2008 Lancia Musa dashboard

135
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
IN AN EMERGENCY
OPENING/CLOSING OF DOORS...................... 136
ENGINE STARTING .......................................... 136
QUICK TYRE REPAIR KIT
FIX & GO automatic......................................... 138
REPLACING A WHEEL.................................... 142
WHEN NEEDING TO CHANGE A BULB ......... 147
IF AN EXTERIOR LIGHT BURNS OUT ............ 150
IF AN INTERIOR LIGHT BURNS OUT............. 155
IF A FUSE BLOWS............................................ 156
IF THE BATTERY IS FLAT .............................. 162
LIFTING THE CAR........................................... 162
TOWING THE CAR........................................... 163
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 135

136
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
OPENING/
CLOSING OF
DOORS
Emergency device for locking
doors from the outside
The doors are fitted with an emer-
gency device so that they can be
closed using a lock in the event of a
current failure.
In this case, to close the doors of the
car, proceed as follows:
❒fit the ignition key into the revolv-
ing plug B-fig. 1.
❒turn it to 1and close the door.
fig. 1L0D0247m
STARTING
THE ENGINE
STARTING WITH AN
AUXILIARY BATTERY
If the battery is lat, the engine may be
started using an auxiliary battery with
the same capacity or a little higher
than the flat one.
Proceed as follows:
❒connect the positive terminals (+
sign near the terminal) of the two
batteries using an appropriate ca-
ble; To re-open the door, proceed as fol-
lows:
❒fit the ignition key in the revolving
plug of the lock on the driver’s side
and turn it anticlockwise
❒open the door on the driver side
❒from the inside of the car, open the
remaining doors by lifting the re-
spective levers on the door han-
dles.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 136

WARNING
137
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
❒using a second cable connect the
negative terminal (–) of the auxil-
iary battery to the ground E
on the
engine or on the gearbox of the car
to be started;
❒Start the engine;
❒when the engine has been started,
remove the leads reversing the or-
der above.
If after various attempts the engine
does not start, do not persist in vain.
Contact a Lancia Dealership.
IMPORTANT Do not connect the neg-
ative terminals of the two batteries di-
rectly: sparks could ignite explosive
gas released from the battery. If the
auxiliary battery is installed on an-
other car, prevent accidental contact
between metallic parts of the two cars.Never use a quick battery
charger for the emergency
start: this could damage the
electronic systems and the
engine fuel feed and ignition control
units.
This starting procedure
must be carried out by
expert personnel as incorrect ma-
noeuvres can cause electric dis-
charges of considerable intensity.
Furthermore, battery fluid is poi-
sonous and corrosive: avoid con-
tact with your skin and eyes. Keep
naked flames away from the bat-
tery. No smoking. Do not cause
sparks.
fig. 2L0D0396m
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 137

138
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
Indicate that the car is sta-
tionary according to the
laws in force: emergency lights, re-
fracting warning triangle, etc. Pas-
sengers should leave the car, partic-
ularly if it is very loaded and wait
for the wheel to be changed away
from on-coming traffic. In case of
steep slopes or rough slopes, place
wedges or other materials suitable
to stop the vehicle under the wheels.
WARNINGQUICK TYRE
REPAIR KIT FIX
& GO automatic
(if provided for)
The quick tyre repair kit Fix & Go
automaticfig. 3is placed in the boot.
The kit includes:
❒cylinderAcontaining sealing liq-
uid and fitted with:
– filling pipe B;
– adhesive label Cbearing the
words “max. 80 km/h”, to be at-
tached in a position easily visi-
ble to the driver (on the dash-
board) after tyre repair;
❒informative leaflet fig. 4, used to
ensure the correct use of the quick
tyre repair kit and then given to
the personnel who will handle the
treated tyre; BUMP STARTING
Never jump start the engine by push-
ing, towing or driving downhill. This
could cause a flow of fuel into the cat-
alytic converter and damage it beyond
repair.
IMPORTANT Remember that the
brake booster and the power steering
system are not operating until the en-
gine is started, a greater effort will
therefore be required to press the
brake pedal or turn the steering
wheel.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 138

139
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
fig. 3L0D0361m
fig. 4L0D0362m
❒a compressor Dcomplete with
pressure gauge and fittings, lo-
cated in the space;
❒a pair of protective gloves located
in the side space of the compres-
sor;
❒adaptors for the inflation of vari-
ous elements.
The kit container (placed in the boot
under the carpet) also holds the
screwdriver and the tow hitch.
Give the instruction book-
let to the tyre repair work-
shop personnel.
WARNING
IMPORTANT Do not use the Fix &
Go if the tyre was damaged by run-
ning on a flat.
IMPORTANT INFORMATION:
The sealing fluid of the quick tyre re-
pair kit is effective with external tem-
peratures between –20 °C and +50 °C.
The sealing fluid will expire.
The kit cannot be used to
repair damage to the tyre
sidewall. Do not use the quick re-
pair kit if the tyre was damaged by
running on a flat.
The damage cannot be repaired
with the kit if the wheel rim is
damaged (deformation of the chan-
nel causing leakage of air). Do not
remove the foreign body (screw or
nail) from the tyre.
Do not operate the compressor for
longer than 20 consecutive min-
utes. Risk of overheating. The
quick repair kit is not suitable for
definitive repairs. The tyres may
only be repaired temporarily.
WARNING
Should any tyre get punc-
tured due to foreign bodies,
you can repair it if the
damage doesn’t exceed 4
mm on the tread and on the shoul-
der of the tyre.
Replace the cylinder con-
taining the expired sealing
fluid. Dispose of the cylinder
and the sealant liquid prop-
erly. Dispose of according to the na-
tional and local laws in force.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 139

