Page 357 of 489

356 Practical hints
What to do if …
Warning!G
Each tire, including the spare (if provided),
should be checked monthly when cold and
inflated to the inflation pressure recom-
mended by the vehicle manufacturer on the
Tire and Loading Information placard on the
driver’s door B-pillar (
page 294) or, if
available, the tire inflation pressure label on
the inside of the fuel filler flap (
page 279).
If your vehicle has tires of a different size
than the size indicated on the Tire and Load-
ing Information placard or, if available, the
tire inflation pressure label, you should de-
termine the proper tire inflation pressure for
those tires.
As an added safety feature, your vehicle has
been equipped with a tire pressure monitor-
ing system (TPMS) that illuminates a low tire
pressure telltale when one or more of your
tires is significantly underinflated.
Accordingly, when the low tire pressure tell-
tale illuminates, you should stop and check
your tires as soon as possible, and inflate
them to the proper pressure. Driving on a
significantly underinflated tire causes the
tire to overheat and can lead to tire failure.
Underinflation also reduces fuel efficiency
and tire tread life, and may affect the vehi-
cle’s handling and stopping ability. Please
note that the TPMS is not a substitute for
proper tire maintenance, and it is the driv-
er’s responsibility to maintain correct tire
pressure, even if underinflation has not
reached the level to trigger illumination of
the TPMS low tire pressure telltale.USA only:
Your vehicle has also been equipped with a
TPMS malfunction indicator to indicate
when the system is not operating properly.
The TPMS malfunction indicator is com-
bined with the low tire pressure telltale.
When the system detects a malfunction, the
telltale will flash for approximately
one minute and then remain continuously
illuminated. This sequence will continue
upon subsequent vehicle start-ups as long
as the malfunction exists. When the mal-
function indicator is illuminated, the system
may not be able to detect or signal low tire
pressure as intended.
TPMS malfunctions may occur for a variety
of reasons, including the installation of
replacement or alternate tires or wheels on
the vehicle that prevent the TPMS from
functioning properly. Always check the
TPMS malfunction telltale after replacing
one or more tires or wheels on your vehicle
to ensure that the replacement or alternate
tires and wheels allow the TPMS to continue
to function properly.
Page 360 of 489

359 Practical hints
What to do if …
Vehicle status messages in the multi-
function display
Warning and malfunction messages
appear in the in the multifunction display
located in the instrument cluster.
Certain warning and malfunction mes-
sages are accompanied by an audible
signal.
Address these messages accordingly and
follow the additional instructions given in
this Operator’s Manual.
Selecting the vehicle status message
memory menu in the control system
(
page 156) displays both cleared and
uncleared messages.
High-priority messages appear in the mul-
tifunction display in red color.Certain messages of high priority cannot
be cleared from the multifunction display
using the reset button (
page 26) or
button j, k, ÿ, or è on the
multifunction steering wheel.
Other messages of high priority and mes-
sages of less immediate priority can be
cleared from the multifunction display us-
ing the reset button or button j, k,
ÿ, or è on the multifunction steer-
ing wheel. They are then stored in the vehi-
cle status message memory (
page 156).
Remember that clearing a message will not
correct the condition that caused the mes-
sage to appear.
Warning!G
All categories of messages contain impor-
tant information which should be taken note
of and, where a malfunction is indicated,
addressed as soon as possible at an autho-
rized Mercedes-Benz Center.
Failure to repair condition noted may cause
damage not covered by the Mercedes-Benz
Limited Warranty, or result in property
damage or personal injury.
Page 362 of 489

361 Practical hints
What to do if …
Text messages
Left displayRight displayPossible cause/consequencePossible solution
Check tires,
then restart
Run Flat Indicator
.
There was a warning message about a
loss in the tire inflation pressure and
the Run Flat Indicator has not been
restarted yet.Make sure that the correct tire inflation
pressure is set for each tire.
Then restart the Run Flat Indicator.
Tire Pressure
Check TiresThe Run Flat Indicator indicates that
the pressure is too low in one or more
tires.Carefully bring the vehicle to a halt, avoid-
ing abrupt steering and braking maneu-
vers. Observe the traffic situation around
you.
Check and adjust tire inflation pressure as
required (
page 302).
If necessary, change the wheel
(
page 417).
Restart the Run Flat Indicator after adjust-
ing the tire inflation pressure values
(
page 304).
ABCMalfunction
Stop CarYou have started driving although the
vehicle level is still too low.
The vehicle is being raised. The ABC
message goes out after a few seconds.Stop your vehicle in a safe location or as
soon as it is safe to do so.
Wait until the message disappears from
the multifunction display.
You may then drive off.
Page 363 of 489
362 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
ABCMalfunction
Stop CarThe vehicle is losing oil.
The ABC message is continuously
shown.Stop your vehicle in a safe location or as
soon as it is safe to do so.
Contact an authorized Mercedes-Benz
Center.
The ABC is malfunctioning.Stop the vehicle in a safe location and
press the vehicle level control button to
select a higher vehicle level (
page 231).
If the vehicle does not raise, observe the
following when you continue to drive:
Do not turn steering wheel too far to
avoid damaging the front fenders.
Listen for scraping noises.
Do not exceed a speed of
50 mph (80 km/h).
Contact an authorized Mercedes-Benz
Center as soon as possible.
ABCMalfunctionThe capability of the ABC system is
restricted. This can impair handling.Do not exceed a speed of 50 mph
(80 km/h).
Contact an authorized Mercedes-Benz
Center as soon as possible.
Page 364 of 489

