2008 HONDA CIVIC COUPE clock

Remove the bulb f rom the socket
by pushing the bulb in and turning
it counterclockwise until it unlocks.
Install the new bulb in the socket.
Turn it clockwise to lock it in place.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
To change the driver’s side bulb,
start the engine, turn the steering
wheel all the way to the right, and
turn of f the engine. To change the
passenger’s side bulb, turn the
steering wheel to the lef t.
Use a Phillips-head screwdriver to
remove the screw from the inner
f ender, and pull the inner f ender
cover back.
Reinstall the inner f ender cover.
Then reinstall the screw and
tighten it securely.
4. 5. 6. 7. 8.
3.
2.
1.
Lights
Replacing the Front Side Marker/
Parking/Turn Signal Light Bulb
Maint enance
249
——

y
y
(+yy

Open the trunk.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Remove the screw in the center of
the fastener on the side of the
trunk lining. Pull the lining back. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Put the f astener into the hole on
the side of the trunk lining.
Reinstall the screw.
Determine which of the f our bulbs
is burned out: stop/tail-light, back-
up light, side marker light, or turn
signal light.
Remove the socket by turning it
one-quarter turn counterclockwise.
1.
2. 3.4. 5.6. 7. 8.
Replacing Rear Bulbs
Lights
250
FASTENER
——

y

y
(+yy

If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle.
Open the trunk, then remove the
holding clips f rom the cover, and
remove the cover.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Reinstall the socket. Turn it
clockwise until it locks. Make sure
the new bulb is working.
Reinstall the cover, and tighten its
holding clips securely.
2.
1.
3. 4.5.
CONT INUED
On DX, Canadian DX-G, and LX models
Replacing a High-mount Brake
Light Bulb Cleaning the Seat Belts
Lights, Cleaning the Seat Belts
Maint enance
251
SOCKETLOOP
BULB
——

y
y
(+yy

If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle.
Open the trunk, then remove the
holding clips f rom the cover, and
remove the cover.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Reinstall the socket. Turn it
clockwise until it locks. Make sure
the new bulb is working.
Reinstall the cover, and tighten its
holding clips securely.
2.
1.
3. 4.5.
CONT INUED
On DX, Canadian DX-G, and LX models
Replacing a High-mount Brake
Light Bulb Cleaning the Seat Belts
Lights, Cleaning the Seat Belts
Maint enance
251
SOCKETLOOP
BULB
——

y
y
(+yy

Placethejackunderthejacking
point nearest the tire you need to
change. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
restinginthejacknotch.
Loosen each wheel nut 1/2 turn
with the wheel nut wrench.
Remove the center cap from the
wheel with the extension.
6.
7.8.Canadian DX-G model
Changing a Flat T ire
272
WHEEL NUT WRENCH JACKING POINTS
——

y


y
(+yy

Put the radiator cap back on
tightly. Run the engine, and check
the temperature gauge. If it goes
back to the red mark, the engine
needs repair (seeon page ).
If you do not see steam or spray,
leave the engine running and
watch the temperature gauge. If
the high heat is due to overloading,
the engine should start to cool
down almost immediately. If it
does, wait until the temperature
gauge comes down to the midpoint,
then continue driving.
If the temperature gauge stays at
the red mark, turn of f the engine.
Look f or any obvious coolant leaks,
such as a split radiator hose.
Everything is still extremely hot,
so use caution. If you f ind a leak, it
must be repaired bef ore you
continue driving (see
on page ).
If you don’t f ind an obvious leak,
check the coolant level in the
radiator reserve tank (see page ). Add coolant if the level is
below the MIN mark. Start the engine, and set the
temperature control dial to
maximum heat. Add coolant to the
radiator up to the base of the f iller
neck. If you do not have the
proper coolant mixture available,
you can add plain water.
Remember to have the cooling
system drained and ref illed with
the proper mixture as soon as you
can.
If the temperature stays normal,
check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back on
tightly.
Using gloves or a large heavy
cloth, turn the radiator cap
counterclockwise, without pushing
down, to the f irst stop. Af ter the
pressure releases, push down on
the cap, and turn it until it comes
off.
If there was no coolant in the
reserve tank, you may need to add
coolant to the radiator. Let the
engine cool down until the reading
reaches the middle of the
temperature gauge, or lower,
bef ore checking the radiator.
7. 8. 9.
3. 4. 5. 6. 290
191 290
10. 11.
Emergency
Towing
Emergency
Towing
If theEngineOverheats
280
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.
——

