2008 MITSUBISHI GRANDIS engine

OXPE08E1
(9290B529)
BL070680
© 2007 Mitsubishi Motors Corporation
Mitsubishi Motors Europe B.V.
ForewordE09200101831
Thank you for selecting a GRANDIS as your new vehicle.
This owner’s manual will add to your understanding and full
enjoyment of the many fine features of this vehicle.
It contains information prepared to acquaint you with the
proper way to operate and maintain your vehicle for the utmost
in driving pleasure.
MITSUBISHI MOTORS Europe B.V. reserves the right to
make changes in design and specifications and/or to make
additions to or improvements in this product without obligation
to install them on products previously manufactured.
It is an absolute requirement for the driver to strictly observe
all laws and regulations concerning vehicles.
This owner’s manual has been written in compliance with
such laws and regulations, but some of the contents may
become contradictory with later amendment of the laws and
regulations.
Please leave this owner’s manual in this vehicle at time of
resale. The next owner will appreciate having access to the
information contained in this owner’s manual.
Repairs to your vehicle:
Vehicles in the warranty period:
All warranty repairs must be carried out by a MITSUBISHI MOTORS
Authorized Service Point.
Vehicles outside the warranty period:
Where the vehicle is repaired is at the discretion of the owner.Throughout this owner’s manual the words WARNINGand
CAUTIONappear.
These serve as reminders to be especially careful. Failure to follow
instructions could result in personal injury or damage to your vehicle.
indicates a strong possibility of severe personal injury or
death if instructions are not followed.
means hazards or unsafe practices that could cause minor
personal injury or damage to your vehicle.
You will see another important symbol:
NOTE: gives helpful information.
*: indicates optional equipment.
It may differ according to the sales classification; refer to
the sales catalogue.
Abbreviations used in this owner’s manual:
LHD: Left-Hand Drive
RHD: Right-Hand Drive
M/T: Manual Transmission
A/T: Automatic Transmission
WARNING
CAUTION
Information for station service
E09300101526
Fuel tank capacity 65 litres
Petrol-powered vehicles
Unleaded petrol octane number (EN 228)
Fuel95 RON or higher
Fuel requirementsDiesel-powered vehicles
Cetane number (EN 590)
51 or higher
Refer to the “General information” section for the fuel selection.
Engine oil Refer to the “Maintenance” section for the selection of engine oil.
Tyre inflation pressure Refer to the “Maintenance” section for the tyre inflation pressure.
8
eng270680_XP08_cv 05-07-2007 12:31 Page 2

General information
Fuel selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Filling the fuel tank . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation of accessories . . . . . . . . . . . . . . . . . . . . 5
Modification/alterations to the electrical
or fuel systems . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Genuine parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Used engine oils safety instructions and
disposal information . . . . . . . . . . . . . . . . . . . . . . . 7
BK-XP08E1ENUK.en-uk.book Page 1 Monday, August 13, 2007 2:20 PM

2 General information
Fuel selection
E00200101388
NOTE●Petrol-powered vehicles have the knock control system so
that you can use unleaded petrol 90 RON as an emergent
measure in case unleaded petrol 95 RON or higher is not
available on journey, etc. In such a case, you don’t need to
adjust the engine specially.
In case of using unleaded petrol 90 RON, the engine per-
formance level is reduced.●Repeatedly driving short distance at low speeds can cause
deposits to form in the fuel system and engine, resulting in
poor starting and poor acceleration. If these problems
occur, you are advised to add a detergent additive to the
gasoline when you refuel the vehicle. The additive will
remove the deposits, thereby returning the engine to a nor-
mal condition. Be sure to use a genuine MITSUBISHI
FUEL SYSTEM CLEANER. Using an unsuitable addi-
tive could make the engine malfunction. For details,
please contact your MITSUBISHI MOTORS Authorized
Service Point.
●Poor quality petrol can cause problems such as hard start-
ing, stalling, engine noise and hesitation. If your experi-
ence these problems, try another brand and/or grade of
petrol.
If the check engine warning lamp flashes, have the system
checked as soon as possible at a MITSUBISHI MOTORS
Authorized Service Point.Recom-
mended fuelPetrol-powered vehicles
Unleaded petrol octane number (EN228)
95 RON or higher
Diesel-powered vehicles
Cetane number (EN590)
51 or higher
CAUTION
!●For petrol-powered vehicles, the use of leaded fuel
can result in serious damage to the engine and cata-
lytic converter. Do not use the leaded fuel.●Diesel-powered vehicles are designed to use only die-
sel fuel that meets the EN 590 standard.
Use of any other type of diesel fuel would adversely
affect the engine’s performance and durability.
BK-XP08E1ENUK.en-uk.book Page 2 Monday, August 13, 2007 2:20 PM

