2008 FIAT ULYSSE instrument panel

2
MUST BE READ!
REFUELLING
JTD engines:only refuel with diesel fuel conforming to the European specification EN590.
The use of other products or mixtures may irreparably damage the engine with invalidation of the warranty
due to the damage caused.
ENGINE START-UP
JTD engines:make sure the handbrake is pulled up; put the gear lever into neutral; press the clutch pedal
down to the floor without touching the accelerator; then turn the ignition key to Mand wait for the instru-
ment panel warning light mto go out, then turn the ignition key to Dand release it as soon as the engine
starts.
JTD enegines with automatic gearbox:make sure the handbrake is pulled up and the gear lever is in P
or N; then turn the ignition key to Mand wait for the instrument panel warning light mto go out, then turn
the key to D, without touching the accelerator and release it as soon as the engine starts.
PARKING OVER INFLAMMABLE MATERIAL
When functioning normally, the catalytic converter reaches high temperatures. For this reason do not park
the vehicle over inflammable material, grass, dry leaves, pine needles, etc.: fire hazard.
K


GETTING TO KNOW YOUR CAR
10
1.Side vents
2.Left-hand stalk: headlight control
3.Horn
4.Instrument panel: odometer display and warning lights
5.Right-hand stalk, windscreen washer, rear window
washer and trip computer
6.Gear lever
7.Central vents
8.Revolution counter
9.Speedometer
10.Fuel gauge with low fuel warning light and engine
coolant temperature gauge with warning light showing
when the temperature is too high
11.Sound system/Infotelematic Connect system display
(where fitted)
12.Sound system/Infotelematic Connect system (where
fitted)
13.Passenger air bag14.Glove compartment
15.Climate system automatic controls
16.Hazard lights
17.Cigar lighter
18.Glove compartment/Infotelematic Connect system re-
mote controls (where fitted)
19.Console
20.Ashtray and glove compartment
21.Ignition switch
22.Sound system controls on steering wheel
23.Document compartment
24.Driver air bag
25.Cruise control control lever
26.Headlight beam adjuster (Xeno light versions excluded)
27.ASR system on/off.

GroupWeight groupsSeats Third row, 3-seat bench
GETTING TO KNOW YOUR CAR
46
PASSENGER SEAT COMPLIANCE WITH REGULATIONS ON CHILD’S SEAT USE
The car complies with the new European Standard 2000/3/CE which enforces the use of restraint systems classified ac-
cording to the following tables:
1)Child restraint systems should be
installed on the rear seat as this is the
most protected area in the vehicle in
the event of a crash.Children must never be
seated in the front pas-
senger seat in cars with
passenger’s front airbag.2)When deactivating the passenger
front air bag, always check that the sys-
tem has actually been deactivated by
looking at the specific warning light
“
that shall be on with fixed light on the
instrument panel. To sum up the safety precautions to follow when transporting children:
Group 0, 0+
Group 1
Group 2
Group 3Front
passenger
U
U
U
USecond row,
rear side
passenger
U
L (Type Isofix)
U
L (Type Isofix)
U
USecond row,
central front
passenger
U
U
U
UThird row,
rear side
passenger
U
U
U
U
Side seats
U
U
U
UCentral seats
–
–
U
U up to 13 kg
9-18 kg
15-25 kg
22-36 kg
Legend:
U= suitable for “Universal” restraint systems according to the European Standard ECE-R44 for the above mentioned
“Groups”.
L= suitable for certain child’s restraint systems available at Lineaccessori for the specified group.

GETTING TO KNOW YOUR CAR
50
INSTRUMENTSA -Odometer display: speedometer,
kilometre counter, maintenance indi-
cator, engine oil level gauge (where fit-
ted) and, for versions with automatic
gear, engaged gear indicator and sym-
bol for presence of ice on the road, if
any.
B -Warning lights
C -Trip kilometre counter reset
button
D -Button for instrument panel
brightness adjustment
fig. 74F0B0412b
fig. 75F0B0413b