y
y
(+yy

If the driver’s power window f use is
removed, the AUTO function of the
driver’s window will be disabled. You
should reset the AUTO f eature, (see
page ).
When the audio system is disabled,
the clock setting in the audio system
will be canceled. You will need to
reset the clock (see page ).
If the radio f use is removed, the
audio system may disable itself . The
nexttimeyouturnontheradio,you
will see ‘‘ENTER CODE’’ in the
f requency display. Use the preset
buttons to enter the five-digit code
(see page ).
Your vehicle has spare fuses on the
back of the under-hood f use box
cover.
180
101
179
All models except DX
Fuses
T aking Care of t he Unexpect ed
287
FUSE PULLER
SPARE FUSES
——

y

y
(+yy

..............
CAUTION, Explanation of . ii
.........................................
CD Care . 174
..........................
CD Changer . 135, 157
.....
CD Changer Error Messages . 137
..............................
CD Player . 130, 150
.
CD Player Error Messages . 136, 158
..................................
Ceiling Light . 111
........................
Certif ication Label . 294
.................................
Chains, Tires . 263
....................
Changing a Flat Tire . 271
Changing Oil
........................................
How to . 236
......................................
When to . 225
...
Charging System Indicator . 57, 281
..............
Check Fuel Cap Message . 68
............
Checklist, Bef ore Driving . 203
.....................................
Child Saf ety . 32
..............................
Booster Seats . 47
...................................
Child Seats . 39
Important Saf ety
.........................
Reminders . 32, 35
..........................................
Inf ants . 37
............................
Large Children . 46
.........................................
LATCH . 41
......................
Risks with Airbags . 33
.............................
Small Children . 38 .........................................
Tethers . 45
...........................
Warning Labels . 51
.........
Where Should a Child Sit? . 33
Child Seats ......................................
Installing . 40
...........................
Lower Anchors . 41
......................................
Selecting . 39
................
Tether Anchor Points . 45
Cleaning ...................................
Seat Belts . 251
..............................................
Clock . 180
...................................
Clutch Fluid . 245
........................
CO in the Exhaust . 305
......................................
Coat Hook . 108
............
Cold Weather, Starting in . 204
......................
Compact Spare Tire . 270
.................
Console Compartment . 107
.................
Consumer Inf ormation . 312
.............
Controls, Instruments and . 53
Coolant
........................................
Adding . 238
....................................
Checking . 191
.........................
Proper Solution . 238
...................
Temperature Gauge . 68
Crankcase Emissions Control ........................................
System . 305 ................
Cruise Control Indicator . 62
............
Cruise Control Operation . 182
...................................
Cup Holders . 107
....
Customer Service Inf ormation . 312
................
DANGER, Explanation of . ii
...................................
Dashboard . 3, 54
................
Daytime Running Lights . 73
Daytime Running Lights
.......................................
Indicator . 63
.................................
Dead Battery . 277
............
Def ects, Reporting Saf ety . 314
................
Def ogger, Rear Window . 74
..............
Def rosting the Windows . 118
....................................
Dimensions . 296
...............
Dimming the Headlights . 72
Dipstick
..........
Automatic Transmission . 242
..................................
Engine Oil . 189
..........................
Directional Signals . 72
........
Disc Brake Wear Indicators . 213
.......................................
Disc Care . 174
............................
Disc Player . 130, 150
..................
Display Change Button . 66
Index
D
II
——

y
y
(+yy