363 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
ABCVehicle Rising
Please WaitThe vehicle’s level is too low while at a
standstill. The vehicle will be raised.Do not drive off.
Wait until the message disappears from
the multifunction display.
You may then drive off.
ABSABS, ESP
Unavailable
See
Oper. ManualThe ABS and ESP® are not available
due to a malfunction. The BAS is also
deactivated.
The system’s self-diagnosis may not
be completed yet.
The electro-hydraulic brake system is
still functioning normally but without
the ABS, the ESP
®, and the BAS avail-
able.
Drive a short distance with added
caution at a vehicle speed of above
12 mph (20 km/h).
When the message disappears, the ABS,
the ESP
®, and the BAS are available again.
If the message does not disappear:
Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.
Have the system checked at an authorized
Mercedes-Benz Center as soon as
possible.
Failure to follow these instructions increases
the risk of an accident.
Page 365 of 489

364 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
ABSABS, ESP
Inoperative
See
Oper. ManualThe ABS and ESP® have switched off
due to a malfunction.
The BAS is also deactivated.
The electro-hydraulic brake system is
still functioning normally but without
the ABS, the ESP
®, and the BAS avail-
able.
Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.
Have the system checked at an authorized
Mercedes-Benz Center as soon as
possible.
Failure to follow these instructions increases
the risk of an accident.
Cruise Control––– MPHYou have attempted to set a speed
below 20 mph (30 km/h).Accelerate to a speed exceeding
20 mph (30 km/h) and set the speed
(
page 215).
The ESP® is switched off.Switch on the ESP® (page 94).
The gear selector lever is set to
position P, R, or N.Move the gear selector lever to position D.
The vehicle is secured with the parking
brake.Release the parking brake (page 55).
Cruise Control
AND SPEEDTRONICInoperativeThe cruise control is malfunctioning.Have the system checked at an authorized
Mercedes-Benz Center as soon as
possible.
Page 368 of 489

367 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
ESPESP
Inoperative
See
Oper. ManualThe ESP® has detected a malfunction
and switched off.
The ABS may not be operational.
The electro-hydraulic brake system is
still functioning normally but without
the ESP
® available.
Continue driving with added caution.
Have the system checked at an authorized
Mercedes-Benz Center as soon as
possible.
Failure to follow these instructions increases
the risk of an accident.
ESP Unavailable
See
Oper. ManualThe ESP® is deactivated because the
power supply has been interrupted.
The electro-hydraulic brake system is
still functioning normally but without
the ESP
® available.
Synchronize the ESP®. With the vehicle
stationary, turn the steering wheel com-
pletely to the left and then to the right.
If the ESP
® message does not go out:
Continue driving with added caution.
Have the system checked at an authorized
Mercedes-Benz Center as soon as
possible.
Failure to follow these instructions increases
the risk of an accident.
!When synchronizing the ESP®, make sure
you can turn the steering wheel in both direc-
tions as far as it will go without the wheels hitting
any objects, e.g. a road curb.
Page 375 of 489

374 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
Tire pressuredisplayed after
driving for
a few minutes.Vehicles with Advanced TPMS*:
The tire inflation pressure is being
checked.Drive the vehicle for a few minutes.
Tire Pressure MonitorInoperativeThe TPMS or Advanced TPMS* is
malfunctioning.Have the TPMS or Advanced TPMS*
checked by an authorized
Mercedes-Benz Center.
Tire Pressure MonitorInoperative
No Wheel SensorsThere are wheels without appropriate
wheel sensors mounted (e.g. winter
tires).Have the TPMS or Advanced TPMS*
checked by an authorized
Mercedes-Benz Center.
Have appropriate wheel sensors in-
stalled by an authorized Mercedes-Benz
Center.
Tire Pressure Monitor
Wheel Sensor MissingVehicles with Advanced TPMS*:
One or more sensors defect
(e.g. empty sensor battery).
The respective tire is indicated by
---
instead of the tire inflation pressure in
the multifunction display.
Have Advanced TPMS* checked by an
authorized Mercedes-Benz Center.
Have appropriate wheel sensors in-
stalled by an authorized Mercedes-Benz
Center.