Page 619 of 801

618 OperationVehicle careWhen taking the vehicle through an auto-
matic conveyor type car wash, observe the
following instructions.
Vehicles with SmartKey:
With the vehicle at a standstill and the
ignition switched on shift the
automatic transmission to neutral
positionN.
If engaged, manually release the
electronic parking brake (
page 423).
Switch off the ignition and leave the
SmartKey in the starter switch.Vehicles with KEYLESS-GO*:
With the vehicle at a standstill, depress
the brake pedal and keep it pressed.
Shift the automatic transmission to
park positionP.
Release the brake pedal.
Remove the KEYLESS-GO start/stop
button from the starter switch
(page 371).
Insert the SmartKey with KEYLESS-GO
into the starter switch.
With the ignition switched on shift the
automatic transmission to neutral
positionN.
If engaged, manually release the
electronic parking brake (
page 423).
Switch off the ignition and leave the
SmartKey with KEYLESS-GO in the
starter switch.Ornamental moldings
For regular cleaning and care of ornamen-
tal moldings, use a damp cloth.
Warning!
G
When leaving the SmartKey or SmartKey
with KEYLESS-GO* in the starter switch, do
not leave children unattended in the vehicle.
It is possible for children to switch on the
ignition which could result in unsupervised
use of vehicle equipment. Unsupervised use
of vehicle equipment could result in an
accident and/or serious personal injury.
i
After running the vehicle through an auto-
matic car wash, wipe any wax off of the wind-
shield (
page 622). This will prevent smears
and reduce wiping noise which can be caused by
residual wax on the windshield.
When leaving the car wash, make sure that the
mirrors are folded out. Otherwise they may
vibrate.
!
Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings may
have chrome appearance, they could be made of
anodized aluminum that will be damaged when
cleaned with chrome cleaner. Instead, use a
damp cloth to clean those ornamental moldings.
For very dirty ornamental moldings of which you
are sure are chrome-plated, use a chrome clean-
er. If in doubt whether an ornamental molding is
chrome-plated, contact an authorized
Mercedes-Benz Center.
Page 629 of 801

628 Practical hintsWhat to do if …?Lamps in instrument cluster
General information:
If any of the following lamps in the instru-
ment cluster fails to come on during the
bulb self-check when switching on the igni-
tion, have the respective bulb checked and
replaced if necessary.Problem
Possible cause/consequence
Suggested solution
-
The yellow Antilock
Brake System (ABS)
indicator lamp comes on
while the engine is run-
ning.
The ABS has detected a malfunction and
has switched off. The BAS, ESP
®, EBP and
PRE-SAFE
® are also switched off (see mes-
sages in multifunction display).
The brake system is still functioning nor-
mally but without the ABS available.
If the ABS control unit is malfunctioning,
other systems such as Parktronic*,
DISTRONIC Plus*, navigation system, Park
Assist* and the automatic transmission
may also be malfunctioning.
Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.
Read and observe messages in the mul-
tifunction display (
page 642).
Have the system checked at an autho-
rized Mercedes-Benz Center as soon as
possible.
Failure to follow these instructions increas-
es the risk of an accident.
Page 646 of 801
645 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Cruise Control
- - - mph
(USA only)
Cruise Control
- - - kmh
(Canada only)
You have tried to switch on
cruise control below a speed of
20 mph (30 km/h).
Drive faster than 20 mph (30 km/h) and save the speed.
ESP
® is switched off.
Switch on ESP
® (page 76).
The automatic transmission is in
park position P, reverse gearR
or neutral positionN.
Shift the automatic transmission to drive positionD (
page 426).
The system is overheated.
Wait until the system cools down.
The vehicle is secured in place
by the electronic parking brake.
Release electronic parking brake (
page 422).
Cruise Control
Inoperative
Cruise control is malfunction-
ing.
Have cruise control checked by an authorized Mercedes-Benz Center.
Page 648 of 801

