2008 DODGE SPRINTER belt

61 Safety
Occupant safety
2
Warning symbol for rearward-facing child
seat
ISOFIX child seat securing system/
Child seat anchors - LATCH typeISOFIX is a standardized securing sys-
tem on the rear seats for special LATCH
(Lower
Anchors and
Tethers for
Ch
il-
dren) child restraint systems with
matching mounting fittings.
The LATCH type anchors for child re-
straint systems are installed between
the seat cushion and the backrest:
\4
on the outside left and right on nar-
row rear bench seats with 3 seats
\4
on the outside left on rear bench
seats with 2 seats
N00.00-2620-31
iNon-LATCH type child seats may also
be used and can installed using the
vehicle’s seat belt system. Install
child seat according to manufactur-
er’s instructions.
nf_BA.book Page 61 Friday, January 25, 2008 3:53 PM

62 SafetyOccupant safety
2
Warning
G
A LATCH type child restraint system that
has been secured using the ISOFIX child
seat securing system is unable to provide
adequate protection for children who
weigh more than 48 lbs (22 kg). For this
reason, only secure children weighing
less than 48 lbs (22 kg) in a LATCH type
child restraint system secured using the
ISOFIX child seat securing system. If the
child weighs more than 48 lbs (22 kg),
you should secure the LATCH type child
restraint system with a lap-shoulder belt.
Warning
G
If the child restraint system has not been
installed correctly on a suitable vehicle
seat, the child cannot be restrained in the
event of an accident or sudden braking
and could be seriously or fatally injured.
You must therefore observe the installa-
tion instructions issued by the child re-
straint system manufacturer when
installing a child restraint system.
Continued
Warning (Continued)
G
On the rear bench seat, only use LATCH
type child restraint systems with ISOFIX
child seat mountings that have been rec-
ommended by the manufacturer.An incorrectly installed child restraint sys-
tem could come loose and the child or
other vehicle occupants could be fatally
injured. You must therefore make sure
that the child restraint system is engaged
in the securing rings on the left and right-
hand sides after it has been installed.
nf_BA.book Page 62 Friday, January 25, 2008 3:53 PM

63 Safety
Occupant safety
2
1Securing rings - LATCH type anchors
Warning
G
If the child restraint system or its securing
system, for example the ISOFIX child seat
securing system, are damaged or have
been subjected to a load in an accident,
the child secured in it could suffer severe
or fatal injuries in the event of an acci-
dent, heavy braking or a sudden change
of direction.
Continued
Warning (Continued)
G
For this reason, have restraint systems
and their mountings checked immediately
and replaced if necessary at a qualified
specialist workshop which has the neces-
sary specialist knowledge and tools to
carry out the work required if they are
damaged or have been subjected to a
load in an accident.The manufacturer recommends that you
use an authorized Sprinter Dealer for this
purpose. In particular, work relevant to
safety or on safety-related systems must
be carried out at a qualified specialist
workshop.
!
CAUTION
Take care not to trap the seat belt on
the middle seat when you install the
child restraint system.
nf_BA.book Page 63 Friday, January 25, 2008 3:53 PM

65 Safety
Occupant safety
2
2 TopTether anchorage
3TopTether hook
4TopTether belt of LATCH type child re-
straint system
\1
Slide head restraint
1
upward.
\1
Guide TopTether belt
4
under head
restraint
1
from the front and be-
tween the two head restraint bars.
\1
Hook TopTether hook
3
into
TopTether anchorage
2
on the feet
of the bench seat.
\1
If necessary, slide head restraint
1

back down a little (
\2
page 121).
Make sure that TopTether belt
4

can move freely.
\1
Install the
LATCH type
child restraint
system with TopTether. The manu-
facturer’s installation instructions
must be observed.
nf_BA.book Page 65 Friday, January 25, 2008 3:53 PM

