2008 DODGE AVENGER light

NOTE: For lighted switches, see your authorized dealer
for replacement instructions.
LIGHTS BULBS Ð Outside Bulb No.
Low Beam Headlight ..................... 9006
High Beam Headlight ..................... 9005
Front Park/Turn Signal/Side Marker Light . . . 3157AK
Front Fog Light ..................... 9145//H10
Center High Mounted Stop Light
(CHMSL) ........................ W16W (921)
Rear Tail/Stop ......................... 3157K
Decklid Tail Light ....................... T3.25
Rear Turn Signal ...................... 3157AK
Backup Light .......................... 3157K
License Light ........................... 168 BULB REPLACEMENT
Headlight Bulb Replacement
1. Raise the hood and locate the connector behind the
headlamp.
Headlight412 MAINTAINING YOUR VEHICLE

2. Reach into engine compartment and from behind the
lamp assembly and grasp the connector.
3. Rotate bulb and connector 1
¤ 4
turn and pull outward
from assembly. CAUTION!Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life.Headlight Housing - Rear View Twisting Bulb From Socket MAINTAINING YOUR VEHICLE 413
7

Fog Lights
1. Access to the lights through the lower fascia cutout is
limited.
2. We recommend you access the lights by turning the
steering wheel to allow access and remove the inner
fender shield. 3. Rotate bulb and connector 1
¤ 4
turn counterclockwise.
4. Pull bulb off of connector and replace with a new one.
CAUTION!Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
Fog Light and Connector MAINTAINING YOUR VEHICLE 415
7

Taillights, Rear Turn Signals And Backup Lights
Ð Replacement
The turn signal, brake and taillights and backup lights
are located in the rear corner body panel housing. Changing the Rear Corner Taillight Bulbs
1. Open the trunk and gently pull back the trunk liner
behind the taillight.
Rear Tail Light Pull Back Trunk Liner416 MAINTAINING YOUR VEHICLE

2. Remove the two plastic wing nuts from the taillight
housing.
3. Grasp the taillight and pull firmly outward pushing
gently on the studs from inside to disengage the light
housing. 4. Twist and remove socket from light.
5. Remove bulb from socket and replace.
Location Plastic Wing Nuts
Changing Tail Light Bulb MAINTAINING YOUR VEHICLE 417
7

License Plate Light Ð Rear
1. Remove two retaining screws holding the light lens in
place.
2. Gently pry the light assembly loose. 3. Pull bulb from socket, replace and reattach the light
assembly with the two retaining screws.
Center High-Mounted Stop Light
1. Open the trunk lid to find the centrally located high-
mounted stop light.
Location and Removal of Rear License Light Assembly
High-mounted Stop Light Bulb Replacement418 MAINTAINING YOUR VEHICLE

2. Twist and remove socket from the back of the light
housing. 3. Replace the bulb and reinstall the socket into the
housing by locking it in place with a twist.
Changing High Mount Stop Light Bulb MAINTAINING YOUR VEHICLE 419
7

NOTE: Six-speed AutoStick t Transaxle, if equipped, is
sealed therefore, checking the fluid level can only be
done by a certified dealership service center.
² Check all lights and other electrical items for correct
operation. At Each Oil Change
² Change the engine oil filter.
² Inspect the brake hoses and lines.
CAUTION!Failure to perform the required maintenance items
may result in damage to the vehicle.428 MAINTENANCE SCHEDULES
8 M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S