2008 MAZDA MODEL 6 warning lights

GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Getting
Started
Getting
Started
Cruise
control
Operates
above
19 mph.
To activate:
Press and release ON/OFF (1).
To set speed: Press and release
SET/COAST (3) at desired speed.
To accelerate: Press and hold
RES/ACCEL (2); incremental
acceleration: Press and release
(2), each tap = plus 1 mph.
To decelerate: Press and hold SET/
COAST (3), release at desired speed;
or tap brake pedal, press and release
(3) at desired speed; incremental
deceleration: Press and release
(3), each tap = minus 1 mph.
To cancel: Tap brake pedal, clutch
pedal (manual transaxle) or press
CANCEL button (4) or ON/OFF (1).
Return to preset speed after
Remote keyless entry systemFunctions only with key removed
from ignition switch.
To lock doors: Press button (1);
press again within 5 seconds,
doors relock and horn beeps.
To unlock: Press (2) for driver’s
door; press again within 5 seconds to
unlock other doors, press and hold
for 3 seconds to lower front windows.
To open trunk: Press (4).
Panic alarm: Press (3); horn
sounds; to stop, press any button
on the transmitter or turn ignition
to ON position.
Tilt/telescopic
steering-wheel
lever
Pull lever (5)
down to unlock
column, adjust tilt
angle and length
of steering column.
WARNING: Do not adjust
steering-wheel while driving.
Instrument panel
lighting
To brighten/dim turn
thumbwheel up/down.
HID headlights
leveling switch*
Set position at 0 unless
vehicle is loaded heavily,
leveling switch adjusts
headlight angle to compensate
for weight of passengers and
cargo, see Owner’s Manual.
Remote window operationRemote keyless entry: Press unlock
button (2) twice and hold, doors
unlock and front windows fully open.
Key: Insert key in driver’s door
lock; turn toward front/rear of
vehicle and hold it, after doors
are unlocked/locked windows
will open/close.
ClockTo set: With ignition in ACC or
ON position, press (A) and hold
until beep sounds; 12 hr/24hr
will be displayed; press (B) to
select; press (A) again while
selection is flashing: Hr ADJUST
displays; press (B) to select hr;
press (A) when done, do the
same to set minutes.
1243
123
5Sedan
5-Door
10
Rear
center
position
seat belt
†
Connecting
seat belt: Pull
seat belt from
recess behind
head restraint (A) (Sedan) or left side
of cargo area (B) (5-Door) and
connect tongue (10) to anchor (11).
Wearing seat belt: Slowly pull out lap/
shoulder belt (12) and insert tongue
(13) into buckle (14) until click is heard.
Unfastening seat belt: Depress
buckle button (14) to release.
Tip: Leave center-rear lap portion
of seat belt fastened at all times
except when folding rear seat.
Stowing seat belt: Insert key or small
object in anchor buckle slot (15) to
release entire belt, let it fully retract,
then put tongues (10) and (13) together,
insert securely into recess (Aor B). CANCELbutton or braking: Press
and release RES/ACCEL button (2).
Tip: Cruise control will not
be canceled in Manual Mode
during gear changes.
Steering-
wheel
audio
controls
To increase/decrease
volume: Press (5).
Radio: Press (6) less than one
second to select next/previous
preset station, press (6) more
than one second until beep sound is
heard to seek next/previous station.
Cassette/CD: Press (6) to select
next selection/track, press (6)
to repeat current selection/track.
Press (7) to select AM, FM 1,
FM 2, Cassette* and CD mode.
Press (8) to mute Audio/NAVI system*.
/
/
M
O
D
EV
O
L5
678
RES
ACCEL ON
OFF
CANCELSET
COAST43
12
*Denotes optional equipment†See Owner’s Manual
CLOCK
SETABTILT
SET CLKAB
1511
10
14 13
AB
12

INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
Instrument
Cluster
Instrument
Cluster
H F
E C
P
R
N
D
M
2
1 2 2 13 12 14 11
0 1 2 3 x1000r/min
4
5
6
7
8
19 20 22 21 23 25 18 24 6
8
10 9
26
4 15
17
16
0 20 mph
km/h 40 60
80
100
120
140
TRIP A 8
O.O
20 40 60 80 100 120
140
160
180
200
220
240
7 5
3
18. Brake system
Parking brake on/low fluid level.
