GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Getting
Started
Getting
Started
Cruise
control
Operates
above
19 mph.
To activate:
Press and release ON/OFF (1).
To set speed: Press and release
SET/COAST (3) at desired speed.
To accelerate: Press and hold
RES/ACCEL (2); incremental
acceleration: Press and release
(2), each tap = plus 1 mph.
To decelerate: Press and hold SET/
COAST (3), release at desired speed;
or tap brake pedal, press and release
(3) at desired speed; incremental
deceleration: Press and release
(3), each tap = minus 1 mph.
To cancel: Tap brake pedal, clutch
pedal (manual transaxle) or press
CANCEL button (4) or ON/OFF (1).
Return to preset speed after
Remote keyless entry systemFunctions only with key removed
from ignition switch.
To lock doors: Press button (1);
press again within 5 seconds,
doors relock and horn beeps.
To unlock: Press (2) for driver’s
door; press again within 5 seconds to
unlock other doors, press and hold
for 3 seconds to lower front windows.
To open trunk: Press (4).
Panic alarm: Press (3); horn
sounds; to stop, press any button
on the transmitter or turn ignition
to ON position.
Tilt/telescopic
steering-wheel
lever
Pull lever (5)
down to unlock
column, adjust tilt
angle and length
of steering column.
WARNING: Do not adjust
steering-wheel while driving.
Instrument panel
lighting
To brighten/dim turn
thumbwheel up/down.
HID headlights
leveling switch*
Set position at 0 unless
vehicle is loaded heavily,
leveling switch adjusts
headlight angle to compensate
for weight of passengers and
cargo, see Owner’s Manual.
Remote window operationRemote keyless entry: Press unlock
button (2) twice and hold, doors
unlock and front windows fully open.
Key: Insert key in driver’s door
lock; turn toward front/rear of
vehicle and hold it, after doors
are unlocked/locked windows
will open/close.
ClockTo set: With ignition in ACC or
ON position, press (A) and hold
until beep sounds; 12 hr/24hr
will be displayed; press (B) to
select; press (A) again while
selection is flashing: Hr ADJUST
displays; press (B) to select hr;
press (A) when done, do the
same to set minutes.
1243
123
5Sedan
5-Door
10
Rear
center
position
seat belt
†
Connecting
seat belt: Pull
seat belt from
recess behind
head restraint (A) (Sedan) or left side
of cargo area (B) (5-Door) and
connect tongue (10) to anchor (11).
Wearing seat belt: Slowly pull out lap/
shoulder belt (12) and insert tongue
(13) into buckle (14) until click is heard.
Unfastening seat belt: Depress
buckle button (14) to release.
Tip: Leave center-rear lap portion
of seat belt fastened at all times
except when folding rear seat.
Stowing seat belt: Insert key or small
object in anchor buckle slot (15) to
release entire belt, let it fully retract,
then put tongues (10) and (13) together,
insert securely into recess (Aor B). CANCELbutton or braking: Press
and release RES/ACCEL button (2).
Tip: Cruise control will not
be canceled in Manual Mode
during gear changes.
Steering-
wheel
audio
controls
To increase/decrease
volume: Press (5).
Radio: Press (6) less than one
second to select next/previous
preset station, press (6) more
than one second until beep sound is
heard to seek next/previous station.
Cassette/CD: Press (6) to select
next selection/track, press (6)
to repeat current selection/track.
Press (7) to select AM, FM 1,
FM 2, Cassette* and CD mode.
Press (8) to mute Audio/NAVI system*.
/
/
M
O
D
EV
O
L5
678
RES
ACCEL ON
OFF
CANCELSET
COAST43
12
*Denotes optional equipment†See Owner’s Manual
CLOCK
SETABTILT
SET CLKAB
1511
10
14 13
AB
12
INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
Instrument
Cluster
Instrument
Cluster
H F
E C
P
R
N
D
M
2
1 2 2 13 12 14 11
0 1 2 3 x1000r/min
4
5
6
7
8
19 20 22 21 23 25 18 24 6
8
10 9
26
4 15
17
16
0 20 mph
km/h 40 60
80
100
120
140
TRIP A 8
O.O
20 40 60 80 100 120
140
160
180
200
220
240
7 5
3
18. Brake system
Parking brake on/low fluid level.
