2008 DODGE VIPER heater

Air Conditioning and Heating SystemBlower Control
Use this control to regulate the
amount of air forced through the sys-
tem in any mode you select. Turn the
control clockwise to increase fan
speed. Turn the control to theOÐOff
position to shut off the fan and to
prevent any outside air from entering
the vehicle. This also turns off the A/C
compressor.
Temperature Control
Use this control to regulate the tem-
perature of the air inside the passen-
ger compartment. The blue area of the
control indicates cooler temperatures
while the red area indicates warmer
temperatures.
Air Conditioning And Heater Controls
UNDERSTANDING YOUR INSTRUMENT PANEL 123
4

²In city traffic ÐWhile moving, shift into the highest
gear possible to reduce engine RPM.
NOTE:There are steps that you can take to slow down
an impending overheat condition. If your air conditioner
is on, turn it off. The air conditioning system adds heat to
the cooling system and turning off the A/C removes this
heat. You can also turn the Temperature control to
maximum heat, the Mode control to floor, and the fan
control to High. This allows the heater core to act as a
supplement to the radiator and aids in removing heat
from the cooling system.WARNING!
A hot cooling system is dangerous. You or others could
be badly burned by steam or boiling coolant. If your
temperature gauge pointer is in the red area, turn off
the engine immediately. You may want to call a service
center for service. If you decide to look under the hood
yourself, see Section 7 of this manual. Follow the
warnings under the Radiator Cap paragraph.
TIREFIT KIT
Small punctures in the tire tread can be sealed with
TIREFIT. Foreign objects (e.g., screws or nails) should not
be removed from the tire. TIREFIT can be used in outside
temperatures down to approximately -4ÉF (-20ÉC).
WHAT TO DO IN EMERGENCIES 177
6

JUMP-STARTING PROCEDURES
WARNING!
²Take care to avoid the radiator cooling fans whenever the hood
is raised. They can start anytime the ignition switch is on. You
can be hurt by the fans.
²Take care to avoid the accessory drive whenever the hood is
raised. You can be hurt by the moving components.
²Do not attempt to push or tow your vehicle to get it started.
Unburned fuel could enter the catalytic converter and once the
engine has started, ignite and damage the converter and
vehicle. If the vehicle has a discharged battery, booster cables
may be used to obtain a start from a booster battery or the
battery in another vehicle. This type of start can be dangerous
if done improperly, so follow this procedure carefully.
²Battery fluid is a corrosive acid solution; do not allow battery
fluid to contact eyes, skin, or clothing. Don't lean over battery
when attaching clamps or allow the clamps to touch each
other. If acid splashes in eyes or on skin, flush contaminated
area immediately with large quantities of water.
²A battery generates hydrogen gas, which is flammable and
explosive. Keep flame or spark away from the vent holes.
²Do not use a booster battery or any other booster source with
an output that exceeds 12 volts.
NOTE:The battery is located underneath an access
panel inside the rear compartment on the left side of the
vehicle. A remote battery terminal is located in the engine
compartment for jump-starting.
1. Wear eye protection and remove any metal jewelry
such as watchbands or bracelets that might make an
inadvertent electrical contact.
2. When boost is provided by a battery in another
vehicle, park that vehicle within booster cable reach, but
without allowing the vehicles touch one another.
3. Set the parking brake, place the transmission in neu-
tral, and turn the ignition OFF on both vehicles.
4. Turn off the heater, radio, and all unnecessary electri-
cal loads.
186 WHAT TO DO IN EMERGENCIES