140
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
INFLATION PROCEDURE
❒Ensure that the handbrake is
up. Unscrew the pneumatic valve
cap, take out the flexible filling
pipeA-fig. 5and screw down the
ring nut Bon the tyre valve;
fig. 5L0D0484m
Wear the protective gloves
provided with the quick
tyre repair kit.
WARNING
The cylinder contains eth-
ylene glycol. Contains la-
tex: may cause an allergic reaction.
Harmful if swallowed. Irritant for
the eye. May cause sensitization by
inhalation or contact. Avoid con-
tact with your eyes, skin and
clothes. In the event of contact,
wash immediately with plenty of
water. Do not induce vomiting if
swallowed. Rinse your mouth and
drink plenty of water. Call a doc-
tor immediately. Keep away from
children. The product must not be
used by asthmatics. Do not breath
in the vapours during insertion and
suction. Call a doctor immediately
if allergic reactions are noted.
Store the cylinder in the specific
compartment, away from sources
of heat.
WARNING
❒ensure that the switch D-fig. 6of
the compressor is in the 0(off) po-
sition, start the engine, fit the plug
A-fig. 7in the cigar lighter (or
12V socket) and switch on the
compressor by turning the switch
Dto the I(on) position. Inflate the
tyre to the pressure specified in the
“Inflation pressure” paragraph,
“Technical Specifications” chap-
ter.
fig. 6L0D0364m
fig. 7L0D0177m
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 140

141
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
For a more accurate reading,
check pressure gauge F-fig. 6with
the compressor off;
❒if after 5 minutes it is still impos-
sible to reach at least 1.5 bar, dis-
engage compressor from the valve
and current outlet and move the
car forward by approx. ten metres
in order to distribute the sealing
fluid inside the tyre evenly. Then
repeat the inflation operation;
❒If after this operation it is still im-
possible after 5 minutes to reach
at least 1.8 bar, do not start dri-
ving since the tyre is excessively
damaged and the quick tyre repair
kit cannot guarantee suitable seal-
ing, contact the Lancia Dealership;
fig. 8L0D0485m
Apply the adhesive label in
a position clearly visible
by the driver as a reminder that
the tyre has been treated with the
quick repair kit. Drive carefully,
particularly on bends. Do not ex-
ceed 80 km/h. Do not accelerate
and brake sharply.
WARNING
If the pressure has
dropped below 1.8 bar, do
not continue to drive: the automatic
Fix & Go quick repair kit cannot
work properly because the tyre is
excessively damaged. Contact a
Lancia Dealership.
WARNING
❒if the tyre has been inflated to the
pressure in paragraph “Inflation
pressure” in section “Technical
Specifications”, resume driving
immediately;
❒after driving for about 10 minutes,
stop and check again the tyre
pressure again; remember to pull
the handbrake;
❒if, on the other hand, a pressure
of at least 1.8 bar pressure is read,
restore the correct (with engine
running and handbrake on) and
restart;
❒drive with the utmost care to the
nearest Lancia Dealership.
FOR CHECKING AND
RESTORING PRESSURE ONLY
The compressor may also be used for
restoring pressure only. Release the
quick coupling and connect directly
to the tyre valve; in this way, the
cylinder will not be connected to the
compressor and no sealing fluid will
be injected.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 141

142
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
CYLINDER REPLACEMENT
PROCEDURE
To replace the cylinder proceed as fol-
lows:
❒disconnect connection A-fig. 9;
❒turn the cylinder to be replaced
anticlockwise and raise it;
❒fit the new cylinder and turn it
clockwise;
❒connect connection Ato the cylin-
der and fit the transparent tube B
into the space provided.
fig. 9L0D0368m
Remember to inform the
workshop that the tyre has
been treated with a quick repair
kit. Give the instruction booklet to
the tyre repair workshop person-
nel.
WARNINGREPLACING
A WHEEL
GENERAL INSTRUCTIONS
Wheel changing and correct use of the
jack and of the small spare wheel call
for some precautions as listed below.
IMPORTANT If the vehicle is
equipped with a “Fix&Go (quick tyre
repair kit)”, see the relative instruc-
tions shown in the previous chapter.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 142