19. Check engine
Dealer inspection required.
20. Charging system
Dealer inspection required.
21. Engine oil pressure
22. Air bag readiness
Front, side and/or curtain air bag
malfunction; warning light
constantly flashes or stays on
or never comes on with ignition
on, dealer inspection required.
23. Door ajar
24. Immobilizer system on,
see Locks
25. Always fasten seat belts
26. Tire Pressure
Monitoring System
(TPMS),
see Trunk
8. Engine coolant
temperature gauge
If above normal range, stop
vehicle and turn off engine,
check coolant level when safe.
12. Automatic transaxle
Dealer inspection required
if light remains on.
13. High beams on
14. Traction Control
System (TCS)
Light flashes when in use;
dealer inspection required if
light remains on.
Enhances traction and safety
by regulating engine torque.
When TCS detects drive wheel
slippage it lowers engine torque
to prevent loss of traction.
15. Lights on*
16. Traction Control
System off
System turned off manually
or malfunctioning; dealer
inspection required.
17. Low fuel7. Odometer/tripmeter
selector
Press to select among trip A,
trip B, and odometer.
Press and hold to reset selected
trip meter.
WARNING LIGHTS
9. Cruise control,see Getting Started
10. Cruise Control Main
Power On,see Getting Started
11. Anti-lock Brake
System (ABS)
ABS malfunction, normal brakes
only, dealer inspection required.
ABS automatically reduces
hydraulic pressure to any wheel
on the verge of locking up.
You may feel a slight pulsing of
the brake pedal and hear a
clicking noise; this tells you the
ABS is functioning properly;
increase pressure on pedal for
maximum braking.
Tips: Maintain constant
pressure on the brake pedal.
Do not pump the brakes.
CRUISE
MAIN
CRUISE
GAUGES
1. Tachometer
2. Turn signals/hazard
warning on
3. Speedometer
4. Fuel gauge
5. Odometer/tripmeter
6. Gear indicator
Displays current gear of Sport AT.
*If equipped with black-out meter
DRIVER CONTROLS
Always check the Owner’s Manual for more operating information and safety features
Driver
Controls
Switches
12
= Fog lights on: Rotate knob
(2); functions only with headlight
low beams on
Turn signals right/left: Move lever
up/down.
Tip: Headlights switch off auto-
matically within 30 seconds if
lights are left on and switch is
in lock position or key removed.
Wiper/washer control lever
Intermittent wiper: One click down.
To change interval speed:
Rotate inner ring (3).
Normal wiper speed: Two
clicks down.
Fast wiper speed: Three
clicks down.
Single wipe: Push stalk up.
Washer: Pull stalk back.
Rear window wiper/washer
(5-Door)
To activate rear interval wiper:
Rotate knob (4) up to INT.
To activate rear normal speed
wiper: Rotate knob (4) up to ON.
To activate rear washer with
wipers operating: Rotate knob
(4) up to ; hold knob (4)
to continue washing; release
knob and wipers will continue
to operate.
To operate stand alone wipe/
wash function: Rotate knob
(4) down and hold, release
to stop.
Front window switches
One-touch down/up: Press/pull
AUTO switch (3) firmly and
release, window goes down/up
all the way, press/pull briefly
to stop, press/pull lightly and
hold for normal operation.
Tip: During closing window
operation, window will stop
and open partway if object
blocks window operation.
Rear window switches
Push/pull (4) to open/close.
Power window lockout switch
Press button (5), only driver's
window operates; press again
for normal operation.
Power window
initialization procedure
If battery is disconnected or power
window fuse is replaced, the auto
open/close and anti-pinch features
will not function.Resetting procedure:
1. Turn ignition switch
to “ON” position.
2. Make sure that power
window lock switch located
on driver’s door is not
depressed.
3. Press switch and fully open
power window.
4. Pull up switch to fully close
power window and continue
holding switch for about
2 seconds after window
fully closes.
