REAR WIPER AND WASHER SYSTEMWW-83
< ON-VEHICLE REPAIR >
C
DE
F
G H
I
J
K
M A
B
WW
N
O P
REAR WIPER AND WASHER SYSTEM
Rear Wiper ArmINFOID:0000000001601879
REMOVAL AND INSTALLATION
Removal
1. Remove wiper arm cover, and remove rear wiper arm nut.
2. Remove the wiper arm.
3. Remove wiper blade.
Installation
1. Operate rear wiper motor one full cycle, then turn "off " (Auto Stop).
2. Clean up the pivot area as illustrated. This will reduce the possi- bility of wiper arm looseness.
3. Install wiper blade.
4. Install rear wiper arm so that the arm rests in the stopper and tighten rear wiper arm nut to specification.
5. Install wiper arm cover.
Rear Wiper MotorINFOID:0000000001601880
REMOVAL AND INSTALLATION
LKIA0608E
Rear wiper arm nut : 10.2 N·m (1.0 kg-m, 8 ft-lb)
SEL024J
Revision: March 2010 2008 QX56
WW-84
< ON-VEHICLE REPAIR >
REAR WIPER AND WASHER SYSTEM
Removal
1. Remove wiper arm. Refer to WW-83, "Rear Wiper Arm".
2. Remove pivot cap.
3. Remove back door lock assembly. Refer to DLK-237, "
Door Lock Assembly".
4. Disconnect rear wiper motor connector.
5. Remove rear wiper motor bolts, and remove rear wiper motor.
Installation
CAUTION:
• Do not drop the wiper motor or cause it to contact other parts.
1. Install rear wiper motor to the vehicle.
2. Connect rear wiper motor connector.
3. Install back door lock assembly. Refer to DLK-237, "
Door Lock Assembly".
4. Install pivot cap.
5. Install wiper arm. Refer to WW-83, "
Rear Wiper Arm".
Rear Washer Nozzle AdjustmentINFOID:0000000001601881
• This vehicle is equipped with a non-adjustable rear washer nozzle.
• If not satisfied with washer fluid spray coverage, c onfirm that the washer nozzle is installed correctly.
• If the washer nozzle is installed correctly, and the washer fluid spray coverage is not satisfactory, replace the
washer nozzle.
WKIA4567E
1. Wiper arm cover 2. Wiper arm and blade 3. Pivot cap
4. Rear wiper motor 5. Wiper arm stop6. Rear wiper arm nut
Revision: March 2010 2008 QX56