647 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
DISTRONIC PLUS
Override
You have depressed the accelerator pedal,
DISTRONIC Plus* is no longer controlling
the speed of the vehicle.
Release the accelerator pedal.
DISTRONIC PLUS
- - - mph
(USA only)
Canada only:
DISTRONIC PLUS
- - - kmh
(Canada only)
You have attempted to activate DISTRONIC
Plus* at a speed below 20 mph (30 km/h)
without the vehicle in front being displayed
in the multifunction display (
page 454).
Drive faster than 20 mph (30 km/h) and activate DISTRONIC
Plus* again.
ESP
® is switched off.
Switch on ESP
® (page 76).
The automatic transmission is in park posi-
tion P, reverse gearR or neutral positionN.
Shift the automatic transmission to drive positionD
(page 426).
The system is overheated.
Wait until the system cools down.
The vehicle is secured in place by the elec-
tronic parking brake.
Release electronic parking brake (
page 422).
The driver’s door is open and the drivers
seat belt is unbuckled.
Close the driver’s door and fasten your seat belt.
The hood is open.
Close the hood (
page 574).
Page 649 of 801
648 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Door Open
Vehicle Not in Park
You have opened the driver’s
door and the automatic trans-
mission is still in drive position
D, reverse gearR or neutral
positionN.
Before you leave the vehicle, make sure that the automatic transmission
is shift to park position P (
page 426) and that the electronic parking
brake is engaged (
page 422).
Page 654 of 801

653 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Next Service X
Due in ... days
Due in ... mls (km)
Service X must be carried out in ... days or
after ... miles (kilometers) (
page 612).
Have the maintenance service carried out by an authorized
Mercedes-Benz Center.
Only Shift to
Position 'P' When
Vehicle Is Stationary
You have tried to shift the automatic trans-
mission to park positionP using the gear
selector lever although the vehicle is still in
motion.
Stop your vehicle as soon as it is safe to do so.
Shift the automatic transmission to park positionP.
Engage the electronic parking brake (
page 422).
Park Assist
Currently Unavailable
See Oper. Manual
Park Assist* is deactivated because the
area around the sensors* in the front or the
rear bumper (
page 620) is dirty.
Clean the front and rear bumper (
page 620).
Park Assist* is deactivated because the
battery voltage is insufficient.
Have the battery checked by an authorized Mercedes-Benz
Center.
Park Assist* is switched off because the ra-
dar sensor system* is temporarily inopera-
tive due to electromagnetic interference
near television and radio transmitter sta-
tions, toll stations, speed measuring sys-
tems, etc.
Wait until the message in the multifunction display disappears.
Park Assist
Inoperative
Park Assist* is unavailable due to a mal-
function.
Contact an authorized Mercedes-Benz Center as soon as pos-
sible.
Page 658 of 801

657 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Shift to P or N
to Start Engine
You have attempted to start the engine
while the automatic transmission was set to
reverse gearR or drive positionD.
Shift the automatic transmission to park positionP or neutral
positionN (
page 426).
Tire Pressure Monitor
Inoperative
The Advanced TPMS or a wheel sensor is
malfunctioning.
Have the Advanced TPMS checked by an authorized
Mercedes-Benz Center.
Warning!
G
Do not drive with a flat tire. A flat tire affects
the ability to steer or brake the vehicle. You
may lose control of the vehicle. Continued
driving with a flat tire will cause excessive
heat build-up and possibly a fire.
Follow recommended tire inflation pres-
sures.
Do not underinflate tires. Underinflated tires
wear excessively and/or unevenly, adverse-
ly affect handling and fuel economy, and are
more likely to fail from being overheated. Do
not overinflate tires. Overinflated tires can
adversely affect handling and ride comfort,
wear unevenly, increase stopping distance,
and result in sudden deflation (blowout) be-
cause they are more likely to become punc-
tured or damaged by road debris, potholes
etc.
Page 660 of 801
659 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Tire Pressures
Displayed After Driving
a Few Minutes
The tire inflation pressure is being
checked.
Drive the vehicle for a few minutes.
Service Required
Do Not Shift Gears
The automatic transmission cannot be
shifted out of the set position because of a
malfunction.
If the automatic transmission is shift to drive positionD
(page 426):
Without changing the automatic transmission from drive
positionD, contact an authorized Mercedes-Benz Center.
If the automatic transmission is shift to neutral positionN, re-
verse gearR or park positionP:
Do not drive.
Consult an authorized Mercedes-Benz Center.