2008 MERCEDES-BENZ R320 technical data

[x] Cancel search: technical data

Page 9 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual Contents
Replacing wiper blades ......................  489
Front wiper blades .......................  489
Rear wiper blade ..........................  490
Flat tire .................................

Page 15 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 14 Introduction
Where to find it
This Operator’s Manual is designed to pro-
vide comprehensive support information 
for you, the vehicle operator. Each section 
has its own reference color.
At a gla

Page 17 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 16 Introduction
Operating safety
Proper use of the vehicle
Proper use of the vehicle requires that you 
are familiar with the following information 
and rules:
the safety precautions in this manual


Page 346 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 345 Operation
Driving instructions
Mercedes-Benz recommends winter tires 
(
page 398) with a minimum tread depth 
of approximately 1/6in (4 mm) on all four 
wheels for the winter season to ensure 
no

Page 360 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 359 Operation
Engine compartment
Wipe oil dipstick 1 clean.
Fully insert oil dipstick1 into the 
dipstick guide tube.
Pull out oil dipstick1 again after 
approximately 3 seconds to obtain 
accurate

Page 361 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 360 Operation
Engine compartment
Be careful not to spill any oil when adding. 
Avoid environmental damage caused by oil 
entering the ground or water.
Screw filler cap1 back on filler neck.
For more

Page 371 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 370 Operation
Tires and wheels
Certification label
Even after careful determination of the 
combined weight of all occupants, cargo 
and the trailer tongue load (if applicable) 
(
page 370) as to not

Page 501 of 569

MERCEDES-BENZ R320 2008 W251 Owners Manual 500 Practical hints
Flat tire
Inflate the spare wheel tire to the 
recommended tire inflation pressure 
given in the “Technical data” section 
(
page 529).
This takes about 5 minutes for the 
co
Page:   1-8 9-16 17-24 25-32 33-40 ... 40 next >