exhaust emission) stored.
This data will be erased if a battery cable is
disconnected which will make a rapid diag-
nosis difficult. Do not disconnect a battery
cable when the check engine warning lamp
is ON.
Check engine warning lamp (diesel-
powered vehicles)
E00502600628
This lamp is a part of an onboard diagnostic sys-
tem which monitors the emissions control sys-
tems.
If a problem is detected in one of these systems,
this lamp illuminates.
Although your vehicle will usually be drivable
and not need towing, we recommend you to have
the system checked as soon as possible.
This lamp will also illuminate for a few seconds
when the ignition key is turned to the “ON” posi-
tion. If it does not go off after a few seconds, we
recommend you to have the vehicle checked.
●If the lamp illuminates or flashes while
the engine is running, avoid driving at
high speeds and we recommend you to
have the system checked.
During vehicle operation with the
lamp illuminated or flashing, the vehi-
cle may not accelerate when you
depress the accelerator pedal.
When the vehicle is stationary with the
lamp illuminated or flashing, you must
depress the brake pedal more firmly
than usual since the engine idling
speed is higher than usual and the
vehicle with an A/T has a stronger ten-
dency to creep forward.
CAUTION
!
CAUTION
!●Prolonged driving with this lamp on
may cause further damage to the emis-
sion control system. It could also affect
fuel economy and drivability.●If the lamp does not illuminate when
the ignition key is turned to the “ON”
position, we recommend you to have
the system checked.
BK-XP08E1ENUK.en-uk.book Page 12 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-13
3
NOTE●The engine electronic control module
accommodating the onboard diagnostic sys-
tem has various fault data (especially about
the exhaust emission) stored.
This data will be erased if a battery cable is
disconnected which will make a rapid diag-
nosis difficult. Do not disconnect a battery
cable when the check engine warning lamp
is ON.
Charge warning lamp
E00502700300
This lamp illuminates when the ignition key is
turned “ON”, and the lamp goes off after the
engine has started.
●If the lamp illuminates while the
engine is running, avoid driving at
high speeds and we recommend you to
have the system checked.
During vehicle operation with the
lamp illuminated, the vehicle may not
accelerate when you depress the accel-
erator pedal.
When the vehicle is stationary with the
lamp illuminated, you must depress
the brake pedal more firmly than usual
since the engine idling speed is higher
than usual.
CAUTION
!
CAUTION
!●If it illuminates while the engine is run-
ning, there is a problem in the charg-
ing system. In this case, immediately
park your vehicle in a safe place and
we recommend you to have it checked.
BK-XP08E1ENUK.en-uk.book Page 13 Monday, August 13, 2007 2:20 PM