In the event that you do take this vehicle to a commercial
car wash, move the Heater/Air Conditioning blower
control to the lowest setting. This will prevent the possi-
bility of water entering the system.
CAUTION!
The tires on this vehicle are wider than the guide
tracks on most washes and the low ground clearance
of this vehicle may not be compatible with some car
wash equipment. You could damage your vehicle.
Paint and Trim
Your vehicle is exposed to the corrosive effects of chemi-
cal fallout, salt spray, and road film. To protect not only
the paint and trim, but also exposed mountings and
fixtures, it is important to wash your vehicle often and
thoroughly.After washing, allow all surfaces to drain and dry before
parking the vehicle in a closed garage. Prompt washing
may not thoroughly remove these deposits. Additional
cleaners may be required. When using chemical cleaners
formulated for this purpose, be certain they are safe for
use on urethane painted surfaces.
Use soap and water on dull black window trim. Polish or
cleaners may leave a white residue. If desired, you may
polish your vehicle immediately by using MopartAuto-
mobile Polish or equivalent.
Damage to the Body Finish
Any stone chips, fractures or deep scratches in the finish
should be promptly repaired.
Minor damage can be repaired by using touch-up mate-
rials available at your dealer. More extensive damage
should be corrected in your dealer's paint facility.
MAINTAINING YOUR VEHICLE 231
7

NOTE:To help prevent the battery from discharging
during shorter periods of inactivity, perform the follow-
ing:
1. Make sure that the trunk/liftgate, hood, doors, win-
dows, and convertible top are completely closed.
2. Make sure that remote transmitter is operating and
that the battery is good.
3. Make sure that the hood, trunk/liftgate, and door
switches are in adjustment. Perform the quick system
check, which follows:
Use the remote transmitter to set the alarm. If the alarm
SET light comes on and flashes, the system is operating
properly. If not, there is a problem with a switch or the
system. See your dealer for service.
²Cover the vehicle whenever possible to prevent acci-
dental damage to the finish.
REPLACEMENT BULBS
LIGHT BULBS Ð Interior Bulb Number
Message Center Indicators.................. 103
Cluster................................ 103
Gauge Pack............................ 103
Heater Control........................... 37
Interior Light..........................212±2
Courtesy Foot Well Lights.................. 194
Cargo Light (Coupe Liftgate)................ 168
240 MAINTAINING YOUR VEHICLE

HEADLIGHT AIMING
The headlights on your new vehicle were aimed at the
factory under a no load setting. A great increase in weight
will change the aiming of the headlights. Therefore, it
may be necessary to readjust the headlights if you
typically carry an excessive amount of weight in the rear
compartment or generally suspect misalignment. In ei-
ther case, see your authorized dealer if the headlights
require adjustment.
FLUIDS AND CAPACITIES
U.S. Metric
Fuel (approximate)
8.4 Liter Engine 16 gal-
lons60.6 li-
ters
Engine Oil-With Filter
8.4 Liter Engine (SAE 0W-40) 10 qts. 9.5 Li-
ters
Cooling System *
8.4 Liter Engine* (Mopart
Antifreeze/Coolant 5 Year/
102,000 Mile Formula) or
equivalent.16 qts. 15 Liters
* Includes heater and coolant recovery bottle filled to
MAX level.
MAINTAINING YOUR VEHICLE 251
7

Hazard
Driving Through Flowing, Rising, or
Shallow Standing Water................. 140
Hazard Warning Flasher.................99,176
Headlights..........................81,243
Aiming............................. 251
High Beam........................... 83
High Beam/Low Beam Select Switch......... 83
Lights On Reminder..................... 82
Passing.............................. 84
Switch............................... 81
Time Delay........................... 81
Heater.............................122,123
High Beam Indicator...................... 97
High Beam/Low Beam Select (Dimmer) Switch . . . 83
Hood Latch Maintenance.................. 215
Hood Release........................... 79
Hoses.............................224,225
Hydraulic Clutch Fluid.................... 228Ignition............................... 12
Key ................................. 12
Timing.............................. 205
Wiring System (Spark Plug Wires).......... 205
Ignition Key Removal..................... 12
Illuminated Entry........................ 16
Infant Restraint........................50,51
Inflation Pressure Tires.................... 101
Inside Rearview Mirror.................... 75
Instrument Cluster........................ 96
Instrument Panel and Controls............... 95
Instrument Panel Lens Cleaning............. 232
Interior Lighting.......................81,84
Interior Lights.........................84,85
Intermittent Wipers (Delay Wipers)............ 87
Introduction............................. 4
Jump Starting.......................... 186
292 INDEX