GETTING TO KNOW YOUR CAR
79
STEERING COLUMN
STALKS
LEFT-HAND STALK
The left-hand stalk controls most of
the outside lights. If you leave the lights
on when you take the key out of the
ignition an alarm will sound.
Outside lighting is possible with the
ignition key at M.
Side lights fig. 91
These lights turn on when you turn
the knurled knob Afrom åto
6.Dipped-beam headlights fig. 92
To switch on: turn the knurled knob
Afrom
6to 2/1.
Instrument panel indicator light 2
comes on.Follow me home (where fitted)
fig. 93
This function works for a set time
(45 seconds) and illuminates the area
in front of the vehicle. It is activated by
turning the ignition key to Sor, if the
ignition key has been removed, by
pushing the stalk towards the dash-
board. This function can be activated
by operating the stalk within 2 minutes
after the engine has been turned off.
If the vehicle is fitted with the side-
light and dipped-beam headlight auto-
matic switching on device, the “follow
me home” function is automatically ac-
tivated when the doors are opened.
fig. 91
F0B0416b
fig. 92
F0B0417b
fig. 93
F0B0418b

GETTING TO KNOW YOUR CAR
80
Side light and dipped-beam
headlight automatic
switching on (where fitted)
This device is fitted with an infrared
sensor installed on the windscreen and
is able to detect the outside light
brightness variations.
To activate /deactivate automatic
light turning on, use the display set-
up menu (see paragraph “Info display”
in this section).Main beam headlights fig. 95
To switch on: push the knurled knob
Ainto position 2/1and pull it up
towards the steering wheel.
Instrument panel indicator light 1
comes on.
To turn off: pull the stalk towards the
steering wheel again.
fig. 94
F0B0419b
fig. 95
F0B0420b
The light sensor is not
able do detect fog, there-
fore in this case it is nec-
essary to turn the lights on man-
ually.
IMPORTANTWhen the device is
on and the windscreen wiper is work-
ing, lights are automatically turned on.
When the lights come on automati-
cally it is also possible to turn on front
and rear foglights; when the lights are
turned off automatically, the latter
ones will be turned off as well.
IMPORTANTWhen the sensor is
on it is possible to have only the lights
flashing, therefore full-beam headlights
will have to be turned on manually, if
needed.

GETTING TO KNOW YOUR CAR
81
Flashing the headlights fig. 96
Pull the stalk towards the steering
wheel (temporary position) to flash
the lights, regardless of the knurled
knob Aposition.Switching on the front
(where fitted) and rear fog
lights fig. 97-98
To switch on fig. 97:
– turn knurled knob Bin the arrow
direction:
– first impulse (temporary position):
front fog lights on. The instrument
panel indicator light
5comes on;
– second impulse (temporary posi-
tion): rear fog lights on
4.
To switch off fig. 98:
– turn knurled knob Bin the arrow
direction (temporary position).Front and rear fog lights are turned
off automatically when the lights are
switched off or when sidelights
6are
restored; if rear fog lights should be
turned on again, repeat the above
mentioned operation.
The lights on before the engine turn-
ing off will automatically come back on
when the engine is started again.
IMPORTANTThe rear foglight
may annoy the drivers following you.
For this reason, do not use the light
when the visibility is good.
fig. 96
F0B0421b
fig. 97
F0B0422b
fig. 98
F0B0423b

GETTING TO KNOW YOUR CAR
82
Direction indicators fig. 99
Move the stalk as follows:
upwards (position 1): for the right
indicator;
downwards (position 2): for the
left indicator.
Instrument panel indicator light Eor
Rflashes.
The direction indicators turn off au-
tomatically when the vehicle straight-
ens up.
If you want to use the indicator
briefly (e.g. change of lane) move the
stalk up or down without it clicking in-
to position.
When you let it go, it will return to
the neutral position again.RIGHT-HAND STALK
Windscreen wiper fig. 100
This feature can only work with the
ignition key at M.
0- Windscreen wiper off.
1- Flick wipe.
1- Slow continuous wipe.
2- Fast continuous wipe.
- Temporary wipe: on releasing
the stalk it returns to position 0and
the windscreen wiper turns off auto-
matically.To make maintenance easier, wash
the windscreen or replace the wind-
screen washer blades, for example,
when the ignition key is at Sor re-
moved and turn the stalk downwards
(impulse) in 60 seconds; the wind-
screen wipers will stop in a vertical po-
sition, thus making it possible to be lift-
ed for replacing the blades or washing
the windscreen.
IMPORTANTDo not lift the wind-
screen wipers if they are not in verti-
cal position as above mentioned, oth-
erwise the bodywork might get dam-
aged.
fig. 99
F0B0424b
fig. 100
F0B0268b