19. Check engine
Dealer inspection required.
20. Charging system
Dealer inspection required.
21. Engine oil pressure
22. Air bag readiness
Front, side and/or curtain air bag
malfunction; warning light
constantly flashes or stays on
or never comes on with ignition
on, dealer inspection required.
23. Door ajar
24. Immobilizer system on,
see Locks
25. Always fasten seat belts
26. Tire Pressure
Monitoring System
(TPMS),
see Trunk
8. Engine coolant
temperature gauge
If above normal range, stop
vehicle and turn off engine,
check coolant level when safe.
12. Automatic transaxle
Dealer inspection required
if light remains on.
13. High beams on
14. Traction Control
System (TCS)
Light flashes when in use;
dealer inspection required if
light remains on.
Enhances traction and safety
by regulating engine torque.
When TCS detects drive wheel
slippage it lowers engine torque
to prevent loss of traction.
15. Lights on*
16. Traction Control
System off
System turned off manually
or malfunctioning; dealer
inspection required.
17. Low fuel7. Odometer/tripmeter
selector
Press to select among trip A,
trip B, and odometer.
Press and hold to reset selected
trip meter.
WARNING LIGHTS
9. Cruise control,see Getting Started
10. Cruise Control Main
Power On,see Getting Started
11. Anti-lock Brake
System (ABS)
ABS malfunction, normal brakes
only, dealer inspection required.
ABS automatically reduces
hydraulic pressure to any wheel
on the verge of locking up.
You may feel a slight pulsing of
the brake pedal and hear a
clicking noise; this tells you the
ABS is functioning properly;
increase pressure on pedal for
maximum braking.
Tips: Maintain constant
pressure on the brake pedal.
Do not pump the brakes.
CRUISE
MAIN
CRUISE
GAUGES
1. Tachometer
2. Turn signals/hazard
warning on
3. Speedometer
4. Fuel gauge
5. Odometer/tripmeter
6. Gear indicator
Displays current gear of Sport AT.
*If equipped with black-out meter

HOMELINK®
Always check the Owner’s Manual for more operating information and safety features
HomeLink®
Interior
Lights
Auto-dimming rear
view mirror*
Auto-dimming function changes
are based on outside lighting
conditions and if bright headlights
are visible in rear view mirror.
Press on (2), off (3).
5. Moonroof tilt switch
Press rear of switch to
tilt rear of moonroof.
Press front of switch to close.
6. Moonroof slide switch
Press rear of switch to open
moonroof.
Press front of switch to close.
Illuminated visor mirrors
Mirrors lighted when covers
open; off when closed. Rolling code synchronization
procedure
Refer to your garage door opener or
device instruction manual to confirm
your system is equipped with a
rolling code feature.
Tip: This procedure is easier
to perform with the assistance
of another person.
To synchronize: Press programming
button on garage door opener
motor; press/hold for 2 seconds
and release the programmed
HomeLink
®button 2 times
within 30 seconds of pressing
the garage door opening
motor programming button.
Some devices may require you
to press/hold and release a
third time to complete
programming procedure.
If indicator light stays on,
programming is complete.
To erase all existing programming;
press and hold two outer
HomeLink
®buttons (1) on mirror,
continue to hold buttons until
indicator light flashes.
1. Map/reading light switch
Press on/off.
2. Interior light switch
DOOR = light on when
door open
OFF = light always off
3. Interior map/reading
light
4. Sunglass holder
Press concaved lip to open.
To program or reprogram:
Press and hold two outer
HomeLink
®buttons (1) for 20
seconds and no more than
30 seconds, release only after
indicator light (4) begins to
flash; hold transmitter for the
device to be programmed
between 1-3 inches to
HomeLink
®; press transmitter
button and desired HomeLink®
button (1) simultaneously until
HomeLink®indicator light (4)
goes from slow to rapid flashing.
