2008 GEELY MK instrument cluster

Chapter 3 Front Seat BeltSeat Belt Reminder SystemI. Component View
II. Fault diagnosis
Possible causes
1. GAUGE fuse;
2. Instrument cluster;
3. Left front buckle assembly
4. Wiring harnessSymptom
Driver's seat belt lamp is not onIII. Alarm system inspection
1. To inspect the left front buckle assembly
Check the conductivity of left front buckle assemblyTerminal Number Seat Belt Required
1<=>2Insert OFF
1<=>2Release ON If you find that the result of the inspection is not the same as
required, you can replace the left front buckle assembly.DriverÕs seat belt reminder lamp
Left front buckleInterior & Exterior Trim and Accessory
-Front Seat Belt6-5

Chapter 5 Dashboard, Middle Console and Instrument PanelI.Component View
II.Component ViewInstrument panel upper housing assy
Upper housing
CD player housingInstrument cluster assyInterior & Exterior Trim and Accessory -Dashboard, Middle Console and Instrument Panel6-11

III. Removal and installation of instrument panel1. Disconnect the negative terminal of storage battery
2. Remove the instrument panel trim panel sub-assembly
a. Loosen 7 clips;
b. Disconnect the connector and unfasten the trim panel.
3. Remove the instrument cluster trim panel sub-assembly
a. Unfix the clamp;
b. Loosen 10 clips and unfasten the trim panel.Steering column upper cover
Steering column lower cover
Auxiliary fasia
console bodyCupholder Instrument cluster trim panel Glove compartment assy Instrument panel
lower housing assyInterior & Exterior Trim and Accessory -Dashboard, Middle Console and Instrument Panel6-12Left Combination switchRight
Combination
switch
7 clips
10 Clips

Interior & Exterior Trim and Accessory -Dashboard, Middle Console and Instrument Panel6-134. Remove the instrument cluster assembly
a. Unfasten 4 screws;
b. Disconnect the connector and unfasten the instrument cluster
assembly.
5. Remove the glove compartment assembly
a. Detach the glove compartment assembly by pressing the top
releaser;
b. Pull the glove compartment upward and then take it out.
6. Remove the right front pillar trim panel
Unfix 2 clamps by use of a screwdriver and then unfasten the right
front pillar trim panel.
Tips:
Protect the trim panel from damage by wrapping the sharp end of
screwdriver up with adhesive tape before operation.
7. Remove the left front pillar trim panel
8. Disconnect the right airbag connector
9. Remove the instrument panel sub-assembly
a. Unfix 6 screws , and 2 bolts ;
b. Unfix the screw
c. Loosen 8 clips;
d. Disconnect the connector;2 clips
Clip
8 clips
Clasp