5. Repeat steps 3- 4 for front
passenger power window
while seated in front
passenger seat.
6. Make sure power windows
operate correctly using
door switches.
Dual power
mirrors
Ignition switch
must be in ACC
or ON position.
Switch is on
driver’s door.
To adjust left/right mirror:
Press selector switch (1) left/
right, press switch (2) in direction
of desired movement.
Tip: To lock mirrors in place,
move selector switch (1) to
center position.
Power window
switches
With ignition ON.
All windows
controlled from
driver’s armrest;
passenger doors
have separate
switches.
Turn signal/lighting
control lever
OFF= Lights off
= Tail, parking and
dashboard lights on: Rotate
knob (1) to first notch
= Tail, parking, dashboard
and headlights on: Rotate knob
(1) to second notch
High beams on/off: Push lever
forward/pull back to detent.
To flash high beams: Pull lever
back slightly and release.
34
R
E
A
R
543
AU
TOA
U
TO
LR
2
1
AM/FM STEREO/CASSETTE/CD CHANGER
Always check the Owner’s Manual for more operating information and safety features
Audio
Systems
Audio
Systems
1. Power/Volume
Press to turn on/off; rotate
to increase/decrease volume.
2. SEEK/TRACK/APC
Radio: Press to
automatically seek higher/
lower frequency.
CD: Press to select
next/previous track.
Cassette*: Press to
automatically advance tape to
beginning of next selection/
replay selection; to stop this
operation, press button again.
3. LOAD
To load multiple discs*: Press
and hold LOAD (3) until
beep sound is heard; insert
CD when “In” is displayed.
To eject disc: Press Eject (11).
12. Scan/Auto-Memory
Press to briefly sample next
listenable selections; functions
in all modes.
Radio: Press and hold until a beep
sound is heard; system auto-
maticallyscans and temporarily
stores six strong stations in each
band; press again to cancel.
13. Tuning/Audio Control
Tune: Rotate counterclockwise/
clockwise for lower frequency/
higher frequency.
Audio control: Press to select
ALC/BASS/TREB/FADE/BAL/BEEP
(Automatic level control) can be
turned on and off; rotate right/left
to adjust selected feature.
ALC ON = Audio volume
decreases/increases with
vehicle speed
ALC OFF = Audio volume does
not decrease/increase with
changes in vehicle speed14. Fast forward
Press to fast forward
through a track.
15. Cassette eject button*
16. Reverse
Press to reverse through a track.
17. Program Random
Press for random play.
18. Cassette door*
19. Repeat
Press to replay current
CD/tape selection.
20. Dolby® Noise Reduction*
Reduces tape noise and hiss;
press to activate/deactivate.
21. Disc up *
Press to skip forward to
beginning of next CD.
22. Disc down *
Press to skip back to
beginning of previous CD.
23. Display, see Information Display
VOL PUSH POWER
SEEK
TRACK
APC
1DBCV2DBC 56 3RPT4PROG
RDMV
FM 1/2 AM SAT CD MEDIA
TUNE PUSH AUDIO CONT.
TEXT
SCAN
AUTO-M DISP/ESN
LOAD
25679108311124
13114
88:8.8 FM1 88.9 88.8CHCD MD 1 2 3 4 5 6 ST RPT RDM AUTO-M8AMB FOAUTOA/C ECO
22
23
15201816171921
*Denotes optional equipment†SAT button is standard but requires
SIRIUS subscription/additional hardware
Tips: Always remove antenna before entering a car wash.
To remove antenna; rotate counter-clockwise,
to install rotate clockwise.
To eject specific disc: Press
and hold Eject (11) until beep
sound is heard; within five
seconds press the desired tray
number 1-6 (4).
4. Memory preset buttons
To set: Tune to station, press and
hold until beep sound is heard.
5. FM1/2
Press to select between FM1/FM2
station preset buttons (4).
6. AM
Press to select AM frequency band.
7. SAT
†, Satellite ready capability.
8. CD slot
9. CD, Press to play CD.
10. MEDIA
Press to play cassette tape.
11. CD eject button