112 Controls in detailSeats
3
\3 SeatsDriver’s and passenger’s seatsWarning
G
Only adjust the seats when the vehicle is
stationary and the handbrake is applied.
You could otherwise lose control of the
vehicle as a result of the seat moving and
cause an accident.
Warning
G
Make sure that nobody can become
trapped as the seat is adjusted. Never
place your hands under the seat or near to
moving parts.Your seat must be adjusted in such a way
that you can wear the seat belt correctly
(\2page 39). Observe the following points:\4Position the backrest as vertically as
possible and sit upright.
Continued
Warning (Continued)
G
\4Avoid seat positions that do not allow
the seat belt to be routed correctly.
The shoulder section of the seat belt
must be routed across the middle of
your shoulder and must fit closely
across your chest. The lap section of
the belt must be routed as low as pos-
sible across your pelvic area, i.e.
across your hip joints. Never drive
with the backrest tilted too far back.\4
Your arms should be slightly bent when
you are holding the steering wheel.
Continued
nf_BA.book Page 112 Friday, January 25, 2008 3:53 PM

113 Controls in detailSeats
3
Warning (Continued)
G
\4The distance from the pedals should
be such that you can depress them
fully.\4Adjust the head restraint in such a
way that the upper edge of the head
restraint is level with your head.\4Make sure that you hear the seat en-
gage. Otherwise, the seat is not cor-
rectly locked in place.Injuries may be caused if these notes are
not observed.
Warning
G
Avoid seat positions in which you cannot
wear your seat belt correctly. They are a
safety hazard and must therefore be
avoided.
nf_BA.book Page 113 Friday, January 25, 2008 3:53 PM

124 Controls in detailSeats
3
\1
Remove key
1
from partition sliding
door.
\1
Fold seat cushion
2
down or up.
The seat cushion is held in the rele-
vant position.
Warning
G
When folding down the seat cushion, make
sure that nobody can become trapped.The Warning to the co-driver is increased
in the event of sudden steering move-
ments or an accident if there is a key in-
serted in the partition sliding door lock.Remove the key from the partition sliding
door before using the folding seat.
Rear bench seatWarning
G
All release levers on the legs of the rear
bench seat must be parallel to the vehicle
floor. A rear bench seat with 2 seats may
only be installed left-sided.You can obtain information from any au-
thorized Sprinter Dealer.
Continued
Warning (Continued)
G
The integrated seat belt can only offer the
degree of protection for which it is de-
signed if you install the specified rear
bench seats correctly. Therefore, you
must have the rear bench seat with four
seats installed only by a qualified special-
ist workshop, e.g., an authorized Sprinter
Dealer.Keep the seat bench mounting cups in the
vehicle floor free from dirt and foreign ob-
jects. This is the only way to guarantee
that the locking mechanisms will engage
securely.
Continued
nf_BA.book Page 124 Friday, January 25, 2008 3:53 PM

184 Controls in detailDriving and parking
3
You will find information on:\4
regular checks (
\2
page 312)
\4
driving in winter (
\2
page 406)
\4
driving when towing a trailer
(\2
page 303)
\4
and other driving tips
in the “Operation” section
(
\2
page 301).
\1
Before starting the engine, make
sure that all vehicle occupants are
wearing their seat belt correctly
(\2
page 39) and the handbrake
(
\2
page 191) is applied.
Starting the engineWarning
G
Never run the engine in an enclosed
space. The exhaust fumes contain poi-
sonous carbon monoxide. Breathing in
exhaust fumes constitutes a health haz-
ard and can lead to loss of consciousness
and death.
Warning
G
A seat belt that is worn incorrectly or not
at all, or that is not correctly engaged in
the seat belt buckle, cannot perform its
intended protective function. In certain
circumstances, you could then be seri-
ously or even fatally injured. Make sure,
therefore, that all occupants – in particu-
lar, expectant mothers – wear their seat
belt correctly at all times.
nf_BA.book Page 184 Friday, January 25, 2008 3:53 PM