General information
3
Filling the fuel tank
E00200200698
Fuel tank capacity65 litresRefuelling1. Before filling with fuel, stop the engine.
2. The fuel tank filler is located on the rear left side of your
vehicle.
The fuel tank filler door can be opened from inside the
vehicle with the fuel tank filler door release lever located
below the instrument panel.
WARNING
!●Gasoline is highly flammable and explosive. You
could be burned or seriously injured when handling
it. When refuelling your vehicle, always turn the
engine off and keep away from flames, sparks, and
smoking materials. Always handle fuel in well-venti-
lated outdoor areas.●Before removing the fuel cap, be sure to get rid of
your body’s static electricity by touching a metal
part of the car or fuel pump. Any static electricity on
your body could create a spark that ignites fuel
vapour.●Perform the whole refuelling process (opening the
fuel tank filler door, removing the fuel cap, etc.) by
yourself. Do not let any other person come near the
fuel tank filler. If you allowed a person to help you
and that person was carrying static electricity, fuel
vapour could be ignited.●Do not move away from the fuel tank filler until
refuelling is finished. If you moved away and did
something else (for example, cleaning your wind-
screen) part-way through the refuelling process, you
could pick up a fresh charge of static electricity.●Be careful not to inhale fuel vapour. Fuel contains
toxic substances.●Keep the doors and windows closed while refuelling
the vehicle. If they were open, fuel vapour could get
into the cabin.
LHD
BK-XP08E1ENUK.en-uk.book Page 3 Monday, August 13, 2007 2:20 PM

General information
5
4. To fill with fuel correctly depends mainly on correct han-
dling of the fuel filler gun. Do not tilt the gun. Insert the
gun in the tank port as far as it goes.
5. When the gun stops automatically, remove the gun half
the way in the tank port. After the second automatic stop,
do not fill with fuel any more.
6. To close, turn the fuel tank filler tube cap slowly clock-
wise until you hear clicking sounds, then gently push the
fuel tank filler door closed.
Installation of accessories
E00200300745
We recommend you to consult your MITSUBISHI MOTORS
Authorized Service Point.
●The installation of accessories, optional parts, etc., should
only be carried out within the limits prescribed by law in
your country, and in accordance with the guidelines fitting
instructions and warnings contained within the documents
accompanying the parts or accessories.
●Improper installation of electrical components may cause
an electrical fire if incorrectly fitted. Please refer to the
Modification/alteration to the electrical or fuel systems
section within this owner’s manual.
●Using a cellular phone or radio set inside the vehicle with-
out an external antenna may cause electrical system inter-
ference, which could lead to unsafe vehicle operation.
●Tyres and wheels which do not meet specifications must
not be used.
Refer to the “Specifications” section for information
regarding wheel and tyre sizes.
CAUTION
!●A label which reads “UNLEADED FUEL ONLY” is
attached to the fuel tank filler lid of vehicles which
can only operate using unleaded petrol. Serious
engine and catalytic converter damage will result if
leaded petrol is filled into these vehicles, and conse-
quently, this must never be attempted.
CAUTION
!●To avoid fuel spillage and overfilling, do not “top-
off” the fuel tank.
CAUTION
!●If you need to replace the fuel tank filler tube cap,
use only the cap specified for your model vehicle.
BK-XP08E1ENUK.en-uk.book Page 5 Monday, August 13, 2007 2:20 PM

