279 Controls in detail
Transporting
3
The load's overall center of gravity
should be as low and central as possible,
between the axles near the rear axle. For crewbus models:
\1
Always transport loads in the load
compartment.
\1
Always place loads flush against the
seat backrests of the rear bench
seat.
\1
Slide larger and heavier loads as far
forward as possible when looking in
the direction of travel. Stack items
against each other behind the rear
bench seat.
\1
Always secure loads with suitable
transport aids or lashing materials.
Load distribution!
CAUTION
Excessive loads on individual points
of the load compartment floor or load
surface have a negative effect on
handling characteristics and could
damage the floor covering.
iObserve the following notes:\4
Do not stack loads higher than
the upper edge of the backrests.
\4
Transport loads behind seats that
are not occupied.
\4
If the rear bench seat is not occu-
pied, insert the seat belts in a
crosswise pattern into the oppo-
site belt buckles.
nf_BA.book Page 279 Friday, January 25, 2008 3:53 PM
