2008 MITSUBISHI GRANDIS MPG

3-22 Instruments and controls
3
Change of driving information (For vehicles with MIT-
SUBISHI MOTORS genuine audio)
E00509100068
Every time the “DISP” button is pressed lightly (less than
5 seconds), the display can be changed.
Momentary fuel consumption → Average fuel consumption →
Driving range → Average speed
Momentary fuel consumption
E00509200014
This value shows the momentary fuel consumption (in
L/100km, km/L or mpg). Calculation and indication of the
value begin when the vehicle speed rises above
6km/h(4mph).
BK-XP08E1ENUK.en-uk.book Page 22 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-23
3
Average fuel consumption
E00509300060
This value shows the average fuel consumption (in L/100 km,
km/L or mpg).NOTE●When the ignition switch is turned on, the average fuel
consumption which was being displayed when the igni-
tion switch was previously turned off will be displayed
once again.
●Average fuel consumption varies according to the condi-
tions under which a vehicle is travelling (road conditions,
the manner in which the vehicle is being driven, etc.).
Observe this display for reference because the fuel con-
sumption display may differ from the actual fuel con-
sumption.To r e s e t t h e d i s p l a y
You can switch from the automatic reset mode to the manual
reset mode by performing the following operations:
1. Press and hold down button (A), then press the “SET”
button (B) within 1 second, and a buzzer will sound and
the reset mode will be changed.
BK-XP08E1ENUK.en-uk.book Page 23 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-31
3
Use the “H” button (C) or “M” button (B) to choose your
desired time display format, and then press the “SET” but-
ton (D) to enter the setting.5. The display will return to the original display item.
NOTE●If you selected the mile unit in step 2, the speed and fuel
consumption units will be as follows.
• Speed: mph (miles per hour)
• Fuel consumption: mpg (miles per gallon)
●To cancel the unit setting procedure before completion,
press the button (A).
●The outside temperature and digital clock are not shown
during the unit selecting procedure.
●If the “SET” button is not pressed for about 15 seconds or
longer in the middle of the selection, the currently
selected unit is set automatically. Then, the display returns
to the original display item.
H - 12-hour format
M - 24-hour format
BK-XP08E1ENUK.en-uk.book Page 31 Monday, August 13, 2007 2:20 PM