General information
7
Genuine parts
E00200500330
MITSUBISHI MOTORS has gone to great lengths to bring you
a superbly crafted automobile offering the highest quality and
dependability.
Use MITSUBISHI MOTORS genuine parts, designed and
manufactured to maintain your MITSUBISHI MOTORS auto-
mobile at top performance. MITSUBISHI MOTORS genuine
parts are identified by this mark and are available at all MIT-
SUBISHI MOTORS Authorized Service Points.
Used engine oils safety instructions and
disposal information
E00200600025
Protect the environmentIt is illegal to pollute drains, water courses and soil. Use
authorized waste collection facilities, including civic amenity
sites and garages providing facilities for disposal of used oil
and used oil filters. If in doubt, contact your local authority for
advice on disposal.
WARNING
!●Prolonged and repeated contact may cause serious
skin disorders, including dermatitis and cancer.●Avoid contact with the skin as far as possible and
wash thoroughly after any contact.●Keep used engine oils out of reach of children.
BK-XP08E1ENUK.en-uk.book Page 7 Monday, August 13, 2007 2:20 PM

Locking and unlocking
1-3
1
• Keep away from audio systems, personal computers,
TVs, and any other equipment that generates a magnetic
field.
• Do not wash with ultrasonic cleaners or similar equip-
ment.
• Do not leave the key where it may be exposed to high
temperature or high humidity.
●The engine is designed so that it will not start if the ID
code registered in the immobilizer computer and the key’s
ID code do not match. Refer to the section entitled “Elec-
tronic immobilizer” for details and key usage.
Keys should never be placed in areas which contain mag-
netic or metal objects as this may interfere with the trans-
ponder.
Electronic immobilizer
(Anti-theft starting system)
E00300201003
The electronic immobilizer is designed to reduce significantly
the possibility of vehicle theft. The purpose of the system is to
immobilize the vehicle if an invalid start is attempted. A valid
start attempt can only be achieved (subject to certain condi-
tions), using a key “registered” to the immobilizer system.NOTE●In the following cases, the vehicle may not be able to
receive the registered ID code from the key. This means
the engine will not start even when the registered key is
turned to the “START” position.
• When the key contacts a key ring or other metallic or
magnetic object (Type A)
• When the key grip contacts metal of another key
(Type B)
• When the key contacts or is close to other immobilizing
keys (including keys of other vehicles) (Type C)
In cases like these, remove the object or additional key
from the vehicle key and turn the key back to the “ACC”
or “LOCK” position. Then try again to start the engine.
If the engine does not start, we recommend you to con-
tact your MITSUBISHI MOTORS Authorized Service
Point.
BK-XP08E1ENUK.en-uk.book Page 3 Monday, August 13, 2007 2:20 PM

Locking and unlocking
1-17
1
NOTE●Repeated operation with the engine stopped will run down
the battery. Operate the window switches only while the
engine is running.Driver’s switchesThe driver’s switches can be used to operate all door windows.
A window can be opened or closed by operating the corre-
sponding switch.
Press the switch down to open the window, and pull up the
switch to close it.
If the switch is fully pressed down/pulled up, the door window
automatically opens/closes completely.
If you want to stop the window movement, operate the switch
lightly in the reverse direction.
1- Driver’s door window
2- Front passenger’s door window
3- Rear left door window
4- Rear right door window
5- Lock switch
WARNING
!●Before operating the electric window control, make
sure that nothing is capable of being trapped (head,
hand, finger, etc.).●Never leave the vehicle without removing the key.●Never leave a child (or other person who might not
be capable of safe operation of the electric window
control) in the vehicle alone.Driver’s switch (RHD)
BK-XP08E1ENUK.en-uk.book Page 17 Monday, August 13, 2007 2:20 PM