Verify device operation by
pressing HomeLink
®button (1)
that was just programmed.
Tip: You do not need to
repeat the first step to program
the other two hand-held
transmitters for the remaining
HomeLink
®buttons.
For further information, contact
HomeLink
®at 1-800-355-3515,
www.homelink.comor your
authorized Mazda Dealer. HomeLink
®Wireless
Control System*
Located on rear view mirror.
HomeLink
®provides three
programmable buttons that
will replace three hand-held
device transmitters.
Tip: It is recommended to
park outside of garage when
programming HomeLink
®.
WARNING: When programming
a garage door or gate opener,
disconnect power to these
devices before programming,
continuous operation of these
devices could damage the motor.
*Denotes optional equipment
11423
T
I
L
TSL
ID
E
121
43356
OFFDOO
R

UNDER HOOD
Always check the Owner’s Manual for more operating information and safety features
Under Hood
1. Engine oil filler cap
SAE 5W-20
2. Automatic transmission
fluid (ATF) dipstick
See Owner’s Manual
3 . Brake/Clutch* fluid reservoir
Fill to MAX mark with DOT 3
fluid; check with cap on.
4. Battery
5. Fuse block
6. Air filter
7. Hood support rod
8. Hood latch
Push hood latch to the right,
open hood.
9. Engine coolant reservoir
Level should be between FULL
and LOW markings when cold.
WARNING: Never remove
coolant reservoir cap while
engine is running or hot;
remove only when system
is cool.
10. Engine oil dipstick
Check with engine off after
approximately 5 minutes and
at operating temperature; fluid
level should be between MAX
and MIN markings on dipstick.
11. Power steering fluid
reservoir
Check with engine off and at
normal temperature; fill to
MAX mark.
12. Windshield washer
reservoir
Fill with windshield washer fluid.
Gas cap
After filling vehicle with gasoline,
fully reinstall gas cap by turning
clockwise until a clicking sound is
heard, if gas cap is not fully installed,
Check Engine light may come on.
For more information on
Check Engine light, see
Owner’s Manual.
Break-in period
First 600 miles: Drive at varying
road and engine speeds; avoid
full throttle, rapid acceleration
or kick-down of transmission.
Unique driving conditions
†Every 5,000 miles change
oil/filter, inspect coolant level,
lights, brake/clutch fluid, tire
pressure/wear, power steering
fluid, locks/hinges and washer fluid.
Normal maintenance notes
Rotate tires every 7,500 miles or
sooner if needed.
Replace cabin air filter every
25,000 miles or 24 months.
Inspect exhaust system and heat
shields every 45,000 miles or 5 years.
Replace (FL22) engine coolant
every 120,000 miles or 10 years.
WARNING: Using coolant other
than FL22 requires more frequent
maintenance intervals.
A.Change: Engine oil/
replace filter
Lube: Locks and hinges
B.Inspect: Disc brakes
C.Inspect: Drive belts (3.0 liter),
fuel lines and hoses, brake
lines, hoses and connections,
steering operation and linkages,
front and rear suspension ball
joints, driveshaft dust boots,
cooling system
D.Inspect: Drive belts (2.3 liter)
Replace: Air filter
E.Inspect: Hoses and tubes for
emission system
F. Replace: Spark plugs
Inspect: Engine valve clearance
(2.3 liter), adjust if noisy
G. Replace: Engine coolant
(Other than FL22)
3.0-liter V62.3-liter I4
*Denotes optional equipment†See Owner’s Manual
2
11 9 7 12 6
5 1 4 3
8 10
10 11 7 9 12 6
5 1 2 4 3
8
7,500 miles
15,000 miles
22,500 miles
30,000 miles
37,500 miles
45,000 miles
52,500 miles
60,000 miles
67,500 miles
75,000 miles
82,500 miles
90,000 miles
A A A
F A A
B C E A A
B A D A
BC A
A B A
105,000 miles G